2012 HONDA ACCORD COUPE Owners Manual

Page 377 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Dirt build-up around the openings of
the seat belt anchors can cause the
belts to retract slowly. Wipe the
openings with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.
If you

Page 378 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual This f ilter removes the dust and
pollenthatisbroughtinfromthe
outside through the heating and
cooling system/climate control
system.
Have your dealer replace this filter
when this service is indicate

Page 379 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual To replace a wiper blade:Raise the wiper arm of f the
windshield. Raise the driver’s side
first, then the passenger’s side.
Check the condition of the wiper
blades at least every six months.
Repla

Page 380 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Pivot the blade assembly toward
the wiper arm until it releases
from the wiper arm.
When replacing a wiper blade,
make sure not to drop the wiper
blade or wiper arm down on the
windshield.Examine the

Page 381 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Slide the wiper blade assembly
onto the wiper arm. Push down
thelocktab.Makesurethewiper
blade assembly locks in place.
Lower the wiper arm down against
the windshield, the passenger’s
side first, t

Page 382 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Keeping the tires properly inf lated
provides the best combination of
handling, tread lif e, and riding
comf ort.Underinf lated tires wear unevenly,
adversely affect handling and fuel
economy, and are

Page 383 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual If you check air pressures when the
tires are hot (driven f or several
miles/kilometers), you will see
readings 4 to 6 psi (30 to 40 kPa, 0.3
to 0.4 kgf/cm ) higher than the cold
readings.Thisisnormal

Page 384 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of trea