2012 Citroen DS4 eco

Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)Fold back the rear seats to gain access to
the lock from inside the boot.)Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )Move the latch to the left.

)After unlocking the boot or the vehicleusing the remote control or the key, press
the opening control, then raise the tailgate.

Opening

Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate to fully close it.


-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,

-
when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal andthe display of an aler t message for a fewseconds.



Locking after closing

If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:

115
Access
1.Driver's electric window control.2.Passenger's electric window control.

-
manual mode)
Press or pull the control gently.The window stops when the control is
released.

- automatic mode)
Press or pull the control firmly.
The window opens or closes fully when
the control is released.) Pressing the control again stops themovement of the window.


The electric window controls remain operational for approximately45 seconds after the ignition is switched off or until the vehicle islocked after a door is opened.
If the passenger 's window cannot be operated from the driver's door controlpanel, carry out the operation from the passenger's door control panel,and vice versa.















Electric windows
Fitted with a safety anti-pinch system.
One-touch electric
windows
There are two options:
After approximately ten consecutivecomplete opening/closing movements of the window, a protection function is activated which only authorises closingof the window to prevent damage to theelectric window motor. Once the window is closed, the controls will become available again after approximately 40 minutes.

Safety anti-pinch
When the window rises and meets an obstacle,
it stops and par tially lowers again.

Reinitialisation

If a window does not rise automatically,
its operation must be reinitialised:
) pull the control until the window stops, )
release the control and pull it again until
the window closes fully,) continue to hold the control for
approximately one second after the
window has closed,
) press the control to lower the window
automatically to the low position, ) when the window has reached the low
position, press the control again for
approximately one second. The safety anti-pinch function is not operational during these operations.

If the window cannot be closed(for example, in the presence of ice),once the window has lowered: )press and hold the control until the window opens fully, )then pull the control immediately and hold it until the window closes, )continue to hold the control for approximately one second after thewindow has closed.The safety anti-pinch function is not operational during these operations.


Always remove the key from the ignition when leaving the vehicle, even for a short time.
If an obstacle is encountered duringoperation of the electric windows,you must reverse the movement of the window. To do this, press the controlconcerned.
When the driver operates thepassenger's electric window control, they must ensure that nothing ispreventing the windows closing correctly.
The driver must ensure that the passengers use the electric windowscorrectly.
Be aware of children when operating the windows.

Deactivation


Use
)Introduce the tool into the filler neck as far as the handle will allow.)Remove the tool completely.)Fill with fuel.
Before refuellin
g using non-standard Diesel
fuel nozzles (present in some countries), a tool
allows you to temporarily disable the misfuel
prevention device.
The misfuel prevention device will beactivated the next time a standard nozzle is used.

This tool will become available durin
g the year.



Tr a v e l l i ng abroad
As Diesel fuel pump nozzles may be different in other countries, the presenceof the misfuel prevention device maymake refuelling impossible.
Before travelling abroad, we recommend that you check with the CITROËN dealer network, whether your vehicle is suitable for the fuel pumps in the country in which you want to travel.

Foglamp selection ring.
The foglamps operate with the dipped and mainbeam headlamps.
Rotate and release the rin
g C:)
forwards a first time to switch on the front foglamps ,)
forwards a second time to switch on the
rear foglamps,) rearwards a first time to switch off the rear foglamps,)
rearwards a second time to switch off thefront foglamps.
Model with front and rear foglamps

In good or rainy weather, by both day and night, the front foglamps and the rear foglamps are prohibited. In these situations, the power of their beams may dazzle other drivers. They shouldonly be used in fog or falling snow.
In these weather conditions, you should switch on the foglamps and dippedbeam headlamps manually, as the sunshine sensor may detect sufficientlight.
Do not forget to switch off the front and rear foglamps when they are no longer necessary.
front and rear foglamps
When the headlamps switch o
ff with automatic
illumination of headlamps (AUTO model) or
when the dipped beam headlamps are switched
off manuall
y, the foglamps and sidelampsremain on.) Turn the ring rear wards to switch off thefoglamps, the sidelamps will then switch off.

127Visibility

Switching off the lighting when switching off the ignition

When the ignition is switched off, allof the lamps switch off immediately, except for the dipped beam headlamps if automatic guide-me-home lighting is activated.
Temporarily keeping the dipped beamheadlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor.
Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A further "headlamp flash" switches thefunction off.

Switching off
The manual guide-me-home lighting switches
o
ff automatically after a set time.
Manual guide-me-home
lighting

Switching on the lightingwhen switching on the ignition
To reactivate the lighting control stalk, turnthe ring Ato position A"0"
- lighting off, then to the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that they have forgotten to switchoff the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down dependin
g on the traffic side(for example: when parking on the left;
lighting control stalk upwards; the right hand sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the central position.

Cornering lighting
With dipped or main beams, this function makes use of the beam from a front foglamp to
illuminate the inside of a bend, when the vehicle
speed is below 25 mph (approximately 40 km/h)(urban driving, winding road, intersections,
parking manouevres...).

Switching on
with cornering lighting
without cornering lighting


Switching off

The system does not operate:


- below a cer tain angle of rotation of thesteering wheel,

- above 25 mph (40 km/h),

- when reverse gear is engaged.
The s
ystem is activated by default.

Programming
The system is activated or deactivated in the vehicleconfiguration menu. Thi
s function starts:


- when the corresponding direction indicator is switched on,
or

- from a cer tain angle of rotation of the steering wheel.

1.Front courtesy lamp
2.Front map reading lamps3.Rear courtesy lamp4.Rear map reading lamps











Courtesy lamps
In this position, the cour tesy lamp comes on gradually:


Front and rear courtesy lamps



- when the vehicle is unlocked,

- when the key is removed from the ignition,

- on opening a door,

- when the remote control locking button is used to locate your vehicle.
It switches off
gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is closed.
Permanently o
ff.
Permanent li
ghting.
In permanent lighting mode, the lighting time varies according to thecircumstances:



- with the ignition off, approximately ten minutes,

- in energy economy mode,approximately thirty seconds,

- with the engine running, unlimited.
When the cour tesy lamp is in the"permanent lighting" position, the rear courtesy lamp also comes on, except if it is in the "permanently off" position.To s w i t c h off the rear cour tesy lamp, put it in the the "permanently off" position.


Front and rear map reading
lamps
)
With the ignition on, press the corresponding switch.

Take care not to put anything in contact with the courtesy lamps.