2013 Citroen C3 engine oil level

.Familiarisation
15

Instrument panel
A.With the ignition on, the fuel gauge bars for
the fuel remaining should come on. B.With the engine running, the associatedlow level warning lamp should go off.C.With the ignition on, the oil level indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the level
whi
ch is low.
Warning lamps
1.With the ignition on, the orange and red
warn
ing lamps come on. 2. With the engine running, these warning lamps should go off.
If a warning lamp remains on, refer to the pageconcerned.

Switch panel

Illumination of the indicator lamp indicates the state of the corresponding system.A.ESP/ASR system deactivation.
B.
Stop & Start system deactivation.

Monitoring
23

25, 3012
5
108

1
Monitoring
23
Panel grouping together the vehicle operation indication dials and warning lamps.
























Instrument panels with manual gearbox
5.Display management buttonServicing information. Adjust the time and choose units.
Reset the service indicator.6.Instrument panel lighting button.Adjusts the brightness of the lighting of the
instruments and controls.
1.Rev counter. Indicates the speed of rotation of the engine (x 1 000 rpm). 2.Vehicle speed. Indicates the current speed of the moving
vehicle (mph or km/h). 3.Fuel level. Indicates the quantity of fuel remaining in
the tank. 4.Screen.
A.Ambient temperature. (°Celsius or °Fahrenheit)B.Gear shift indicator.C.Time.D.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears. E.Trip computer.F.Ser vice indicator. (miles or km) then, Total mileage. These two functions are displayed successively when switching on
the i
gnition.



Screen
For more information, refer to thesection on the button or function and its associated display.


Dials

Monitoring
24

















Instrument panels for electronic or automatic gearboxes
Panel grouping together the vehicle operation indication dials and warning lamps. Depending on the version, the instrument panel may have permanent
back-lighting.
1.Rev counter.Indicates the speed of rotation of the
engine (x 1 000 rpm).2.Vehicle speed.Indicates the current speed of the moving
vehicle (mph or km/h).3.Fuel level.Indicates the quantity of fuel remaining in
the tank. 4.Screen.
5.Display management button
Alternates display between range and trip mileage recorder.
Servicing information.
Resets the selected function to zero (trip
distance recorder or ser vice indicator).
6.Instrument panel lighting button. Adjusts the brightness of the lighting of the
instruments and controls.


ScreenDials
For more information, refer to thesection on the button or function and its associated display.A
.Speed limiter (mph or km/h) or Cruise control.B.Gear shift indicator.C.Electronicorautomatic gearboxinformation.D.Range (miles or km) or Trip mileage recorder.E.
Ser vice indicator
r (miles or km), then Total mileage recorder. These two functions are displayedsuccessively when switching on the ignition
F.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears.

Monitoring
30
reading the associated message in the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the following warning lamps indicates a fault whichrequires action on the par t of the driver.
STOPfixed, alone or
associated withanother warning lamp,accompanied by anaudible signal anda message on the screen. Illumination of the warnin
g lamp is
associated with a serious braking system or engine coolant temperature problem. Stop as soon as it is safe to do so as the en
gine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Servicetemporarily. Minor problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown in
the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control batter
y,
- saturation of the par ticle emission filter on Diesel
vehicles
(see the "Checks - Particle emissions
filter" section).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed.Major problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown
in the screen and contact a CITROËN dealer or a
qualified workshop.
Warning lampis onCauseAction / Observations

Monitoring
32
Maximum coolant temperaturefixed red. The temperature of the coolingsystem is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or qualified workshop.
Engine oil
pressure
fixed. There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.
Battery chargefixed.The battery charging circuit has a fault (dir ty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Low fuel levelfixed.When it first comes on there remainsapproximately 5 litres offuelin thetank.You must refuel as soon as possible to avoid runnin
gout of fuel.
This warning lamp will come on every time the ignition
is switched on
, until a sufficient addition of fuel is made.
Fuel tank capacity: approximately 50 litres (petrol),
46 litres (Diesel) or 37 litres (LPG); depending on
version: approximately 30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this could damage the emission control and injectionsystems.
Warning lampis onCauseAction / Observations

1
Monitoring
37
Engine oil level indicator

This information is displayed for a few seconds
when the ignition is switched on, after theservice information.
Oil level correct
This is indicated by the flashing of "OIL", linked with the ser vice warning lamp, accompanied
by an audible signal and a message in the
multifunction screen.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to prevent damage to the engine.
Oil level low

This is indicated by the flashing of "OIL--" . Contact a CITROËN dealer or a qualified
workshop.

Oil level indicator fault

Dipstick


There are 2 marks on the
dipstick:


- A= max; never exceed this
level (risk of damage to the engine), -B= min; top up the level via
the oil filler cap, using thegrade of oil suited to your engine. R
efer to the "Checks" section to locate the
dipstick and the oil filler cap on your engine.

The level shown will only be correctif the vehicle is on level ground and
the engine has been off for more than 30 minutes.

Checks
140






Checking levels
Oil level


The check is carried out either when
the ignition is switched on using the oil level indicator in the instrument
panel, or using the dipstick.

Engine oil change

Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of the inter val
for this operation.
In order to maintain the reliabilit
y of the engine
and emission control system, the use of
additives in the engine oil is prohibited.
It is normal to top up the oil levelbetween two ser vices (or oil changes). CITROËN recommends that you check
the level, and top up if necessary, every3 000 miles (5 000 kms). After topping up the oil, the check when switching on the ignition with the oil level indicator in the instrument panel is not valid during the 30 minutes after topping up. It will onl
y be correct if the vehicle is on level
ground and the engine has been off for more
than 30 minutes. Check all of these levels re
gularly, in line with the MAINTENANCE AND WARR ANT Y GUIDE. Top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.


Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could star t atany time (even with the ignition off).



Oil specifi cation

The oil must be the correct grade for your engine and conform to the manufacturer'srecommendations.
Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level

Changing the fl uid

Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of the interval for this operation.

Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet
the DOT3 or DOT4 standard.

10
Checks
141
Additive level (Diesel with
particle emissions filter
)
According to your version of instrument panel,
the additive reser voir low level is indicated by:
To p p i ng up
The reser voir must be topped up without delay
by a CITROËN dealer or a qualified workshop.









Used products



- fixed illumination of the particleemissions filter warning lamp,
accompanied by an audible signal, or
- fix
ed illumination of the servicewarning lamp, accompanied byan audible signal and a message
that the par ticle emissions filter additive level is too low.

Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.

Avoid prolonged contact of used oil or fluids with the skin.

Most of these fluids are harmful tohealth or indeed very corrosive.
Coolant level

The coolant level should be close
to the "MA X" mark but should never exceed it.
When the en
gine is warm, the temperature of
the coolant is regulated by the fan.

Changing the coolant
The coolant does not have to be changed.


Fluid specifi cation

The coolant must conform to themanufacturer's recommendations.
Top up the level when necessary.
The cooling fan may star t after switching off the engine: take care with ar ticles and clothing that might become caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off theengine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up t
he level.
Screenwash fluid level
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this
fluid must not be topped up or replaced with plain water.