.Familiarisation
13
Lighting
Ring A
Ring B
Raise or lower the lighting stalk passing thepoint of resistance; the corresponding directionindicators will flash for as long as the stalkremains in this position.
Direction indicators
Switching to "AUTO"
)Press the stalk down and release it.
Ring B: rear wiper
8087 Li
ghting off.
Automatic illumination of headlamps.
Sidelamps.
Dipped / main beam headlamps.
Rear
foglamp.
or
Front and rear
foglamps. P
ark.
Intermittent wipe.
Wash-wi
pe.
Stalk A: windscreen wipers
Wipers
Switching off "AUTO"
)Push the stalk up and return it to position "0".
113
"Motorway" function
Push the lighting stalk up or down, withoutpassing the point of resistance; thecorresponding direction indicators will flash
three times.
This function can be used at any speed, but it is par ticularly useful when changing lane on high-speed roads.
Seeing clearly
86
88
79
11
Practical information
163
Changing a bulb
Procedure for replacing a faulty bulb with a new bulb.
1
.Direction indicators (H21W amber).2.Dipped beam headlamps (H7-55W).3. Main beam headlamps (H1- 55W).4.Sidelamps (W5W).5.Foglamps (PSX24W).6.LED daytime running lamps.
Front lamps
The headlamps are fitted with polycarbonate glass with a protectivecoating: )do not clean them using a dry or abrasive cloth, nor with a detergent or solvent product, )
use a sponge and soapy water or apH neutral product, )
when using a high pressure washer on persistent marks, do not keep the lance directed towards thelamps or their edges for too long, so as not to damage their protectivecoating and seals, )
do not touch the bulb directly withyour fingers, use lint-free cloths.
Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of seriousburns). It is imperative to use only anti-ultraviolet(UV) type bulbs in order not to damage the headlamp.
Always replace a failed bulb with a new bulb with the same type andspecification.
