2012 Peugeot M59 buttons

47ACCESS and STARTING
-
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control sys-
tem as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code must
be recognised for the vehicle to start.

If the system does not function
correctly,
the central locking button
indicator light, situated in the centre
of the fascia, fl ashes rapidly when the
ignition is switched on (2nd notch),
accompanied by an audible signal
and a message on the display.
In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon
as possible.






Key in ignition

A buzzer sounds on opening the
driver's door, if the key has been left
in the ignition. Make a careful note of the
number of each key. This
number is coded on the label
attached to the key.
The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock the vehi-
cle, without you being aware of it.
The remote control does not operate
when the key is in the ignition, even
when the ignition is switched off, ex-
cept for reprogramming.
Do not operate the deadlocking function
if there is anyone inside the vehicle.
Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.
As a safety precaution (with children
on board), remove the key from the
ignition when you leave the vehicle,
even for a short time.
Do not repeatedly press the buttons
of your remote control out of range of
your vehicle.
You run the risk of stopping it from
working and the remote control would
have to be reprogrammed.
When purchasing a second-hand
vehicle, have the key codes memo-
rised by a PEUGEOT dealer, to en-
sure that the keys in your possession
are the only ones which can start the
vehicle.
Do not make any modifi cations to the
electronic engine immobiliser system.
If the keys are lost
Visit a PEUGEOT dealer with the vehi-
cle’s V5 registration certifi cate and your
personal identifi cation documents.
The PEUGEOT network will be able
to retrieve the key code and the
transponder code to order a replace-
ment key.


A heavy object (key fob...), attached
to the key and weighing down on
its shaft in the ignition switch, could
cause a malfunction.

AUDIO EQUIPMENT11 2 -

GENERAL FUNCTIONS

AUDIO SETTINGS


Adjusting the loudness
This function automatically empha-
sises bass and treble tones. Press
button I
or J
to switch the function on
or off.
On/Off
With the ignition key
in the accessories or
ignition position, press
button A
to switch the
set on or off.

The set can oper-
ate for 30 minutes
without the vehicle ignition being
switched on.



Anti-theft system
The audio system is coded in such a
way that it can operate only on your
vehicle. It would not function if fi tted
to another vehicle.

The anti-theft system is automatic
and requires no action on your
part.




ADJUSTING THE VOLUME


Adjusting the bass

Adjusting the treble
When "TREB"
is displayed, press
button I
or J
to vary the setting.


- "TREB -9"
for a minimum treble
setting,

- "TREB 0"
for a normal setting,

- "TREB +9"
for a maximum treble
setting.
Press button H
several
times in succession
to access the bass
(BASS)
, treble (TREB)
,
loudness (LOUD)
,
fader (FAD)
, balance
(BAL)
and automatic
volume correction.
Exit from audio mode is automatic
after a few seconds without pressing
any button, or by pressing button H

after confi guration of the automatic
volume correction. When "BASS"
is dis-
played, press button I

or J
to vary the setting.


- "BASS -9"
for a
minimum bass
setting,

- "BASS 0"
for a
normal setting,

- "BASS +9"
for a maximum bass
setting.

Press button C
to in-
crease the volume, or
button B
to decrease
it.
The bass and treble settings
are specifi c to each source.
It is possible to set them dif-
ferently for radio or CD.
Continuous pressure on buttons C

and B
allows a gradual adjustment of
the volume.

11 3AUDIO EQUIPMENT-

RADIO SOURCE

Adjusting the front/rear sound
distribution (Fader)
When "FAD"
is displayed, press but-
ton I
or J
.
Button I
increases the volume in the
front.
Button J
increases the volume in the
rear.

Adjusting the right/left sound
distribution (Balance)
When "BAL"
is displayed, press but-
ton I
or J
.
Button I
increases the volume on the
right-hand side.
Button J
increases the volume on the
left-hand side.

Automatic volume correction
This function enables the volume to
be automatically adjusted depending
on the level of noise produced by the
speed of the vehicle.
Press buttons I
or J
to switch the
function on or off.

Selecting radio mode
Press button R
.

Radio reception
Your car radio is subject to phenom-
ena which do not affect domestic ra-
dio sets. Both AM (MW/LW) and FM
reception are subject to various forms
of interference. This is no refl ection on
the quality of the equipment, but is due
to the nature of the signals and the way
in which they are transmitted.
On MW/LW, interference may be no-
ticed when passing under high voltage
power lines or bridges, or in tunnels.
On FM, interference may be the result
of increasing distance from the trans-
mitter, defl ection of the signals by ob-
stacles (mountains, hills, buildings,
etc.), or of being in an area which is
not covered by a transmitter.
Selecting a waveband
Briefl y press button R
to select the
FM1, FM2, FMast and AM wave-
bands.

AUDIO EQUIPMENT11 4 -
Briefl y press button L
or N
to search
for the station immediately above or
below. By continuing to press the
button in the direction selected, you
will obtain continuous scrolling of the
frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
If the TA
traffi c information pro-
gramme is selected, only stations
broadcasting this type of programme
are selected.
Searching for a station occurs fi rst in
"LO"
sensitivity (selection of the most
powerful transmitters) during scan-
ning of the waveband, then in "DX"

sensitivity (selection of the weakest
and most distant transmitters).
To make a direct search in "DX"
sen-
sitivity, press button L
or N
twice.
Manual station search
Press the "MAN"
button.
Briefl y press button L
or N
to in-
crease or decrease the frequency
displayed.
By continuing to press the button in
the direction selected, you will obtain
continuous scrolling of the frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
Pressing the "MAN"
button again
returns you to automatic station
search.

Manual presetting of stations
Select the station required.
Press one of the buttons "1"
to "6"

for more than two seconds.
The sound stops then becomes audi-
ble again, confi rming that the station
has been stored in the memory.
Automatic station search
Automatic presetting of FM
stations (autostore)
Press and hold button
R
for more than two
seconds.
Your radio automatically presets the
6 stations with the strongest signal in
FM
. These stations are stored in the
FMast waveband.
If it is not possible to fi nd 6 stations,
the remaining preset positions are
empty.

Recalling preset stations
For each waveband, briefl y press
buttons "1"
to "6"
to recall the cor-
responding station.

AUDIO EQUIPMENT11 6 -

EON system
This connects stations which are part
of the same network. It enables the
broadcast of traffi c information, by a
station that is part of the same net-
work as the station to which you are
listening.
This service is available when you
have selected the TA
traffi c informa-
tion programme or the PTY
function.

PTY function

This allows you to listen to stations broad-
casting a specifi c type of programme
(news, culture, sport, rock, etc.).
To search for a PTY
programme:
With FM
selected,
press the "TA"
but-
ton for more than two
seconds to switch this
function on or off.

- select the PTY
function,

- briefl y press button L
or N
to
scroll down the list of the various
types of programmes offered.

- when the programme of your
choice is displayed, keep button L

or N
pressed for more than two
seconds to carry out an automatic
search (after an automatic search
the PTY
function is switched off).
In PTY
mode the different types of
programmes can be stored in the
memory. To do this, press the pre-
set buttons "1"
to "6"
for more than
two seconds. Briefl y press the corre-
sponding button to recall the type of
programme stored in the memory.