Page 183 of 316
XI
!
181
PRACTICAL INFORMATION
CHANGING A BULB
Front lamps
Model with Xenon headlamps (D1S)
1.
Dual-function Xenon
headlamps (dipped/main):
D1S
2.
Cornering lighting:
HP19
3.
Daytime running lamps /
sidelamps (LEDs)
For the maintenance of the front lamps
and changing HP19 and D1S bulbs
and LED lamps, contact a CITROËN
dealer or a qualifi ed workshop.
Risk of electrocution
Xenon bulbs must be replaced by
a CITROËN dealer or a qualifi ed
workshop.
You are advised to change both
D1S bulbs at the same time, if one
of them has failed. The headlamps are fi tted with
polycarbonate glass with a
protective coating:
)
do not clean them using a dry
or abrasive cloth, nor with a
detergent or solvent product,
)
use a sponge and soapy water,
)
when using a high pressure
washer on persistent marks, do
not keep the lance directed to-
wards the lamps or their edges
for too long, so as not to dam-
age their protective coating and
seals,
)
do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a bulb should only be
done after the headlamp has been
switched off for a few minutes (risk
of serious burns).
It is imperative to use only anti-
ultraviolet (UV) type bulbs in order
not to damage the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
specifi cation.
Page 184 of 316
XI
182
PRACTICAL INFORMATION
Main beam headlamps
)
Remove the protective cap A
.
)
Disengage the retaining spring.
)
Remove the bulb and replace it,
paying attention to the direction
of fi tting.
)
Refi t the retaining spring.
)
Refi t the protective cap A
.
Model with halogen headlamps
1.
Main beams:
H1
2.
Dipped beams:
H7
3.
Directional lighting:
H7
4.
Daytime running lamps /
sidelamps (LEDs)
For the maintenance of the front lamps
and changing LED lamps, contact a
CITROËN dealer or a qualifi ed work-
shop.
Page 185 of 316
XI
183
PRACTICAL INFORMATION
Dipped beam
headlamps
)
Remove the protective cap B
.
)
Disconnect the connector by
pressing it between the thumb
and index fi nger.
)
Free the bulb from its two metal
clamps.
)
Take out the bulb.
)
Replace the bulb, exerting a slight
axial force.
)
Refi t the connector, until it is all
the way in.
)
Refi t the protective cap B
.
Directional lamp
)
Remove the protective cap C
.
)
Disconnect the connector by
pressing it between the thumb
and index fi nger.
)
Free the bulb from its two metal
clamps.
)
Take out the bulb.
)
Replace the bulb, exerting a
slight axial force.
)
Refi t the connector, until it is all
the way in.
)
Refi t the protective cap C
.
Page 192 of 316
XI
190
PRACTICAL INFORMATION
Interior lamps
Roof lamps
)
Unclip the transparent cover of
the roof lamp to reach the bulb.
Bulb:
W 5 W
Rear reading lamps (Tourer)
)
Detach the cover of the reading
lamp to access the bulb.
Bulb:
W 5 W
Map reading lamp
)
Detach the cover.
)
If necessary, detach the partition
of the affected map reading lamp.
Boot lamp
)
Detach the cover and use a W 5W
bulb.
Pavement lighting
)
Detach the cover and use a W 5W
bulb.
Floor lighting
)
Detach the cover and use a W 5W
bulb.
Glove box
)
Detach the cover and use a W 5W
bulb.
Page 194 of 316
XI
192
PRACTICAL INFORMATION
Table of fuses
Fuse N°
Rating
Function
G29
-
Not used
G30
5 A
Heated door mirrors
G31
5 A
Rain and sunshine sensor
G32
5 A
Seat belt not fastened warning lamps
G33
5 A
Electrochromatic rear view mirror
G34
20 A
Sunroof (saloon)
G35
5 A
Passenger door lighting - passenger door mirror adjustment
G36
30 A
Electric tailgate (tourer)
G37
20 A
Heated front seats
G38
30 A
Driver’s electric seat
G39
30 A
Passenger’s electric seat - HIFI amplifi er
G40
3 A
Trailer relay unit supply
FUSEBOX B
Fuse N°
Rating
Function
G36
15 A
6 speed automatic gearbox
5 A
4 speed automatic gearbox
G37
10 A
Daytime running lamps - Diagnostic socket
G38
3 A
ESP
G39
10 A
Hydraulic suspension
G40
3 A
STOP switch
Page 195 of 316
XI
193
PRACTICAL INFORMATION
FUSEBOX C
Fuse N°
Rating
Function
F1
15 A
Rear screen wipe (Tourer)
F2
30 A
Locking and deadlocking relay
F3
5 A
Airbags
F4
10 A
Automatic gearbox - additional heater unit (Diesel) - electrochrome rear view mirror
F5
30 A
Front window - sunroof - passenger door lighting - passenger door mirror adjustment
F6
30 A
Rear window
F7
5 A
Vanity mirror lighting - Glove box lighting - interior lamps - torch (tourer)
F8
20 A
Radio - CD changer - Steering mounted controls - Screen - Under-infl ation detection -
Electric boot ECU
F9
30 A
Cigar lighter - front 12 V socket
F10
15 A
Alarm - Steering mounted controls, signalling and wiper controls
F11
15 A
Low current ignition switch
F12
15 A
Driver’s electric seat - instrument panel - seat belt not fastened warning lamps - air
conditioning controls
F13
5 A
Engine relay unit - Hydraulic suspension pump cut-off relay - airbag ECU supply
F14
15 A
Rain and sunshine sensor - parking sensors - passenger’s electric seat - trailer relay unit -
HIFI amplifi er ECU - Bluetooth system - Lane Departure Warning System
F15
30 A
Locking and deadlocking relay
F17
40 A
Heated rear screen - heated door mirrors
FSH
SHUNT
PARK SHUNT
Page 199 of 316
XI
!
197
PRACTICAL INFORMATION
Starting using another
battery
)
Lift the pins to remove the front
left headlamp cover (V6 HDi en-
gine).
)
Connect the red cable to the
positive terminal (+) of the fl at
battery A
, then to the positive ter-
minal (+) of the slave battery B
.
)
Connect one end of the green or
black cable to the negative ter-
minal (-) of the slave battery B
.
V6 HDi engine: the positive ter-
minal (-) is located under the red
cover.
)
Connect the other end of the green
or black cable to the earth point C
on the broken down vehicle.
)
Operate the starter, let the en-
gine run.
)
Wait until the engine returns to
idle and disconnect the cables.
Charging the battery using a
battery charger
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance with
regulations and must not, in any
circumstances, be discarded with
household waste.
Take used remote control batteries
and vehicle batteries to an autho-
rised collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not touch the clips during the
operation.
Do not lean over the batteries.
Disconnect the cables in the re-
verse order to connection, ensur-
ing that they do not touch.
Before disconnecting the battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if slight malfunctions
remain following this operation, con-
tact a CITROËN dealer or a qualifi ed
workshop.
Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
- the glass panoramic roof blind,
-
the GPS satellite navigation system.
)
Disconnect the battery from the
vehicle.
)
Follow the instructions for use
provided by the manufacturer of
the charger.
)
Reconnect starting with the neg-
ative terminal (-).
)
Check that the terminals and
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), remove them
and clean them.
Do not disconnect the battery to
charge it.
Page 200 of 316
XI
!
198
PRACTICAL INFORMATION
ENERGY ECONOMYMODE
System which manages the duration
of use of certain functions to con-
serve a suffi cient level of charge in
the battery.
After the engine has stopped, you can
still use functions such as the audio
and telematics system, windscreen
wipers, dipped headlamps, courtesy
lights, etc. for a maximum combined
duration of thirty minutes.
This period may be signifi cantly re-
duced if the battery charge is low.
Exiting economy mode
These functions are reactivated auto-
matically next time the vehicle is driven.
)
In order to resume the use of
these functions immediately, start
the engine and let it run for a few
minutes.
The time available will then be dou-
ble the duration for which the en-
gine was left running. However, this
time will always be between fi ve and
thirty minutes.
A fl at battery prevents the en-
gine from starting (refer to the
corresponding section).
TOWING THE VEHICLE
Procedure for having your vehicle
towed or for towing another vehicle
using a removable towing eye.
Access to the tools
The towing eye is installed in the
jack box placed in the spare wheel.
For access to it:
)
open the boot,
)
raise the fl oor,
)
remove the towing eye from the
jack box.
Switching to economy mode
Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the
active functions are put on standby.
If the telephone is being used at this
time:
- it will be maintained for fi ve min-
utes with hands-free kit of your
Audio system,
- it will be maintained for ten minutes
with your eMyWay.
