2012 MERCEDES-BENZ G-Class warning

Display messages Possible causes/consequences and
M Solutionsb
Reversing lamp
right The backup lamp is faulty.
X
Replace the bulb ( Y page 94).b
Tail lamp left
Back-up bulb on
 or 
Tail lamp right
Back-up bulb on The left or right-hand tail lamp is faulty. Another lamp has taken
over its function.
X
Replace the bulb ( Y page 98).Engine
Display messages Possible causes/consequences and
M Solutions; Some electronic systems are unable to send information to the
on-board computer. The coolant temperature gauge and the
tachometer could be malfunctioning.
X
Visit a qualified specialist workshop. +
Top
Up
Coolant See
Operator's Manual The coolant level is too low.
X
Add coolant, following the warning notes when doing so
(Y page 213).
X If coolant needs to be added more often than usual, have the
engine coolant system checked at a qualified specialist
workshop. G
WARNING
Do not spill antifreeze on hot engine parts. Antifreeze contains ethylene glycol which may burn
if it comes into contact with hot engine parts. You could be seriously burned.
! The coolant

level is too low. Avoid making long journeys with too little coolant in the cooling
system. The engine will otherwise be damaged.
The display messages and the corresponding symbol that indicate that the coolant level is
too low must not be ignored. 170
Display messages
On-board computer and displays

Display messages Possible causes/consequences and
M Solutions?
Coolant
Stop,
Turn
Engine Off The coolant is too hot.
X
Pull over and stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
X Make sure that the air supply to the radiator is not blocked, e.g.
by snow, slush or ice.
X Wait until the display message disappears before restarting the
engine. Otherwise, there is a risk of engine damage.
X Pay attention to the coolant temperature display.
X If the temperature increases again, visit a qualified specialist
workshop immediately. The poly-V-belt may have torn.
X
Pull over and stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
X Open the hood.
X Check whether the poly-V-belt is torn.
If the poly-V-belt is torn:
! Do not

continue driving. The engine could otherwise overheat.
X Consult a qualified specialist workshop.
If the poly-V-belt is not damaged:
X Wait until the display message disappears before restarting the
engine. Otherwise, there is a risk of engine damage.
X Pay attention to the coolant temperature display.
X Visit a qualified specialist workshop. G
WARNING
Driving when your engine is overheated can cause some fluids which may have leaked into the
engine compartment to catch fire. You could be seriously burned.
Steam from

an overheated engine can cause serious burns which can occur just by opening the
engine hood. Stay away from the engine if you see or hear steam coming from it.
Stop the vehicle in a safe location away from other traffic. Turn off the engine, get out of the
vehicle and do not stand near the vehicle until the engine has cooled down.
! If the coolant temperature exceeds 248 ‡(120 †) do not continue driving. The engine will
otherwise be damaged. Display messages
171
On-board computer and displays Z

Tires
G
WARNING
Do not drive with a flat tire. A flat tire affects the ability to steer or brake the vehicle. You may
lose control of the vehicle. Continued driving with a flat tire will cause excessive heat build-up
and possibly a fire. G
WARNING
Follow recommended tire inflation pressures.
Do not
underinflate tires. Underinflated tires wear excessively and/or unevenly, adversely affect
handling and fuel economy, and are more likely to fail from being overheated.
Do not overinflate tires. Overinflated tires can adversely affect handling and ride comfort, wear
unevenly, increase stopping distance, and result in sudden deflation (blowout) because they are
more likely to become punctured or damaged by road debris, potholes etc. Display messages Possible causes/consequences and
M
Solutions
Tire pressure
displayed only
after driving for
a few minutes The tire pressure monitor is measuring the tire pressure.
X
Drive on.
The tire

pressures appear in the multifunction display after you
have been driving for a few minutes. Tire Pres.
Check Tires
G
Risk of accident
The
tire pressure monitor has detected a significant pressure loss.
X Stop the vehicle without making any sudden steering or braking
maneuvers. Pay

attention to the traffic conditions as you do so.
X Check the tires.
X Check the tire pressure and correct it if necessary
(Y page 242).
X Repair or change the faulty wheel as necessary ( Y page 226).
X Then restart the tire pressure monitor when the tire pressure is
correct (

Y page 249). Tire Pres. Monitor
Inoperative The tire pressure monitor is deactivated due to a malfunction.
X
Visit a qualified specialist workshop. Tire Pres. Monitor
Inoperative No
Wheel Sensors The wheels mounted do not have a suitable tire pressure sensor.
The tire pressure monitor is deactivated.
X
Mount wheels with suitable tire pressure sensors.
The tire

pressure monitor is activated automatically after driving
for a few minutes. Display messages
175
On-board computer and displays Z

Display messages Possible causes/consequences and
M Solutionsh
Tire
Pres.
Caution
Tire Defect G
Risk of accident
The tire pressure in one or more tires has dropped suddenly.
X Stop the vehicle without making any sudden steering or braking
maneuvers. Pay

attention to the traffic conditions as you do so.
X If necessary, change a wheel ( Y page 226).h
Tire Pres. Check
Tires G
Risk of accident
The tire pressure in one or more tires has dropped significantly.
X Stop the vehicle without making any sudden steering or braking
maneuvers. Pay

attention to the traffic conditions as you do so.
X If necessary, change a wheel ( Y page 226).
X Check the tire pressure. If necessary, correct the tire pressure
(Y page 248). Vehicle
Display messages Possible causes/consequences and
M Solutions: The rear door is open.
X
Close the rear door. M G
Risk of accident
Vehicles with anti-theft alarm system:
The hood is open. A warning tone also sounds.
X Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
X Apply the parking brake.
X Close the hood. ¡ At least one door is open.
X
Close all the doors. ~
Bluetooth Ready The Bluetooth
®
connection between your mobile phone and
COMAND is not activated.
X If desired, activate the Bluetooth ®
connection between your
mobile phone and COMAND (see the separate Operator's
Manual). ¥
Top
Up

Washer Fluid The washer fluid level in the washer fluid reservoir has dropped
below the minimum.
X
Add washer fluid ( Y page 214). Display messages
177
On-board computer and displays Z

Display messages Possible causes/consequences and
M Solutions©
TC
Shift
Procedure
Canceled The gear change process was not carried out.
X
Repeat the gearshift process. ©
TC Shift
Conditions Not
Fulfilled One or more conditions to shift the transfer case have not been
fulfilled.
X
Repeat the gearshift process. ©
TC In Neutral The transfer case is in the neutral position.
X
Shifting the transfer case into HIGH or LOW.©
Transfer Case
Service Required There is a malfunction in the transfer case.
X
Do not shift the transfer case.
X Have the vehicle checked as soon as possible at a qualified
specialist workshop. G
WARNING
If the transfer case is in Neutral,
the
park position P of the automatic transmission will not hold
the vehicle. The parking brake must be engaged to hold the vehicle in place. Warning and indicator lamps in the instrument cluster
Seat belts
Problem Possible causes/consequences and
M Solutions7
After starting the
engine, the red seat
belt
warning

lamp lights
up for six seconds. The seat belt warning lamp reminds the driver and front passenger
to fasten their seat belts.
X
Fasten your seat belt ( Y page 41).7
After starting the
engine, the red seat
belt
warning

lamp lights
up. In addition, a
warning tone sounds
for up to six seconds. G
Risk of injury
The driver's seat belt is not fastened.
X Fasten your seat belt ( Y page 41).
The warning tone ceases. 178
Warning and indicator lamps in the instrument cluster
On-board computer and displays

Problem Possible causes/consequences and
M Solutions7
The red seat belt
warning lamp lights up
after the engine starts,
as soon as the driver's
or the front-passenger
door is closed.
G
Risk of injury
The driver or front passenger has not fastened their seat belt.
X Fasten your seat belt ( Y page 41).
The warning lamp goes out. G
Risk of injury
There are objects on the front-passenger seat.
X Remove the objects from the front-passenger seat and stow
them in a secure place.
The warning lamp goes out. 7
The red seat belt
warning lamp flashes
and an intermittent
audible warning
sounds.
G
Risk of injury
The driver or front passenger has not fastened their seat belt. In
addition, you
are driving faster than 15 mph (25 km/h) or you have
briefly driven faster than 15 mph (25 km/h).
X Fasten your seat belt ( Y page 41).
The warning
lamp goes out and the intermittent audible warning
ceases. G
Risk of injury
There are objects on the front-passenger seat. In addition, you are
driving faster than 15 mph (25 km/h ) or you have briefly driven
faster than 15 mph (25 km/h

).
X Remove the objects from the front-passenger seat and stow
them in a secure place.
The warning

lamp goes out and the intermittent audible warning
ceases. Warning and indicator lamps in the instrument cluster
179
On-board computer and displays Z

Safety systems
Problem Possible causes/consequences and
M Solutions
$ (USA only)
J (Canada only)
The red brake system
warning lamp

comes on
while the vehicle is
moving. A warning tone
also sounds. You are driving with the parking brake applied.
X
Release the parking brake.
The warning lamp goes out and the warning tone ceases. $
(USA only)
J (Canada only)
The red brake system
warning lamp

comes on
while the engine is
running. G
Risk of accident
There is not enough brake fluid in the brake fluid reservoir.
X Pull
over and stop the vehicle safely as soon as possible, paying
attention to

road and traffic conditions. Do not continue driving
under any circumstances.
X Engage the parking brake.
X Consult a qualified specialist workshop immediately.
X Observe the additional display messages in the multifunction
display.
Do not add brake fluid. This will not rectify the malfunction. G
WARNING
Driving
with the brake warning lamp illuminated can result in an accident. Have your brake system
checked immediately

if the brake warning lamp stays on. Do not add brake fluid before checking
the brake system.
Overfilling the brake fluid reservoir can result in spilling brake fluid on hot engine parts and the
brake fluid catching fire. You can be seriously burned. 180
Warning and indicator lamps in the instrument cluster
On-board computer and displays

Problem Possible causes/consequences and
M Solutions!
The
yellow
ABS warning
lamp is lit while the
engine is running. G
Risk of accident
ABS (Anti-lock Brake System) is deactivated due to a malfunction.
Therefore, BAS

(Brake Assist), ESP ®
(Electronic Stability Program),
EBD (electronic brake force distribution) and 4ETS are also
deactivated.
The brake system continues to function normally, but without the
functions listed above. The wheels could therefore lock if you
brake hard, for example.
X Observe the additional display messages in the multifunction
display.
X Drive on carefully.
X Visit a qualified specialist workshop.
If the ABS control unit is defective, other systems, such as the
navigation system or the automatic transmission, may also be
unavailable. !
The
yellow

ABS warning
lamp is lit while the
engine is running. G
Risk of accident
The on-board voltage is too low. ABS has been deactivated due to
undervoltage.
ESP ®
, BAS, EBD and 4ETS are therefore also deactivated, for
example.
The brake

system continues to function normally, but without the
functions listed above. The wheels could therefore lock if you
brake hard, for example.
X Observe the additional display messages in the multifunction
display.
X Drive on carefully.
X Switch off consumers that are not required, e.g. the rear window
defroster or interior lighting.
ABS will be available again as soon as the vehicle's on-board
electrical system voltage increases.
If the warning lamp is still on:
X Have the battery and alternator checked at a qualified specialist
workshop. !
The
yellow

ABS warning
lamp is lit while the
engine is running. You have engaged the differential locks. ABS, BAS, EBD, ESP
®
and
4ETS are deactivated.
X Disengage the differential locks.
Subsequently, ABS, BAS, EBD, ESP ®
and 4ETS are reactivated. Warning and indicator lamps in the instrument cluster
181
On-board computer and displays Z