Page 91 of 336
3/
EASE OF USE and COMFORT
The duration of lighting varies, depending on the context:
- when the ignition is off, approximately ten minutes,
- in energy economy mode, approximately thirty seconds,
- when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a fi rst aid kit, the
temporary puncture repair kit, a warning triangle, the removable ball of
the towbar system...
BOOT LAMPS
Your vehicle is fi tted with two boot lamps; one in the right-hand boot
side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch off
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim. It also contains the vehicle's handbook pack.
For access to it:
)
raise the fl oor using the strap,
)
secure it in the vertical position behind the stops, located on the sides of the boot.
Page 97 of 336
4/
VISIBILITY
AUTOMATIC "GUIDE-ME-HOME" LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualifi ed workshop.
In fog or snow, the sunshine sensor may detect suffi cient light. In
this case, the lighting will not come on automatically.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled.
When the automatic illumination of headlamps function is activated,
under low ambient light the dipped beams headlamps come on
automatically when the ignition is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home
lighting, is set in the vehicle confi guration menu.
Page 98 of 336
96
MANUAL ADJUSTMENT OF
HALOGEN HEADLAMPSA
UTOMATIC ADJUSTMENT OF
XENON HEADLAMPS
To avoid dazzling other road users, the height of the halogen bulb
headlamps must be adjusted according to the load in the vehicle.
0.
1 or 2 people in the front seats.
-.
3 people.
1.
4 people.
-.
Intermediate setting.
2.
4 people + maximum authorised loads.
-.
Intermediate setting.
3.
Driver + maximum authorised loads. In order to avoid causing a nuisance to other road users, this system
corrects the height of the xenon headlamp beams automatically and
when stationary, in relation to the load in the vehicle.
If a malfunction occurs, this warning lamp is displayed on the
instrument panel, accompanied by an audible signal and a
message in the screen.
The system then places your headlamps in the lowest position.
Initial setting is position "0". Do not touch the xenon headlamp bulbs.
Contact a PEUGEOT dealer or a qualifi ed workshop.
Travelling abroad
If using your vehicle in a country that drives on the other side of
the road, the headlamps must be adjusted to avoid dazzling on-
coming drivers.
Contact a PEUGEOT dealer or a qualifi ed workshop.
Page 99 of 336
4/
VISIBILITY
DIRECTIONAL LIGHTING
When the dipped or main beam headlamps are on, this function enables
the light beams to provide improved lighting of the side of the road when
cornering.
The use of this function, from approximately 12 mph (20 km/h) and
associated with the xenon headlamps only, considerably improves the
quality of your lighting when cornering.
with directional lighting
without directional lighting
PROGRAMMING
OPERATING FAULT
When stationary or moving at very low speed or when reverse
gear is engaged, the function is inactive.
The status of the function remains in the memory when the
ignition is switched off. If a fault occurs, this warning lamp fl ashes in the instrument
panel, accompanied by a message in the screen.
Contact a PEUGEOT dealer or a qualifi ed workshop. The function is activated or deactivated via the vehicle
confi guration menu.
Page 101 of 336
4/
VISIBILITY
WINDSCREEN AND HEADLAMP WASH
)
Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fi xed period.
The headlamp washers only operate when the dipped beam
headlamps are on
.
Screenwash/headlamp wash low
In the case of vehicles fi tted with headlamp washers, when
the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next time you stop, fi ll the screenwash / headlamp wash fl uid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every time the stalk is operated, until the reservoir is fi lled.
Page 104 of 336
102
DIRECTION INDICATORS
If you forget to cancel the direction indicators for more than
twenty seconds, the volume of the audible signal will increase if
the speed is above 40 mph (60 km/h).
)
Left: lower the lighting stalk passing the point of resistance.
)
Right: raise the lighting stalk passing the point of resistance.
HAZARD WARNING LAMPS
A visual warning by means of the direction indicators to alert other road
users to a vehicle breakdown, towing or accident.
)
Press this button, the direction indicators fl ash.
They can operate with the ignition off.
AUTOMATIC OPERATION OF HAZARD
WARNING LAMPS
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They switch off automatically the fi rst time you accelerate.
)
You can also switch them off by pressing the button.
Deactivating the ESC/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the "Trajectory control
systems - Deactivation" section.
Page 105 of 336
5/
SAFETY
TYRE UNDER-INFLATION DETECTION
System which automatically and continuously checks the pressure of
the tyres while driving.
The tyre under-infl ation detection system is an aid to driving which
does not replace the need for the driver to be vigilant or to drive
responsibly. Sensors fi tted in each valve trigger a warning in the event of a problem
(speed above 12 mph (20 km/h)).
Under-inflated tyre
This warning lamp is displayed in the instrument panel
accompanied by an audible signal and an alert message
identifying the wheel concerned.
)
Check the tyre pressures as soon as possible.
This check must be carried out when the tyres are cold.
HORN
Audible warning to alert other road users to an imminent danger.
)
Press one of the spokes of the steering wheel.
EMERGENCY OR ASSISTA NCE
CALL
This system allows you to make an emergency or assistance call to the
emergency services or to the dedicated PEUGEOT service.
For more information on the use of this function, refer to the "Audio
equipment and telematics" section.
Page 106 of 336
104
All repairs and changing of tyres on a wheel fi tted with this
system must be carried out by a PEUGEOT dealer or a qualifi ed
workshop.
If, when changing a tyre, you install a wheel which is not detected
by your vehicle (example: fi tting of snow tyres), you must have
the system reinitialised by a PEUGEOT dealer or a qualifi ed
workshop.
This system does not avoid the need to have the tyre pressures
checked regularly (refer to the "Identifi cation markings" section)
to ensure that the optimum dynamic performance of the vehicle is
maintained and prevent premature wear of the tyres, particularly in
arduous driving conditions (heavy load, high speed).
The tyre pressures must be checked cold, at least once a month.
Remember to also check the pressure of the spare wheel if your
vehicle has one.
The tyre under-infl ation detection system may experience
temporary interference due to electro-magnetic signals on a
frequency close to that used by the system.
Puncture
The STOP
warning lamp comes on and this warning lamp is
displayed in the instrument panel, accompanied by an audible
signal and an alert message identifying the wheel concerned.
)
Stop as soon as it is safe to do so, avoiding any sudden movement
of the steering wheel and the brakes.
)
Repair or change the damaged wheel (punctured or very defl ated
tyre), and have the tyre pressure checked as soon as possible.
Sensor(s) not detected or faulty
This warning lamp is displayed in the instrument panel
accompanied by an alert message to identify the wheel or wheels
which are not detected or to indicate a fault in the system.
Contact a PEUGEOT dealer or a qualifi ed workshop to replace the
faulty sensor(s).
This message is also displayed when one of the wheels is away
from the vehicle (being repaired) or when one or more wheels
without a sensor are fi tted.
If your vehicle has a spare wheel, this does not have a sensor.
