Page 176 of 442
Features and controls
3-27
3
To adjust the mirror positionIt is possible to move the mirror up/down and left/right to
adjust its position.
To reduce the glareThe day/night knob (A) at the bottom of the mirror can be used
to adjust the mirror to reduce the glare from the headlights of
vehicles behind you during night driving.1- Daytime position
2- Night position
BK0140800US.book 27 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 182 of 442
Features and controls
3-33
3 Starting the electric motor unit
N00571800014
1. Make sure all occupants are properly seated with seat
belts fastened.
2. Insert the key.
3. Make sure the parking brake is applied.
4. Press and hold the brake pedal down with your right foot.
5. Make sure the selector lever is in the “P” (PARK) posi-
tion.
6. Turn the key to the “ON” position and make certain that
all warning lights are functioning properly before starting
the electric motor unit.
7. Turn the key to the “START” position for one to two sec-
onds, and slowly return it to its original position. When
you hear the startup sound and the ready indicator comes
on, startup of the electric motor unit is complete.Electric motor reminderIf the driver’s door is opened while the key is in the “ON” posi-
tion, the electric motor reminder buzzer sounds intermittently
to remind the key is in the electric motor switch.
Transmission
N00513200203
Selector lever operation
N00513800371
CAUTION
!Never attempt to start the electric motor unit by
pushing or pulling the vehicle.
While depressing the brake pedal, move the selector
lever through the gate.
Move the selector lever through the gate.
BK0140800US.book 33 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 194 of 442
Features and controls
3-45
3
If you turn the steering wheel while the vehicle is station-
ary with the headlights on, the headlights may become
dim. This behavior is not abnormal. The headlights will
return to their original brightness after a short while.Electric power steering system warning light
N00574400011
If there is a malfunction in the system, the warning light will
come on.
Under normal conditions, the warning light comes on when the
electric motor switch is turned to the “ON” position and goes
off a few seconds later.
If the warning light appears while driving
N00574500012
1. Stop the vehicle in a safe place, put the selector lever to
the “P” (PARK) position and turn off the electric motor
unit.
2. Restart the electric motor unit to check whether the warn-
ing light goes out; if it then remains off, there is no prob-
lem.
If the warning light does not go out, or it appears again
while driving, we recommend you to have your vehicle
inspected.
CAUTION
!If the warning light appears during driving, it may
become harder to turn the steering wheel.
BK0140800US.book 45 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 207 of 442
3-58 Features and controls
3
NOTEMirror image is displayed on the screen.
Monitor brightness is adjusted automatically by sensors.
It is possible to change the display language of the screen.
For details, please refer to the separate owner’s manual for
“Mitsubishi Multi-Communication System”.
Under certain circumstances, it may become difficult to
see an image on the screen, even when the system is func-
tioning correctly.
• In a dark area, such as at night.
• When water drops or condensation are on the lens.
• When sunlight or headlights shine directly into the lens.
Instrument cluster
N00519000375
1- Energy level gauge
2- Energy usage indicator
3- Odometer/Trip odometer/Dash lights brightness indica-
tor/Service reminder/Cruising range indicator/Outside
temperature display
4- Speedometer
5- Reset button/Dash lights illumination button/Selector
button
BK0140800US.book 58 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 210 of 442
Features and controls
3-61
3
Odometer/Trip odometer/Dash lights brightness
indicator/Service reminder/Cruising range indi-
cator/Outside temperature display
N00519500439
With the electric motor switch in the “ON” position, odometer,
trip odometer, dash lights brightness indicator, service
reminder, cruising range indicator, and outside temperature are
displayed.To change the display
N00572200015
The display is changed every time the reset button (A) is
briefly pressed.
BK0140800US.book 61 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 211 of 442
3-62 Features and controls
3
NOTEThe cruising range indicator and outside temperature dis-
play are indicated when the electric motor switch is in the
“ON” position.
If there is no operation for about 10 seconds when the
meter illumination control or service reminder is shown,
the display returns to the odometer.Odometer
N00572300016
The odometer indicates the total distance the vehicle has trav-
eled.NOTEEven if the electric motor switch is turned to “ACC” or
“LOCK”, the odometer will be displayed for about 30 sec-
onds after the reset button is pressed.
1- Odometer
2-
Trip odometer
3-
Trip odometer
4- Dash lights brightness indicator
5- Service reminder (Drive distance remaining until next
inspection)
6- Service reminder (Number of months remaining until next
inspection)
7- Cruising range indicator
8- Outside temperature display
BK0140800US.book 62 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 215 of 442
3-66 Features and controls
3
Dash lights brightness indicator
N00572600019
Each time you press the dash lights illumination button (B), the
brightness of the instruments changes.
NOTEYou can adjust to 4 different levels for when the parking
lights or headlights are illuminated and 4 for when they
are not.
If you press and hold the button for longer than about 1
second, the brightness automatically scrolls through its
different levels, and stops scrolling when you release the
button. Select your desired level of brightness.
When the combination headlights and dimmer switch is in
the “AUTO” position, the meter illumination switches
automatically to the adjusted brightness, depending on the
brightness outside the vehicle.
The brightness level of the instruments is stored when the
electric motor switch is turned off.
If the 12V starter battery is disconnected for a long time,
these level of brightness will be reset.
A- Brightness display
B- Dash lights illumination button
Bright Dim
BK0140800US.book 66 ページ ２０１１年９月２９日 木曜日 午後３時２８分
Page 220 of 442
Features and controls
3-71
3 Indicator and warning light package
N00519800836
1- Low energy warning indicator → P.3-69
2- Selector lever position indicator → P.3-34
3- Acoustic Vehicle Alerting System (AVAS) indicator
→ P.3-38
4- High-beam indicator → P.3-72
5- Turn-signal indicators/Hazard warning lights → P.3-72
6- Position indicator → P.3-72
7- Front fog light indicator (if so equipped) → P.3-72
8- Service reminder → P.3-63
9- Outside air temperature warning indicator → P.3-67
10- Regenerative brake system indicator → P.3-72
11- Ready indicator → P. 3 - 7 2
12- Tire pressure monitoring system warning light → P.3-50
13- 12V starter battery charging system warning light → P.3-7414- Electric power steering system warning light → P.3-45
15- Electric motor unit warning light → P.3-75
16- Brake warning light → P.3-73
17- Anti-lock braking system warning light → P.3-42
18- Power down warning light → P.3-75
19- Active stability control (ASC) indicator → P.3-48
20- Active stability control (ASC) OFF indicator → P.3-48
21- Charging indicator → P.3-72
22- Theft-alarm indicator → P.3-18
23- Door-ajar warning light → P.3-74
24- Driver ’s seat belt reminder/warning light → P.2-17
25- Supplemental Restraint System (SRS) warning light
→ P. 2 - 2 2
BK0140800US.book 71 ページ ２０１１年９月２９日 木曜日 午後３時２８分
