2012 Citroen BERLINGO FIRST Owner's Manual

87 PRACTICAL INFORMATION
-

Third brake lamp (tailgate)
(W 5 W)


)
With the tailgate open, unscrew
the two nuts.

)
Unclip the carrier for access to
the bulbs.

)
Change the failed bulb.



Third brake lamp (left rear
door) (W5W)


)
Remove the housing cover by
pressing the tab A
(round section)
at the end of the lamp.

)
Pull the housing cover rear-
wards.
)
Squeeze the two tabs B
to re-
move the bulb holder.

)

Pull out the failed bulb and change it.

To refi t, proceed in the reverse order.

PRACTICAL INFORMATION
88 -

Removing and fi tting a fuse
Before changing a fuse, the cause
of the fault must be found and reme-
died. The fuse numbers are indicated
on the fusebox.
Use the tweezer B
.
CHANGING A FUSE

The fuseboxes are located under the
dashboard and in the engine com-
partment.

Dashboard fusebox

Unclip the cover to gain access to the
fuses.
The spare fuses and the tweezer B

are fi tted to the inside of the cover A
.
Good


Failed


Tweezer B



Always replace a failed fuse with a fuse
of the same rating (two fuse types ac-
cording to manufacturer - see images).

89 PRACTICAL INFORMATION
-


Fuse N°



Rating



Functions




1



15A

Rear wiper.


4



20A

Multifunction screen - Instrument panel -
Audio system - Steering mounted controls.


5



-

Not used.


6



10A

Diagnostic socket.


7



-

Not used.


9



30A

Heated seats.


10



40A

Rear window and door mirrors demisting.


11



15A

Rear wiper (tailgate).


12



30A

Front electric windows.


14



10A

Engine fusebox - Steering mounted controls.


15



15A

Instrument panel - Multifunction screen -
Audio system.


16



30A

Locking/unlocking controls for doors,
bonnet and boot.


20



10A

Right-hand brake lamp.


21



15A

Left-hand brake lamp.


22



20A

Front courtesy lamp - Map reading lamp -
Cigarette lighter - Electric mirror.

PRACTICAL INFORMATION
90 -

The electrical system of your vehicle is designed to operate with standard or optional equipment.
Before installing other electrical equipment or accessories in your vehicle, consult a CITROËN dealer.
Some electrical accessories or the way in which they are fi tted may have an adverse effect on the operation of your
vehicle (its electronic control circuits, the audio system and the electrical charging circuit).
CITROËN declines any responsibility for expenses incurred through the repair of your vehicle or for any malfunctions
resulting from the installation of auxiliary accessories, not supplied and not recommended by CITROËN and not installed in
accordance with its instructions, in particular for any equipment the power consumption of which exceeds 10 milliamps.
The maxi fuses provide additional protection for the electrical systems. Any work on these fuses must be carried out by a
CITROËN dealer.

91 PRACTICAL INFORMATION
-


Fuse N°



Rating



Functions




1



10A

Pre-heater unit (Diesel) - Brake and clutch
switches - Reversing lamps.


2



15A

Fuel pump.


3



10A

ABS control unit.


4



10A

Engine control unit.


5



-

Not used.


6



15A

Front foglamps.


7



20A

Headlamp wash pump.


8



20A

Fan assembly relay -
Engine control unit.


9



15A

Left-hand dipped beam.


10



15A

Right-hand dipped beam.


11



10A

Left-hand main beam.


12



10A

Right-hand main beam.


13



15A

Horn.


14



10A

Front and rear screen wash pumps.


15



30A

Oxygen sensor - Air
fl ow sensor.


16



30A

Air pump relay.


17



30A

Front windscreen wiper.


18



40A

Air conditioning fan.


Engine compartment fusebox

To gain access to the box in the en-
gine compartment (next to the bat-
tery), unclip the cover.
After carrying out work, close the
cover carefully to ensure its sealing.

PRACTICAL INFORMATION
92 -
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the "accessories" position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment, etc.) can only be
used for a combined duration of ap-
proximately thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multi-function
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then
be double the duration for which the
engine is left running. However, this
period will always be between fi ve
and thirty minutes.
BATTERY

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.



Before disconnecting the bat-
tery, you must wait 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Close the windows and the roof before
disconnecting the battery.
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight diffi culties are experienced af-
ter this, please contact a CITROËN
dealer.

A fl at battery prevents the
engine from starting.
To start the vehicle from
another battery:


- Connect the red cable to the posi-
tive (+) terminals of the two bat-
teries,

- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,

- Connect the other end of the
green or black cable to an earth
point on the broken down vehi-
cle as far as possible from the
battery (for example, right-hand
engine mounting).
Operate the starter, let the engine run.

Wait for the engine to return to idle,
then disconnect the cables.

To charge the battery using a
battery charger:


- Disconnect the battery,

- Follow the instructions for use
given by the battery charger man-
ufacturer,

- Reconnect starting with the nega-
tive (-) terminal,

- Check that the terminals and
connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them.

93 PRACTICAL INFORMATION
-

Making the connections
A1: -
A2: - Digital control (manufacturer)
A3: - Digital control (manufacturer)
A4: - Audio equipment multiplexing
(manufacturer)
A5: -
A6: (+) Accessories
A7: (+) Permanent
A8: (-) Earth
B1: (+) -
B2: (-) -
B3: (+) Front right speaker and
tweeter
B4: (-) Front right speaker and tweeter
B5: (+) Front left speaker and tweeter
B6: (-) Front left speaker and tweeter
B7: (+)
B8: (-)

FITTING SPEAKERS

The factory-fi tted equipment allows
the fi tting of:


- 35 mm diameter tweeters in the
fascia,

- 165 mm diameter speakers in the
front doors.


FITTING AUDIO EQUIPMENT

Your vehicle is equipped with certain
factory-fi tted audio equipment:


- roof aerial,

- coaxial aerial cable,

- basic interference suppression,

- supply to front speakers and
tweeters,

- two 8-way connectors.
Contact a CITROËN dealer
before fi tting audio equipment
or speakers in your vehicle.

PRACTICAL INFORMATION
94 -
SNOW SCREEN *

The snow screen is installed on the
lower part of the front bumper to pre-
vent the accumulation of snow at the
radiator cooling fan.
Remove the snow screen:


- when the exterior temperature is
higher than 10 °C,

- when towing,

- for speeds higher than 75 mph
(120 km/h).


FITTING



)
Offer up the snow screen facing
the front bumper.

)
Put it in place positioning the lower
clips A
in the bumper.

)
Press the snow screen at each
upper clip B
.



REMOVAL



)
Press the two upper clips B
and
pull the snow screen.


*
As an accessory or according to country.