2012 SSANGYONG NEW ACTYON SPORTS belt

02-8
STICS
40 ms after receiving the air bag deployment signal
at the vehicle speed 3 km/h or higher, it sends out
the door UNLOCK signal for 5 seconds.Driver side (pretensioner)
Air Bag Warning Lamp
2. CONFIGURATION
Seat belt pretensioner
Driver Air Bag
(DAB)

02-98810-01
Passenger Air Bag
Upper side Lower side
Passenger pretensioner
Air Bag Unit (SDM)
The collision G sensor is installed
inside this. And it sends out signals to
deploy the front air bags (driver and
passenger air bags) and/or the driver
and passenger seat belt retensioners.
When the front collision G sensor
sends out only the air bag deployment
signal, the signal deploys the two front
air bags and activates their seat belt
pretensioners.

02-12
4. DEPLOYMENT
According to the collision deceleration rate that each collision G sensor reads, the air bag unit
sends out about 2~4 or higher Amp current. This current generates some heat, which fires the
detonator in the inflator.
The table shows the basic inner resistance of the air bag related module and the basic instant
current necessary for firing.
1) Air Bag System Deployment (Firing Loop)
2) Air Bag Deployment Signal Output (Crash Out)
When the air bag deploys, the signal is sent to STICS to perform the basic security operation
which is the automatic door unlock function that release the automatic door lock mode.
Deployment signal
output (crash out)200ms
Automatic Door Unlock (Crash unlock: unlock when colliding) ▶
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition
key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from 40
ms after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the ignition switch. 1.
2.
3.
4.
Air bag module
DAB /PABSeat belt pretensioner(BPA)
Resistance (at -30 ~ 85˚C) 2 ±0.3 Ω 2.15 ±0.35 Ω
Firing current 1.2 Amps 0.8 Amps
Please do not connect a tester to any air bag connector or single item to measure the
supplied power or resistance. The detonator may explode due to a sudden extra power
supplied by the tester.
Before removing or installing any air bag related components, disconnect the negative
battery cable. -
-

OVERVIEW ANS OPERATING
PROCESS
1. FRONT SEAT.........................................
COMPONENT
7410-01 FRONT SEAT...............................
7410-01 COMPOSITION OF
FRONT SEAT...............................
7510-01 REAR SEAT.................................
7510-01 COMPOSITION OF REAR SEAT..
7430-00 FRONT SEAT BELT.....................
7530-00 REAR SEAT BELT.......................
7430-01 LAYOUT OF SEAT BELTS..........
7510-08 CHILD RESTRAINT SYSTEM
(ISOFIX).......................................
REMOVAL AND INSTALLATION
7410-01 DRIVER SEAT ASSEMBLY..........
7410-01 PASSENGER SEAT ASSEMBLY.
7510-01 RAER SEAT ASSEMBLY.............
7430-01 FRONT SEAT BELT.....................
7530-01 REAR SEAT BELT (3-POINT)......
7530-04 REAR SEAT BELT (2-POINT)......
4
6
8
9
10
11
12
1619
21
23
25
27
29 2

03-10
Components ▶
Seat belt assembly - front
Height adjuster assembly - front seat belt
Cover - front seat belt D-ring
Screw
Buckle assembly - front 1.
2.
3.
4.
5.

03-117530-00
Components ▶
Seat belt assembly - rear first row seat
Double buckle assembly - rear first row seat
Tongue and buckle assembly - rear first row seat
Screw
Cover - Seat belt anchor mounting 1.
3.
4.
7.
8.

03-12
<007b008f008c0099008c004700880099008c0047008d0096009c00990047009b008f0099008c008c00540097009600900095009b0047009a008c0088009b00470089008c0093009b009a0047004f008b00990090009d008c009902c5009a00530047008d00
9900960095009b004700970088009a009a008c0095008e008c>r’s, rear left and rear right) and one
two-point seat belt (rear center).
The front seat belts have the pretensioner. When a severe frontal impact occurs, seat belt
pretensioners rewind the seat belts immediately to restrain the occupants to their seats. It helps
the effective operation of the seat belts and airbags.
Front seat belt (driver’s, front passenger’s)
Type: Three-point type
Installed Removed
A. Pretensioner B. Seat belt anchor
When a severe frontal impact
occurs, seat belt
pretensioners rewind the seat
belts immediately to restrain
the occupants to their seats.

03-137430-01
Rear seat belt (rear left and rear right)
Type: Three-point type
Installed Removed
A. Seat belt anchor
B. Buckle for three-point seat belt
C. Buckle for two-point seat belt
Rear seat belt (rear center)
Type: Two-point type
Installed Removed