2013 Citroen C3 PICASSO lock

1
Monitoring
25
Passenger's airbag system fixed. The control switch, located at the
passenger's end of the dashboard, is in
the "ON"position.
The passenger's front airbag is activated.
In this case, do not install a rear-facing child seat.
Turn the control switch to the "OFF" position to
deactivate the front passenger's airbag.
In this case you can install a rear-facing child seat.
Warning lampis onCauseAction / Observations
Electric child
lock

temporarily. The electric child lock is activated. Displayed for a few seconds after activating the
function and every time the ignition is switched on.
For more information, refer to the "Child safety"section.

Monitoring
28
Warning lampis onCauseAction / Observations
Anti-lockBraking System(ABS)
fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a CITROËN dealer or a qualified workshop without
delay.
Dynamic stability control(ESP/ASR)
flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.
fixed. Unless it has been deactivated(button pressed and its indicator lamp
on) the ESP/ASR system has a fault. Have it checked b
y a CITROËN dealer or a qualified
workshop.
Engine autodiagnosis system
flashing.The engine management system hasa fault. Risk of destruction of the catalytic conver ter.
Have it checked by a CITROËN dealer or a qualified
workshop.
fix
ed. The emission control system has a
f
ault.
The warning lamp should go off when the engine is started.
If it does not
go off, contact a CITROËN dealer or qualified
workshop without delay.
Brakingfixed, associated with
the STOP warning
lamp. The braking system fluid level is too
low.You must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.

+ fixed, associated with
the
STOP and ABS
warning lamp.Th
e electronic brake force distribution(EBFD) system has a fault.You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.

Monitoring
32
Service indicator zero reset
After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is asfollows: )
switch off the ignition,)
press and hold the trip distance recorder
zero reset button,
) switch on the ignition; the distance recorder
display begins a countdown, ) when the display indicates "=0", release
the button; the spanner disappears.
Service overdue
A few seconds after the ignition is switched
on, the distance recorder resumes its normaloperation. The spanner remains on.

Retrieving the serviceinformation

You can access the ser vice information at anytime. )Press the trip distance recorder zero reset button.
The ser vice information is displayed for afew seconds, then disappears.
The distance remaining may be weighted by the time factor, dependingon the type of driving.
Therefore, the spanner may also comeon if you have exceeded the time interval since the last service, indicatedin the ser vicing and warranty booklet.

Following this operation, if you wish todisconnect the battery, lock the vehicleand wait at least five minutes for thezero reset to be taken into account. For a
few seconds after the ignition is switchedon,the spanner flashes to indicate that the
ser vice must be carried out as soon as possible. Example:the ser vice is overdue by 180 miles(300 km).
For a few seconds after the ignition is switched
on, the display indicates:

Monitoring
34
Total distance recorder Lighting dimmer
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked. S
ystem which measures a distance travelled
during a day or other period since it was reset
to zero by the driver.
Activation
When the lighting is on:)press the button to change the brightness
of the instruments and controls,)when the level of brightness required isreached, release the button.

Deactivation

When the lighting is off, or in day mode on
vehicles fitted with daytime running lamps,
pressing the button does not have any effect.



Tr ip distance recorder
)
With the ignition on, press the button until
zeros appear.



To conform to legislation in the country you are crossing, change the units of distance (miles or km) via theconfiguration menu.
S
ystem which measures the total distance
travelled by the vehicle during its life. System for manual adjustment of the brightness of the instruments and controls in relation to theexterior brightness.

Comfort
58








Scented air freshener System permitting the diffusion of a fragrance in the passenger compar tment in accordance with your requirements, by means of the adjustment dial and the various fragrance car tridges available.

Fitting the cartridge
)Remove the cartridge from the sealing case. )Install the car tridge (flower at top right).
)Press the dial and turn it a quarter of a turnclockwise.

Thi
s dial is located on the dashboard or in the
upper glove box.
It allows you to adjust the intensity of diffusion
of the fragrance.)Turn the dial to the right to permit diffusion
of the fragrance.)Turn the dial to the left to stop diffusion of
the
fragrance.

Fragrance cartridge


Removing the cartridge
)Press the dial and turn it a quarter of a turnanti-clockwise. )Remove the cartridge.)Refit its sealing case.

As a safety precaution, do not carry out any action on the car tridge whiledriving. Do not dismantle the car tridges.Do not attempt to refill the fragrancediffuser or the cartridges.
Avoid all contact with the skin and eyes.Keep out of reach of children and animals.
Do not discard the original cartridge as this ser ves as a plug when no fragrance car tridge is in use. In order to preser ve the ser vice life of thecartridge, turn the dial to the left when you no longer wish to diffuse the fragrance in the passenger compartment.

Leave the central vents open.
The intensity of diffusion of the fragrance may depend on the ventilationor air conditioning settings.
Adjustment dial
This car tridge can be removed easily.
You can change it at any time and store it in the
sealed case which keeps it closed once it has been opened.
You can obtain different fragrance car tridges
from a CITROËN dealer or a qualified
workshop.

3
Comfort
61
Table position of the frontpassenger seat
Placing this seat in the table position, with the rear benchseat also in the table position, allows you to transpor t long objects. ) Push the control upwards and guide the seat back forwards to fold it onto the seat cushion.)
To put it back in place, lift up the seat back
and
guide it rear wards until it locks in. With the en
gine running, the front seats can be heated separately.)Use the adjustment dial, placed on the side
of each front seat, to switch on and select
the level of heating required:
0: Off. 1: Low. 2: Medium.3

: High.

Heated seats control

Do not forget to fold the "aircraft" type table fixed on the back of the seat first.
For safety reasons, a passenger sat inthe rear of the vehicle must not placehis feet on the front seat in the tableposition.

3
Comfort
63

Fully-folded position
)Move the corresponding front seat forward
if necessary. )Put the rear seat in the fully back position. )Place the head restraints in thelow position. )Pull control A, to release the seat back
which folds easily onto the seat cushion.
The seat fits into the floor, providing acontinuous level floor.
To put the seat back in position: )Pull the seat back backwards until it locks
in place.
)Return the seat cushion to the desired position.
When putting back in position, take care not to jam the seat belts.

Comfort
64





Mirrors
The mirror glass is electrically adjustable.
A lamp located under the mirror shell provides
lighting for the driver's and front passenger'sentry and exit.
This exterior lighting comes on when the
vehicle is unlocked or a door is opened and
stays on for a timed period.


Folding
)From outside: lock the vehicle using the
remote control or the key. )From inside: with the ignition on, pull the control A
in the central position rearwards.


Unfolding
)From outside: unlock the vehicle using theremote control or the key. )From inside: with the ignition on, pull the control A
in the central position rear wards.


Adjustment
)
Move control Ato the right or to the left to select the corresponding mirror. )
Move control Bin all four directions toadjust. )
Return control Ato the central position.

If the mirrors are folded using control A
,they will not unfold when the vehicle is unlocked. Pull again on control A.

The folding and unfolding of the door mirrors using the remote control can bedeactivated by a CITROËN dealer or a qualified workshop.
Never fold or unfold the electric foldingmirrors manually.
The objects obser ved are, in reality, closer than they appear.Take this into account in order to correctly judge the distance of vehicles
approaching from behind.

Door mirrors