2012 Citroen C5 oil change

25

Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly (en-
gine oil, oil fi lter, air fi lter...) and observe
the schedule of operations recommend-
ed by the manufacturer.


When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid
any overfl ow.

At the wheel of your new vehicle,
it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see
the fuel consumption settle down to a
consistent average.

BLEEDING THE DIESEL FUEL
FILTER

Protective cover


Removing the cover


Bleeding water from the fuel
filter
Bleed regularly (at each oil change).
To bleed the water, slacken the bleed
screw or the water in diesel fuel sen-
sor, located at the base of the fi lter.
Continue until all the water has
fl owed out.
Then tighten the bleed screw or the
water detection sensor.

HDi 115, HDi 160 and V6 HDi 240
engines



)
Pull the protective cover upwards
to remove it.

HDi 140 engine



)
Remove the protective cover by
fi rst unclipping at 3
, then 1
and 4.

)
Unclip at 2
by pulling towards
you, then lift up.
Refi tting


)
Firstly clip in at 2
.

)
Lower and centre the cover.

)
Clip in at 3
and 4
, pushing verti-
cally and gently from the rear.

)
Clip in at 1
pushing vertically.


CHECKS
163
CHECKS

X
!
170
CHECKS






CHECKING LEVELS
















Oil level


The check is carried out either
when the ignition is switched
on using the oil level indicator
on the instrument panel, or
using the dipstick.
This manual check will only be cor-
rect if the vehicle is on level ground
and the engine has been off for more
than 30 minutes.
It is normal to top up the oil level be-
tween two services (or oil changes).
CITROËN recommends that you
check the level, and top up if neces-
sary, every 3 000 miles (5 000 kms).
After topping up the oil, the check
when switching on the ignition with
the oil level indicator in the instru-
ment panel is not valid during the
30 minutes after topping up.
If a level drops signifi cantly, have
the corresponding system checked
by a CITROËN dealer or a qualifi ed
workshop.
Check all of these levels regularly
and top them up if necessary, unless
otherwise indicated.

Take care when working under the
bonnet, as certain areas of the en-
gine may be extremely hot (risk of
burns).


Engine oil change
Refer to the servicing booklet for
details of the interval for this opera-
tion.
In order to maintain the reli-
ability of the engine and emis-
sion control system, the use
of additives in the engine oil is
prohibited.

Oil specifi cation
The oil must be the correct grade
for your engine and conform to the
manufacturer's recommendations.












Brake fluid level

The brake fl uid level should
be close to the "MAX" mark.
If it is not, check the brake
pad wear.

Changing the fl uid
Refer to the servicing booklet for de-
tails of the interval for this operation.

Fluid specifi cation
The brake fl uid must conform to the
manufacturer's recommendations
and meet the DOT4 standard.












Power steering or power
steering and suspension
fluid level
For topping up, it is necessary
to go to a CITROËN dealer or
a qualifi ed workshop.















Dipstick
There are two marks on
the dipstick:

A
= max; never exceed
this level,

B
= min; top up the oil
level via the oil fi ller cap,
using the correct grade of
oil for your engine.

X
!
171
CHECKS









Diesel additive level
(Diesel engine with particle
emission filter)

Topping up
This additive must be topped up by
a CITROËN dealer or a qualifi ed
workshop without delay.









Used products

Avoid prolonged contact of
used oil or fl uids with the skin.
Most of these fl uids are harmful to
health or indeed very corrosive.
Do not discard used oil or fl u-
ids into sewers or onto the
ground.
Take used oil to a CITROËN dealer
or a qualifi ed workshop (France) or
to an authorised waste disposal
site. The additive reservoir
low level is indicated
by fi xed illumination
of this warning lamp,
accompanied by an audible warning
and a message in the multifunction
screen.










Coolant level


The coolant level should be
close to the "MAX" mark but
should never exceed it.
When the engine is warm, the tem-
perature of the coolant is regulated
by the fan. This can operate with the
ignition off.

Changing the coolant
The coolant does not have to be
changed.

Fluid specifi cation
The coolant must conform to the
manufacturer's recommendations.






For vehicles fi tted with a particle
emissions fi lter, the cooling fan may
continue to run after stopping the
vehicle, even if the engine is cold.

In addition, as the cooling system is
pressurised, wait at least one hour
after switching off the engine before
carrying out any work.
To avoid any risk of scalding, unscrew
the cap by two turns to allow the pres-
sure to drop. When the pressure has
dropped, remove the cap and top up
the level.






















Screenwash and headlamp
wash fluid


In the case of vehicles fi tted
with headlamp washers, the
low fl uid level is indicated
by an audible signal and a
message in the screen.
Top up the reservoir when you next
stop the vehicle.

Fluid specifi cation
For optimum cleaning and to avoid
freezing, this fl uid must not be
topped up with or replaced with plain
water.



Reservoir capacity (depending on
version).


- screenwash fl uid: approximately
3.5 litres,

- screenwash and headlamp wash
fl uid: approximately 6.15 litres.

X
172
CHECKS






CHECKS












12 V battery

The battery does not re-
quire any maintenance.
However, check that the
terminals are clean and
correctly tightened, particu-
larly in summer and winter.
When carrying out work on the bat-
tery, refer to the "Practical information"
section for details of the precautions
to be taken before disconnecting the
battery and following its reconnection.










Particle filter system (Diesel)

Complementary to the catalytic con-
verter, this fi lter makes an active
contribution to the preservation of air
quality by trapping unburnt pollutant
particles. Black exhaust fumes are
thus no longer emitted.
After prolonged idling or driving at very
low speeds, you may occasionally no-
tice water vapour being emitted from
the exhaust when accelerating. This is
of no consequence to the running of
the vehicle or to the environment.
If there is risk of blockage, a mes-
sage appears in the instrument
panel screen, accompanied by an
audible signal and illumination of
the service warning lamp.
This alert tells you that the par-
ticle fi lter is approaching satura-
tion (in conditions of urban driving
of exceptionally long duration: low
speeds, traffi c jams etc.)
To regenerate the fi lter, it is advised
to drive as soon as possible, when
traffi c conditions permit, at a speed
of 40 mph (around 60 km/h) or
more for at least fi ve minutes (until
the alert message disappears).
If this alert persists, contact a CITROËN
dealer or a qualifi ed workshop.







The presence of this label, in particular
with the Stop & Start system, indicates
the use of a specifi c 12 V lead-acid bat-
tery with special technology and specifi -
cation. The involvement of a CITROËN
dealer or a qualifi ed workshop is essen-
tial when replacing or disconnecting the
battery.


Unless otherwise indicated, check
these components in accordance
with the servicing booklet and ac-
cording to your engine.
Otherwise, have them checked by
a CITROËN dealer or a qualifi ed
workshop.




















Air filter and passenger compartment filter


Refer to the servicing
booklet for details of the
replacement intervals for
these components.
Depending on the environ-
ment (e.g. dusty atmosphere) and
the use of the vehicle (e.g. city driv-
ing), replace them twice as often if
necessary
.
A clogged passenger compartment
fi lter may have an adverse effect on
the performance of the air condition-
ing system and generate undesirable
odours.

Replace the oil fi lter each
time the engine oil is
changed.













Oil filter

Refer to the servicing booklet for de-
tails of the replacement interval for
this component.

X
!
173
CHECKS





















Brake pads

Brake wear depends on
the style of driving, par-
ticularly in the case of ve-
hicles used in town, over
short distances. It may be
necessary to have the condition of
the brakes checked, even between
vehicle services.
Unless there is a leak in the circuit, a
drop in the brake fl uid level indicates
that the brake pads are worn.







Manual gearbox

The gearbox does not re-
quire any maintenance (no
oil change).






Automatic gearbox

The gearbox does not re-
quire any maintenance (no
oil change).

Brake disc wear

For information on checking
brake disc wear, contact a
CITROËN dealer or a quali-
fi ed workshop.


Parking brake

If a loss of effectiveness
of this system is noticed,
the parking brake must be
checked, even between
two services.
This system must be checked by a
CITROËN dealer.
Only use products recom-
mended by CITROËN or
products of equivalent quality
and specifi cations.
Do not use a dry cloth with an abra-
sive product for the maintenance of
aluminium parts; use a sponge and
soapy water.
In order to optimise the operation
of units as important as the braking
system, CITROËN selects and of-
fers very specifi c products.
To avoid damaging the electrical
units, the use of a high pressure
washer in the engine compartment
is strictly prohibited
. Refer to the servicing booklet for the
details of the level checking interval
for this component.
Refer to the servicing booklet for de-
tails of the level checking interval for
this component.