2012 CADILLAC ESCALADE ESV Owners Manual

Black plate (3,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
In Brief 1-3A. Air Vents on page 8 ‑ 7 .
B. Turn and Lane ‐ Change Lever.
See Turn and Lane-Change
Signals on page 6 ‑ 7 .
Windshield Wiper/Washer on
page 5 ‑ 4 .
C. Instrument Cluster on
page 5 ‑ 11 .
D. Hazard Warning Flashers on
page 6 ‑ 7 .
E. Shift Lever. See Automatic
Transmission on page 9 ‑ 30 .
Driver Shift Control (DSC).
See Manual Mode on
page 9 ‑ 33 .
F. Tow/Haul Mode on page 9 ‑ 33 .
G. Driver Information Center (DIC)
Buttons. See Driver Information
Center (DIC) on page 5 ‑ 23 .
H. Clock on page 5 ‑ 7 . I. Infotainment on page 7 ‑ 2 .
J. StabiliTrak ®
System on
page 9 ‑ 37 .
Rear Park Aid Disable Button.
See Ultrasonic Parking Assist
on page 9 ‑ 44 .
K. Steering Wheel Adjustment on
page 5 ‑ 2 .
L. Exterior Lamp Controls on
page 6 ‑ 1 .
M. Dome Lamp Override.
See Dome Lamps on page 6 ‑ 9 .
Instrument Panel Illumination
Control on page 6 ‑ 8 .
Fog Lamps on page 6 ‑ 8 .
N. Data Link Connector (DLC)
(Out of View). See Malfunction
Indicator Lamp on page 5 ‑ 16 .
O. Automatic Transfer Case
Control (Hybrid only). See the
hybrid supplement for more
information. P. Cruise Control on page 9 ‑ 41 .
Heated Steering Wheel on
page 5 ‑ 4 (If Equipped).
Q. Horn on page 5 ‑ 4 .
R. Steering Wheel Controls on
page 5 ‑ 2 .
S. Dual Automatic Climate Control
System on page 8 ‑ 1 .
T. Pedal Adjust Button. See
Adjustable Throttle and Brake
Pedal on page 9 ‑ 22 .
Power Assist Steps on
page 2 ‑ 12 (If Equipped).

Black plate (4,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
1-4 In Brief
Initial Drive
Information This section provides a brief
overview about some of the
important features that may or may
not be on your specific vehicle.
For more detailed information, refer
to each of the features which can be
found later in this owner manual.
Remote Keyless Entry
(RKE) System The RKE transmitter is used to
remotely lock and unlock the doors
from up to 60 m (195 ft) away from
the vehicle. Press
K to unlock the driver door.
Press
K again within three seconds
to unlock all remaining doors.
Press
Q to lock all doors.
Lock and unlock feedback can be
personalized. See Vehicle
Personalization on page 5 ‑ 38 .
Press and hold
8 to open or
close the liftgate.
Press and hold
m to open the
liftglass. Press
L and release to locate the
vehicle.
Press
L and hold for
three seconds to sound the panic
alarm.
Press
L again to cancel the panic
alarm.
See Keys on page 2 ‑ 2 and Remote
Keyless Entry (RKE) System
Operation on page 2 ‑ 3 .
Remote Vehicle Start With this feature the engine can be
started from outside of the vehicle.
Starting the Vehicle 1. Aim the RKE transmitter at the
vehicle.
2. Press and release
Q .
3. Immediately after completing
Step 2, press and hold
/ until
the turn signal lamps flash.

Black plate (5,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
In Brief 1-5When the vehicle starts, the parking
lamps will turn on and remain on
as long as the engine is running.
The doors will be locked and the
climate control system may
come on.
The engine will continue to run for
10 minutes. Repeat the steps for a
10-minute time extension. Remote
start can be extended only once.
Canceling a Remote Start To cancel a remote start: .
Aim the RKE transmitter at the
vehicle and press and hold
/until the parking lamps turn off. .
Turn on the hazard warning
flashers. .
Turn the ignition on and then
back off.
See Remote Vehicle Start on
page 2 ‑ 5 . Door Locks There are several ways to lock and
unlock the vehicle.
From outside, use the Remote
Keyless Entry (RKE) transmitter or
the key in the driver door.
From inside, use the power door
locks or the manual door locks.
To lock or unlock the door with the
manual locks, push down or pull up
on the manual lock knob.
Power Door Locks Press
Q or
K on the RKE
transmitter. See Remote Keyless
Entry (RKE) System Operation on
page 2 ‑ 3 . Premium Trim Shown,
Up ‐ Level Similar
Q : Press to lock the doors.
K : Press to unlock the doors.
See Door Locks on page 2 ‑ 7 .

Black plate (6,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
1-6 In Brief
Liftgate
The liftglass or liftgate cannot be
opened if the rear wiper is in motion.
Attempting to open the liftglass or
liftgate while the rear wiper is in
motion will cause the release of the
liftglass or liftgate to delay until the
wipers are parked off the liftglass. Manual Liftgate Operation To unlock the liftgate, press
" on
the power door lock switch or
press
" on the Remote Keyless
Entry (RKE) transmittertwice, see
Remote Keyless Entry (RKE)
System Operation on page 2 ‑ 3 .
Press the touch pad on the
underside of the liftgate handle (B)
and lift up.
Use the pull cup to lower and close
the liftgate. Do not press the touch
pad while closing the liftgate.
This will cause the liftgate to be
unlatched. Power Liftgate Operation On vehicles with a power liftgate,
the switch is on the overhead
console.
The vehicle must be in P (Park) to
use the power feature. The taillamps
will flash and a chime will sound
when the power liftgate moves.
There are several ways to open and
close the power liftgate: .
Press and hold
8 on the
RKEtransmitter until the liftgate
starts moving. .
Press
8 on the overhead
console. .
Press
l on the bottom of the
liftgate next to the latch to close.

Black plate (7,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
In Brief 1-7Pressing a second time while the
liftgate is moving reverses the
direction.
To disable the power liftgate
function, press OFF on the liftgate
switch, see Liftgate on page 2 ‑ 9 .
Liftglass
If equipped, there are two ways to
open the liftglass: .
Press the button on the
underside of the license plate
applique (A). .
Press
m on the RKE
transmitter. Windows
Premium Trim Shown,
Up ‐ Level Similar
The driver door has switches
that control all windows, the
passengers door switch only
control that window. The power
windows work when the ignition is
in ON/RUN or ACC/ACCESSORY, or in Retained Accessory Power
(RAP). See Retained Accessory
Power (RAP) on page 9 ‑ 26 for more
information.
Press the switch to lower the
window. Pull the switch up to
raise it.
For more information, see: .
Windows on page 2 ‑ 18 . .
Power Windows on page 2 ‑ 19 .

Black plate (8,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
1-8 In Brief
Seat Adjustment
To adjust the seat: .
Move the seat forward or
rearward by sliding the control
forward or rearward. .
Raise or lower the front or rear
part of the seat cushion by
moving the front or rear of the
control up or down. .
Raise or lower the entire seat by
moving the entire control up
or down.
See Power Seat Adjustment on
page 3 ‑ 3 . Lumbar Adjustment
To adjust the lumbar support: .
Press and hold the front or rear
of the control to increase or
decrease lumbar support. .
Press and hold the top or bottom
of the control to raise or lower
the height of the support.
See Lumbar Adjustment on
page 3 ‑ 3 . Reclining Seatbacks
To adjust the seatback: .
Tilt the top of the control
rearward to recline. .
Tilt the top of the control forward
to raise.
See Reclining Seatbacks on
page 3 ‑ 4 .

Black plate (9,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
In Brief 1-9
Memory Features
The controls on the driver door are
used to program and recall memory
settings for the driver seat, outside
mirrors, power steering column, and
the adjustable throttle and brake
pedals. Storing Memory Positions
To save into memory:
1. Adjust the driver seat, including
the seatback recliner and
lumbar, both outside mirrors,
power steering column, and the
throttle and brake pedals.
See Power Mirrors on
page 2 ‑ 16 , Steering Wheel
Adjustment on page 5 ‑ 2 , and
Adjustable Throttle and Brake
Pedal on page 9 ‑ 22 .
Not all mirrors and adjustable
throttles and brake pedals will
have the ability to save and
recall their positions.
2. Press and hold “ 1 ” until
two beeps sound.
3. Repeat for a second driver
position using “ 2. ” To recall, press and release “ 1 ”
or “ 2. ” The vehicle must be in
P (Park). A single beep will sound.
The seat, outside mirrors, steering
column, and adjustable throttle and
brake pedals will move to the
positions previously stored for the
identified driver.
See Memory Seats on page 3 ‑ 5
and Vehicle Personalization on
page 5 ‑ 38 .
Easy Exit Positions
This feature can move the driver
seat rearward and the power
steering column up and forward to
allow extra room to exit the vehicle.
B : Press to recall the easy exit
positions. The vehicle must be
in P (Park).
See Memory Seats on page 3 ‑ 5
and Vehicle Personalization on
page 5 ‑ 38 .

Black plate (10,1)Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11
1-10 In Brief
Second Row Seats On vehicles with a 60/40 split bench
or buckets seats, the seatbacks
can be folded for additional cargo
space, or the seats can be folded
and tumbled for easy entry/exit to
the third row seats, if equipped.
On vehicles with bucket seats, the
seatbacks also recline.
See Second Row Seats on
page 3 ‑ 8 .
Third Row Seats On vehicles with third row seats,
the seatbacks can be folded, and
the entire seat can be tumbled or
removed from the vehicle.
For detailed instructions, see
Third Row Seats on page 3 ‑ 12 .Heated and Ventilated
Seats
The buttons are on the climate
control panel.
{ : Press to cool the entire seat.
+ : Press to heat the
seatback only.
z : Press to heat the seat and
seatback. Press the desired button once for
the highest setting. With each press
of the button, the seat will change to
the next lower setting, and then to
the off setting. Indicator bars next to
the symbol on the climate control
display show the selected setting:
three for high, two for medium, and
one for low.
See Heated and Ventilated Front
Seats on page 3 ‑ 7 .