2012.5 Citroen C3 PICASSO RHD Owner's Manual

6
Fittings
95
Mats
Removable carpet protection.



Refi tting

To refit the mat on the driver's side:)
position the mat correctly, )
refit the fixings by pressing, )
check that the mat is secured correctly.

Fitting
When fitting the mat for the first time, on the
driver's side use only the fixings provided in
the wallet attached.The other mats are simply placed on thecarpet.
Removal
To remove the mat on the driver's side: ) move the seat as far back as possible,)
unclip the fixings,)
remove the mat.

Ticket holder


To avoid any risk of jamming of the pedals:


- only use mats which are suited tothe fixings already present in thevehicle; these fixings must be used,

- never fit one mat on top of another.
The use of mats not approved byCITROËN may inter fere with access tothe pedals and hinder the operation of the cruise control / speed limiter. It is located at the top of the dashboard central
panel.
It can be used to hold toll or parking tickets.

Fittings
96























Rear interior fi ttings

They are located on the back of the front seats. Two boxes are available, located under the rear passenger footwells.
To open them, lift the lid using the cut-out. There is a cup holder located at the rear of thecentre console.
Storage boxes
Seat pockets
Cup holder

6
Fittings
97
Lift the catch to release the table and unfold it.


Aircraft style tables
Reading lamps are built into the back of the
front seats, behind the tables. With the ignition
on, they illuminate the top of the table without inconveniencing other passengers.
They are only accessible if the table isunfolded.) Press the button to switch the lamp on or off.
Individual reading lamps
Side blinds

Blinds are available for the side windows.
Pull the side blind longways by the tab to use it.
Always guide the blind slowly using the tab.
Do not place hard or heavy objects on the table. They could becomedangerous projectiles in the event of sharp braking or impact. As a safety precaution, if too much pressure is exer ted the table will fold downwards.

Fittings
98
) Lower the storage shelf. )
Press the flap opening control. )
Lower the flap. )
Check that the adjustable boot floor is in
the high position.) Load the objects from inside the boot.


Ski flap

Device for storing and transporting long
objects.
When unfolded, this provides a stora
ge area split into 2 sections, completing the storagespaces available at the rear of the vehicle.
Storage tray

6
Fittings
99


























Boot fi ttings
1.
Storage net on right-hand boot trim. 2.Open storage compar tments.3.Torch. 4.
Adjustable boot floor.
5. Carrier bag hook.
6.Securing rings. 7. Storage area under boot carpet.8.Rear parcel shelf.

Fittings
100
2-position adjustable boot
The two-position adjustable boot floor allows you to:
- maximise the volume of the boot,
- par tition the boot
(stowing the rear shelf...),
- obtain a flat floor from the boot opening to
the front seats, when the rear bench seat isin the folded and fully back position.

Placing the adjustable boot fl oor in the low position
)
Lift the adjustable boot floor by pulling on
the strap.) Move the adjustable boot floor rear wards
and then down, following the guides on
the sides.



Placing the adjustable boot fl oor in the high position
)Lift the adjustable boot floor by pulling the strap.)Move the adjustable boot floor rearwards
then up to its high position.
In the high position, the adjustable boot floor
allows stowing of the rear parcel shelf and
fragile objects.
The ad
justable boot floor is fitted with four stowing rings to secure your loads using the net
available as an accessory.
Ensure that your boot is empty beforehandling the adjustable boot floor.

6
Fittings
101
Hooks
The hooks can be used to hold shopping bags.
2-panel rear parcel shelf
The rear section is attached to the tailgate bytwo cords.
Removing the shelf
From the boot: )
unhook the two cords,)
pull the shelf towards you to unclip it, )
lift the shelf to remove it.


Refi tting the shelf
From the boot:)
position the shelf so that the two notches
are directly above the fixing pins, ) push the shelf towards the inside of the
vehicle to clip it in place,
) attach the two cords.
It can be stored under the ad
justable boot floor,if this is in its high position.

Fittings
102
3-panel rear parcel shelf
The front section is flexible, and the central andrear sections are rigid. The rear section is secured to the tailgate by
two cords.
Removing the shelf
From the boot: )unhook the two cords, )gently lift up the shelf to unclip it, )remove the shelf.

Refi tting the shelf
From the boot:)
position the shelf so that the two notches
are directly above the fixing pins, ) press gently on the shelf to clip it in place, )
attach the two cords.


It can be stored under the ad
justable boot floor,
if this is in its high position.