2012 SSANGYONG KORANDO turn signal

03-62
The emergency hazard flasher does not operate if the vehicle speed is over 50 km/h when the
emergency stop signal is received.
The emergency hazard flasher operates if the vehicle speed is 50 km/h or lower when the
emergency stop signal is received.
When vehicle speed increases more than 10 km/h above the speed when the signal is received
during operation by emergency braking signal, the emergency hazard flasher stops operation.
When turning emergency hazard flasher switch OFF during operation by emergency braking
signal, it stops operation.
It is deactivated automatically 10 seconds after if items 2) and 3) above are not met during
operation by emergency braking signal.
If multi-function automatic hazard flasher signal is received during operation by emergency
braking signal, it will be overridden. 1)
2)
3)
4)
5)
6) OFF conditions:
The BCM flashes the emergency auto hazard flasher with interval of 1.25 times/sec.: 3.

03-638710-01
19) DRL (Daytime Running Light) Control
When receiving the DRL activation signal, the tail lamps are turned ON when turning the ignition
switch to ON position, and the headlamps are turned ON when the engine speed is 300 rpm or
higher.
When turning ON the tail lamp switch during engine running, the headlamps are turned OFF.
The headlamps do not come ON when the engine speed is above 300 rpm with the tail lamp switch
ON.
The auto light sensor is not available in the vehicle with DRL system.
If there is no DRL activation signal, the light system operates in normal conditions. 1.
2.
3.
4.
5.
20) Fog Lamp Control
When pressing the rear fog lamp switch with IGN2 ON (headlamp ON condition), the rear fog lamps
are turned ON. When pressing the rear fog lamp switch again during the operation, the rear fog lamps
are turned OFF.
The rear fog lamps do not come ON when the IGN2 switch is turned to OFF position or the light
switch is OFF.
The rear fog lamps should not automatically come on again if they have been turned OFF by any
other way other than the switch. 1.
2.
3.
(The rear fog lamps are applied to only EU region)

03-658710-01
22) Outside Mirror Folding/Unfolding Control
Folding/unfolding control ▶
When pressing the mirror folding/unfolding switch with IGN ON, the mirrors are folded or unfolded
according to the mirror condition. If the outside rearview mirror was folded, the mirror should be
<009c0095008d00960093008b008c008b0053004700880095008b0047009d0090008a008c0047009d008c0099009a008800550047006d00960093008b00900095008e0056009c0095008d00960093008b00900095008e00470096009c009b0097009c009b00
470090009a00470088008a009b0090009d0088009b008c008b> for 16±6 seconds.
This operation time should be completed even when the ignition switch is turned to OFF position
during its operation.
At first time pressing the mirror folding/unfolding switch after reconnecting the battery, the mirror
folding operation is performed.
You can control the mirror position within the first 30 sec. after turning the ignition OFF. In other
words, this control must be available for 30 seconds (time lag period) after turning the ignition switch
to OFF position. Folding/unfolding is completed when time lag of 30 seconds elapse during
operation.
When receiving the folding/unfolding signal during the mirror folding/unfolding operation, the output
should be activated after having time lag of 0.1 second.
The folding/unfolding operation is performed regardless of the vehicle speed.
Manual operation
<005400470074009000990099009600990047009c0095008d00960093008b008c008b004702e700470074009000990099009600990047008d00960093008b00900095008e0056009c0095008d00960093008b00900095008e0047009a0090008e0095008800
930047008d0099009600940047009a009e0090009b008a008f> → Mirror folding
<005400470074009000990099009600990047008d00960093008b008c008b004702e700470074009000990099009600990047008d00960093008b00900095008e0056009c0095008d00960093008b00900095008e0047009a0090008e009500880093004700
8d0099009600940047009a009e0090009b008a008f004702e7> Mirror unfolding 1.
2.
3.
4.
5.

03-66
Auto folding/unfolding control ▶
Setting 1.
Set auto folding function: When pressing the mirror folding switch for over 3 seconds, the auto
folding function is set and the internal buzzer sounds once (ON: 0.1 sec, OFF: 0.2 sec).
Release auto folding function: When pressing the mirror folding switch for over 3 seconds, the
auto folding function is set and the internal buzzer sounds twice (ON: 0.1 sec, OFF: 0.2 sec). -
-
Auto folding sequence 2.
When receiving the LOCK signal from the REKES, the system operates in the sequence of "Door
<00930096008a0092004702e70047007b008f008c008d009b0047008b008c009b008c00990099008c0095009b004700940096008b008c00470088008a009b0090009d0088009b009000960095004702e700470074009000990099009600990047008d009600
93008b00900095008e00490047008d0096009900470069006a>M without SKM.
When receiving the outside door handle switch signal or door lock signal from the smart key
<0099008c00940096009b008c0047008a00960095009b00990096009300530047009b008f008c0047009a00a0009a009b008c0094004700960097008c00990088009b008c009a0047009000950047009b008f008c0047009a008c0098009c008c0095008a00
8c00470096008d0047006b009600960099004700930096008a>k → Theft deterrent mode
activation → Mirror folding" for BCM with SKM. -
-
When the auto folding function is set, the automatic unfolding is not available if the mirrors have been
folded manually.
(The outside rearview mirror will be folded automatically if the auto folding function is set.)
The factory setting is the enabling the auto folding function. 4.
5.
23) Approach (Puddle) Lamp Control
Without SKM ▶
Approach lamp ON 1.
When receiving the UNLOCK signal in the theft deterrent mode, the approach lamps come
ON for 30 seconds.
When turning the ignition switch to OFF from ON position and opening the driver door, the
approach lamps come ON. -
-
Approach lamp OFF 2.
When receiving the door lock signal with the approach lamps ON, the lamps go OFF
(reactivation of theft deterrent mode).
When turning the ignition switch to ON position with the approach lamps ON, the lamps go OFF.
The approach lamps go OFF after 30 seconds. -
-
- Auto unfolding sequence 3.
When receiving the UNLOCK signal from the REKES, the system operates in the sequence of
<0049006b0096009600990047009c009500930096008a0092004702e70047007b008f008c008d009b0047008b008c009b008c00990099008c0095009b004700940096008b008c0047008b008c0088008a009b0090009d0088009b009000960095004702e700
470074009000990099009600990047009c0095008d00960093>ding" for BCM without
SKM.
When receiving the outside door handle switch signal or door unlock signal from the smart key
<0099008c00940096009b008c0047008a00960095009b00990096009300530047009b008f008c0047009a00a0009a009b008c0094004700960097008c00990088009b008c009a0047009000950047009b008f008c0047009a008c0098009c008c0095008a00
8c00470096008d0047006b0096009600990047009c00950093>ock → Theft deterrent
<00940096008b008c0047008b008c0088008a009b0090009d0088009b009000960095004702e700470074009000990099009600990047009c0095008d00960093008b00900095008e00490047008d0096009900470069006a00740047009e0090009b008f00
47007a007200740055> -
-

03-678710-01
24) Buzzer Control
Priority are as follows:With SKM ▶
Approach lamp ON 1.
When turning the ignition switch to OFF from ON position and opening the driver door, the
approach lamps come ON.
When receiving the UNLOCK signal from the smart key remote control or outside door handle
switch signal in the theft deterrent mode, the approach lamps come ON for 30 seconds.
When receiving the AUTO approach signal in the theft deterrent mode, the approach lamps
come ON for 30 seconds. -
-
-
Approach lamp OFF 2.
When receiving the door lock signal from the smart key remote control or outside door handle
switch signal with the approach lamps ON, the lamps go OFF (reactivation of theft deterrent
mode).
When turning the ignition switch to ON position with the approach lamps ON, the lamps go OFF.
The approach lamps go OFF after 30 seconds. -
-
-

04-12
The system first identifies the last smart key used, and then identifies all the other registered smart
keys until a normal smart key is verified.
The system identifies the smart keys by using the outside door handle antenna on the door handle
switch which has sent the signal.
Smart key search input: The last door is opened and then closed. Outside door handle switch, Brake
switch, START switch (Tailgate open request) 1.
2.
3.Smart key search mode ▶Searching for other keys ▶
When the ignition status is IGN ON or ACC ON, the SKM starts to verify the smart key if any door is
opened and then closed. If one or more smart keys are verified as being in the vehicle, the smart key
verification procedure is stopped. If no verified smart key is identified as being in the vehicle, the SKM
sends the signal which identifies that there is no verified key inside the vehicle to the BCM and instrument
cluster through the BCAN (Smart key not identified warning).Interruption of door LOCK & Smart key function by outside door handle switch ▶
When the door LOCK signal is received from the driver/passenger door handle switch with the ignition
status OFF or ACC ON, the SKM identifies the verified smart key and sends the passive LOCK signal
to the BCM through the BCAN if the ignition is turned to OFF.
The SKM receives the theft deterrent mode information signal from the BCM through the BCAN.
If there is any verified smart key in the vehicle, the function of the verified smart key is interrupted. 1.
2.
3.

04-158712-03
(5) Puddle (approach) lamp control
Operating condition ▶
When the driver approaches the vehicle in theft deterrent mode (within 1 m), the SKM sends the
puddle lamp operation signal through the BCAN if a smart key is identified.
The SKM starts to search for a smart key 30 sec. after the vehicle has entered the theft deterrent
mode. -
-
Continuous operation ▶
Reset conditions ▶
Standby mode operation ▶When a smart key is identified within 1 m from the vehicle in theft deterrent mode, the SKM sends the
puddle lamp operation signal (10 min. timer activated) through the BCAN. If a smart key is
continuously found within 10 min. the SKM sends the puddle lamp signal again for continuous
operation (up to 2 times within 10 min.)
The SKM starts to search for a smart key 30 sec. after sending the 1st puddle lamp operation signal.
If a smart key is found, the SKM sends the 2nd operation signal. -
-
10 min. timer terminated
Re-entering theft deterrent mode after deactivation -
-
Duration Function Time (s)
1st within 5 days Normal monitoring time 1.25
2nd within 5 to 14 days Increasing monitoring time 1.5
3rd 14 days or more Vehicle is stationary.
The SKM sends the signals for [AUTO approach], [REKES UNLOCK] and [Passive UNLOCK] through
the BCAN to control the puddle (approach) lamp by AUTO puddle (approach) lamp ON, REKES
UNLOCK and Passive entry UNLOCK.
Default setting is AUTO approach.
The AUTO approach function can be turned ON or OFF using a diagnostic device.AUTO puddle (approach) lamp ON ▶
REKES or Passive door LOCK/UNLOCKStop/Standby operation reset condition: ▶
The SKM sends the signals for [REKES UNLOCK] and [Passive UNLOCK] to control the puddle
(approach) lamp ON function by REKES UNLOCK and Passive entry UNLOCK in theft deterrent mode. Puddle (approach) lamp ON by REKES UNLOCK & Puddle (approach) lamp ON by Passive
entry UNLOCK ▶

04-178712-03
3) REKES Control Function
(2) REKES UNLOCK
The SKM receives the signal for [REKES UNLOCK] 0.1 sec. after the UNLOCK button on the smart
key is turned ON, and sends this signal through the BCAN. - When the SKM receives the REKES signals by the buttons on the smart key, it transmits the
corresponding signals through the BCAN.
Switch Stage Remark
LOCK 1 step
100 ms: 1 step CMD
1500 ms: 2 step CMD
1000 ms: 3 step CMD unlocked 1 step
Tailgate open 3 step
PANIC 3 step
(3) Remote keyless tailgate open
When the SKM receives the signal for [REKES UNLOCK] by the UNLOCK button on the smart key, it
transmits this signal through the BCAN.
(1) REKES LOCK
The SKM receives the signal for [REKES LOCK] 0.1 sec. after the LOCK button on the smart key is
turned ON, and it transmits this signal through the BCAN.
When the REKES LOCK signal is received with the ACC ON, the ACC is turned OFF and the signal
for [REKES LOCK] is sent. -
- When the SKM receives the signal for [REKES LOCK] by the LOCK button on the smart key, it transmits
this signal through the BCAN.
The SKM receives the tailgate open signal 1 sec. after the tailgate open button on the smart key is
turned ON with the ignition status OFF, ACC or IGN ON, and it transmits the signal for [REKES
tailgate open] through the BCAN. - When the SKM receives the signal for [REKES tailgate open] by the tailgate open button on the smart
key, it transmits this signal through the BCAN.
Remote keyless tailgate open ▶