2012 Citroen DS5 Owner's Manual

215
Practical information

009
Checks

TOTAL & CITROËN

219Checks
Opening the bonnet
Opening
)
From inside: pull the release lever, located
on the left below the dashboard, towards you.
Before doing anything under the bonnet,
switch off the Stop & Star t system toavoid any risk of injury resulting from anautomatic change to STA R T m o d e .

Closing
)
Lower the bonnet and release it at the endof its travel. )
Check that it is latched correctly.


)From the outside: lift the safety catch and
raise the bonnet.
A bonnet strut opens the bonnet and holds itopen.

The various caps and covers allow access for
checking the levels of the various fluids and for replacing cer tain components.














Petrol engines
1.
Power steering reservoir.2.
Screenwash and headlamp wash reser voir.3.
Coolant reservoir. 4.
Brake fluid reservoir.5.
Battery/Fuses.
6.Fusebox.
7. Air filter.8.Engine oil dipstick. 9.
Engine oil filler cap.THP 155 6- SPEED AUTOTHP 200 6- SPEED MANUAL

221Checks
The various caps and covers allow access for
checking the levels of the various fluids, for
replacing cer tain components and for primingthe fuel system.

*

According to engine.















Diesel engines
1.
Power steering reservoir.2.Screenwash and headlamp wash reser voir.3.Coolant reservoir.4.
Brake fluid reservoir.
5. Battery/Fuses.
6.Fusebox.
7. Air filter.8.Engine oil dipstick.9.
Engine oil filler cap.10.Priming pump * . 11.
Bleed screw * .
e- HDi 110 6- SPEED ELECTRONIC
HDi 160 PEF 6- SPEED MANUAL/HDi 160 PEF 6- SPEED AUTO

system must be primed if you run out of fuel; refer to the engine compar tment view on the
"Diesel engine" page.










Running out of fuel (Diesel)

If the tank on your vehicle is fitted witha misfuel prevention device, refer to the section "Access - § Misfuel prevention(Diesel)".
)
Fill the fuel tank with at least five litres of diesel. )
Open the bonnet.)
If necessary, unclip the styling cover for
access to the priming pump.
) Squeeze and release the priming pump
repeatedly until resistance is felt (there may
be resistance at the first press). ) Operate the star ter until the engine starts(if the engine does not star t at the first
attempt, wait around 15 seconds before
trying again). ) If the engine does not star t after a few
attempts, operate the priming pump again
then start the en
gine. ) Clip the styling cover back in place.
)
Close the bonnet.



1.6 litre HDi engine
)Fill the fuel tank with at least five litres of Diesel.)Open the bonnet. )If necessary, unclip the style cover for access to the priming pump. )Slacken the bleed screw.)Squeeze and release the priming pump repeatedly until fuel appears in the
transparent pipe.
)Tighten the bleed screw. )Operate the star ter until the engine star ts (if the engine fails to star t at the first attempt, wait around 15 seconds before
trying again).)If the engine fails to star t after a fewattempts, operate the priming pump again,
th
en the starter. )Put the style cover back in position andclip it in place, ensuring that it has clippedcorrectly.)Close the bonnet.
2 litre HDi engine

If the engine does not star t first time, don't keep trying. Start the procedure
again from the beginning.