Page 161 of 358
159Visibility
Wiper controls
Programming
Various automatic wiper control modes are also
available according to the following options:
- automatic rain sensitive windscreen wipers,
- rear w
iping on engaging reverse gear.
Manual controls
The wipers are controlled directly by the driver. The vehicle's
front and rear wipers are
designed to improve the driver's visibility
progressively according to the climaticconditions.
Windscreen wipers
Wiping speed:
fast
(heavy rain),
normal
(moderate rain),
intermittent
(proportional to the
speed of the vehicle),
park,
automatic
(press down and
release),
single wipe
(pull the stalk briefly towards you).
Page 162 of 358
Rear wiper
If a significant accumulation of snowor ice is present, or when using a bicycle carrier on the boot, deactivatethe automatic rear wiper via theconfiguration menu. park,
intermittent wipe,
wash-wipe
(set duration).
Reverse gear
When reverse gear is engaged, the rear wiper
will come into operation if the windscreen
wipers are operatin
g.
Th
e function is activated or
deactivated via the configuration menu.
This function is activated by default.
Programming
)Pull the windscreen wiper stalk towards you. The windscreen wash then the
windscreen wipers operate for a fixed
period.
The headlamp washers only operate when
the dipped beam headlamps are on.
Windscreen and headlamp
wash
Rear wiper selection ring:
Page 163 of 358
161Visibility
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically,
without any action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Switching on
Briefly push the control stalkdownwards.
This warning lamp comes on in the
instrument panel and a messa
ge is
displayed. Brie
fly push the control stalkdownwards again, or place the control stalk in another position
(Int, 1 or 2).
This warning lamp goes off in the instrumentpanel and a message is displayed.
Switching off
The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if theignition has been off for more than one minute.
Page 164 of 358

Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror. Switch off the automatic rain sensitive wipers when using an automatic car wash.
In winter, it is advisable to wait until the windscreen is completely clear of ice before activating the automatic rain sensitive wipers.
Operating fault
If a fault occurs with the automatic rain
sensitive wipers, the wipers will operate in intermittent mode.
Have it checked by CITROËN dealer or a
qualified workshop.
Special position of
the windscreen wipers
This position permits release of the windscreen
wiper blades.
It is used for cleaning or replacement of
the blades. It can also be useful, in winter,
to detach the blades from the windscreen.
To maintain the effectiveness of the "flat-blade" type of wiper blades, it isadvisable to:
- handle them with care,
- clean them regularly using soapywater,
- avoid using them to retain cardboard on the windscreen,
- replace them at the first signs of wear.
)
Any action on the wiper stalk in the minute
after switching off the ignition places the
blades vertically on the screen. ) To park the blades again, switch on theignition and operate the wiper stalk.
Page 165 of 358

163Visibility
1.Front - rear cour tesy lamp2.Front map reading lamps 3.Rear map reading lamp s4.Interior mood LEDs
Courtesy lamps
In this position, the cour tesy lamp comes on gradually:
Front - rear courtesy lamps
Take care to avoid leaving anything in contact with the cour tesy lamps.
With the "permanent lighting" mode, the lighting time varies according to the circumstances: - with the ignition off, approximatelyten minutes,- in energy economy mode, approximately thirty seconds,
- with the hybrid system active, unlimited.
- when the vehicle is unlocked,
- when the electronic key is removed from
the reader,
- when opening a door,
- when the remote control locking button is
activated, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the i
gnition is switched on,
- 30 seconds after the last door is closed.
Permanentl
y off.
Permanent lighting.
Front - rear map reading
lamps
)
With the ignition on, press thecorresponding switch.
Page 166 of 358

Interior mood lighting The dimmed passenger compar tment lighting improves visibility in the vehicle when the light is poor.
At night, the interior mood lighting comes onautomatically when the sidelamps are switched
on (for example, a source of light in the roof console illuminates the middle of the centre console).
The interior mood lighting switches off automatically when the sidelamps are switched off. Lamps on: there are 7 levels o
f brightness.
The level of brightness increases progressively
with each press of the button, returning to zero after the maximum level is reached.
A long press gives maximum brightness.
This adjustment is used to set the mood lighting level for the interior lamp, as well as for the
door opening controls and the storage locations(depending on version).
Foot well lighting
Activation
Its operation is identical to that of the cour tesy
lamps. The lighting comes on when one of the
doors is opened. The so
ft lighting provided by the footwell lamps
improves visibility in the vehicle when the light
is poor.
Switching on
Adjusting the brightness of
the courtes
y lamp
Page 167 of 358
Page 168 of 358