Page 69 of 284
4
Access
67
Remote control problem
Following disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle. ) First of all, use the key in the lock to unlock
or lock your vehicle. ) Then, reinitialise the remote control.
If the problem persists, contact a CITROËN
dealer as soon as possible.
Changing the battery
Battery ref.: CR1620 / 3 volts. Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition on). )
Press the closed padlock immediately for afew seconds. )
Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again. I
f the battery is flat, you are
informed by illumination of
this warnin
g lamp, an audible
signal and a message in the
multifunction screen.
Key reminder
Switching the vehicle off
)Immobilise the vehicle. )Turn the key fully towards you toposition 1 (Stop)
. )Remove the key from the ignition switch.
)
Unclip the casing using a coin at the notch. )
Slide the flat battery out of its location. )
Slide the new battery into its location
observing the original direction. ) Clip the casing. )
Reinitialise the remote control.
Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault.
If the key is left in the ignition switch, anaudible signal sounds when the driver's door is opened.
Page 75 of 284
4
Access
73
Activation
)Press button Afor more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an
audible signal.
Deactivation
)Press button Aagain for more than
two seconds.
A confirmation message appears on themultifunction screen, accompanied by an
audible signal.
Emergency control
Locking the front and rear passenger doors
)
Inser t the key in the lock, located on the edge of the door, then turn it one eighth of a turn
.
Locking the driver's door
)
Inser t the key in the lock, then turn it to theleft.
Unlocking the driver's door
)
Inser t the key in the lock, then turn it to theright.
Unlocking the front and rear passenger doors
)
Pull the interior door opening control.
In the event of a failure with the centrallocking system, you should disconnectthe battery to lock the boot and soensure the complete locking of thevehicle.
System which locks or unlocks the doors
mechanically in the event of a malfunction of
the battery or of the central locking.
Page 76 of 284
Access
74
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
Boot
- when the engine is running
, this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release
Unlocking
)Fold back the rear benchseat to gainaccess to the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate.
Closing
If the tailgate is not closed correctly:
Opening
-when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal anda message on the multifunction screen for a few seconds.
)
Lower the tailgate using the interior grab handle.
System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.
Page 134 of 284
Driving
132
Stop & Start The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
- with the 6-speed electronic
gearbox
system, at speeds below 5 mph (8 km/h),
when you press the brake pedal or put thegear lever in position N.
A time counter calculates thesum of the periods in STOP
mode during a journey. It rests
itself to zero every time the
ignition is switched on with thekey.
Special cases: STOP mode not available
STOP mode is not invoked when:
- the driver's door is open,
- the driver's seat belt is not fastened,
- the vehicle has not exceeded 6 mph(10 km/h) since the last engine start usingthe key,
- the engine is needed to maintain acomfortable temperature in the passenger compartment,
- demisting is active,
- some special conditions (battery charge,
engine temperature, braking assistance,ambient temperature...) where the engine isneeded to assure control of a system.
The "ECO"warning lamp flashes for
a few seconds then goes off.
This operation is per fectly normal.
Never refuel with the engine in STOPmode; you must switch off the ignition with the key.
For your comfor t, during parkingmanoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...
Page 136 of 284
Driving
134
Operating fault
In the event of a fault with the system, the
"ECO OFF"
switch warning lamp flashes thencomes on continuously.
Have it checked by a CITROËN dealer or aqualified workshop.
In the event o
f a fault in STOP mode, the
vehicle may stall. All of the warning lamps in the instrument panel come on. It is then
necessary to switch off the ignition and star t
the engine again using the key.
Maintenance
This system requires a battery with a specialspecification and technology (reference numbers available from a CITROËN dealer or a qualified workshop).
Fitting a battery not listed by CITROËN introduces the risk of malfunction of
the system.
Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting from automatic operation of STA R T m o d e .
The Stop & Star t system makes use of advanced technology. All workon this type of battery must be doneby a CITROËN dealer or a qualifiedworkshop.
Press the "ECO OFF"switch again.
The system is active again; this is con
firmed
by the switch warning lamp going off,accompanied by a message in the screen.
The system is reactivated automaticallyat every new star t using the key.
Reactivation
