Page 20 of 318

10KEYS AND DOORS
Keys
MS12023
Without wireless remote control system
MS12024
With wireless remote control system
These keys work in every lock. Your au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped pro-
fessional, will need one of them to make
a new key with a built−in transponder
chip.
A transponder chip for the engine immobi-
lizer system hasbeen placed in the head
of the keys. These chips are needed to
enable thesystem to function correctly, so
be careful not to lose these keys. If you
make your own duplicate key, you will not
be able to cancel the system or start the
engine.Since the side doors and back door can
be locked without a key, you should al-
ways carry a spare key in case you acci-
dentally lock your keys inside the vehicle.
When bringing a wireless remote control
key onto an aircraft, make sure you do
not press any buttons on the wireless re-
mote control key while inside the aircraft
cabin. If you are carrying a wireless re-
mote control key in your bag etc., ensure
that the buttons are not likely to be
pressed accidentally. Pressing a button
may cause the wireless remote control
key to emit radio waves that could inter-
fere with the operation of the aircraft.
AYGO WE 99E37E11 02.18
Page 21 of 318
KEYS AND DOORS11
MS12025
NOTICE
When using a key containing a trans-
ponder chip, observe the following
precautions:
zWhen starting the engine, do not
use the key with a key ring resting
on the key grip and do not press
the key ring against the key grip.
Otherwise the engine may not start,
or may stop soon after it starts.
MS12026
zWhen starting the engine, do not
use the key with other transponder
keys around (including keys of oth-
er vehicles) and do not press other
key plates against the key grip.
Otherwise the engine may not start,
or may stop soon after it starts. If
this happens, remove the key once
and then insert it again after remov-
ing other transponder keys (includ-
ing keys of other vehicles) from the
ring or while gripping or covering
them with your hand to start the
engine.
AYGO WE 99E37E11 02.18
Page 23 of 318

KEYS AND DOORS13
Engine immobilizer system
MS12029
The engine immobilizersystem is a
theft prevention system. When you in-
sert the key in the engine switch, the
transponder chip in the key’s head
transmits an electronic code to the ve-
hicle. The engine will start only when
the electronic code in the chip corre-
sponds to the registered ID code for
the vehicle.
Never leave the keys inside the vehicle
when you leave the vehicle.
The system is automatically set when ei-
ther of the following conditions applies.
DWhen the engine switch is turned from
the “ACC” to the “LOCK” position.
DWhen 20 seconds have elapsed since
the engine switch is turned from the
“ON” to the “ACC” position.
After opening the driver ’s door, inserting
the registered key in the engine switch
and turning it to the “ACC” position auto-
matically cancel the system, which en-
ables the engine to start.
The system is maintenance−free.
For your authorized Toyota dealer or work-
shop, or another duly qualified and
equipped professional, to make you a new
key with a built−in transponder chip, they
will need your key number and key. How-
ever, there is a limit to the number of
additional keys that can be made for you.If you make your own duplicate key,
you will not be able to cancel the sys-
tem or start the engine.
NOTICE
Do not modify or remove the system.
If modified or removed, the proper
operation of the system cannot be
guaranteed.
AYGO WE 99E37E11 02.18
Page 40 of 318

30KEYS AND DOORS
Power windows
MS12016a
The windows can be operated with the
switch on each side door.
The engine switch must be in the “ON”
position.
OPERATING THE WINDOWS
Use the switches on the driver ’s and
front passenger ’s doors.
The window moves as long as you hold
the switch.
To open: Push down the switch.
To close: Pull up the switch.
CAUTION
To avoid death or serious injury, you
must do the following.
DBefore you close the power win-
dows, always make sure there is
nobody around the power windows.
You must also make sure the
heads, hands and other parts of the
bodies of all occupants are kept
completely inside the vehicle. If
someone’s neck, head, hands or
other parts of the body get caught
in a closing window, it could result
in death or serious injury. When
anyone closes the power windows,
make sure he or she operates the
windows safely.
DWhen small children are in the ve-
hicle, never let them use the power
window switches without supervi-
sion.
DBe sure to remove the key or turn
the engine switch to the “LOCK”
position when you leave your ve-
hicle.
DNever leave anyone (particularly a
small child) alone in your vehicle,
especially with the key still in-
serted. Otherwise, he/she could use
the power window switches and get
trapped in a window. Unattended
people (particularly small children)
could be involved in serious acci-
dent.
AYGO WE 99E37E11 02.18
Page 47 of 318
KEYS AND DOORS37
MS12030c
protector
Removing the support rod
Hold the support protector area, and
remove the support rod from the clip
as shown in the illustration.
CAUTION
Hold the support protector area to
prevent scalding.
MS12033a
Move the support rod as shown in the
illustration.
CAUTION
When detaching the support rod from
the clip take care to prevent hands or
arms from being hit against the in-
side of the engine hood. Failure to do
so many result in injury.
AYGO WE 99E37E11 02.18
Page 49 of 318
KEYS AND DOORS39
MS12036
1. To open the fuel filler door.
When refueling, turn off the engine.
CAUTION
Do not smoke, cause sparks or allow
open flames when refueling. The
fumes are flammable.
MS12014d
2. To remove the fuel tank cap, insert
the key and turn it counterclockwise
by 45 degrees (to point 1), and then
turn it clockwise by 45 degrees (to
point 2). Remove the key.
If the fuel tank cap can not be re-
moved, perform the above operations
again.
AYGO WE 99E37E11 02.18
Page 63 of 318

OCCUPANT RESTRAINT SYSTEMS53
NOTICE
Do not perform any of the following
changes without consulting any
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional. Such changes
can interfere with proper operation of
the seat belt pretensioners in some
cases.
zInstallation of electronic devices
such as an RF−transmitter, cassette
tape player or compact disc player
zRepairs on or near the front seat
belt retractor assemblies
zModification of the suspension sys-
tem
zModification of the front end struc-
ture
zAttachment of a grille guard (bull
bar, kangaroo bar, etc.), snowplow,
winches or any other equipment to
the front end
zRepairsmadeonornearthefront
fenders, front end structure or con-
sole
MS13089
This indicator comes on when the en-
gine switch is turned to the “ON” posi-
tion. It goes off after about 6 seconds.
This means the seat belt pretensioners
are operating properly.
This warning light system monitors the
airbag sensor assembly, side airbag
sensors, side and curtain shield airbag
sensors, airbag manual on−off switch, seat
belt pretensioner assemblies, inflators,
warning light, interconnecting wiring and
power sources. (For details, see “Service
reminder indicators and warning buzzers”
on page 127 in Section 1−6.)
If any of the following conditions occurs,
this indicates a malfunction of the airbags
or seat belt pretensioners. Contact any
authorized Toyota dealer or repairer, or
another duly qualified and equipped
professional, as soon as possible.
DIf any front seat belt does not retract
or cannot be pulled out due to a mal-
function or activation of the relevant
seat belt pretensioner.
DThe seat belt pretensioner assembly or
surrounding area has been damaged.
The airbag manual on−offswitchisinthe
“ON” position:
DWhen the engine switch is turned to
the “ON” position, the light comes on
for more than 6 seconds and then
flashes.
AYGO WE 99E37E11 02.18
Page 64 of 318

54OCCUPANT RESTRAINT SYSTEMS
DWhen the engine switch is turned to
the “ON” position, the light either re-
mains off or flashes.
DWhile driving the vehicle, the light
flashes.
The airbag manual on−offswitchisinthe
“OFF” position:
DWhen the engine switch is turned to
the “ON” position, the light comes on
for more than 6 seconds and then goes
off or flashes.
DWhen the engine switch is turned to
the “ON” position, the light remains off
or flashes without illuminating for more
than 6 seconds.
DWhile driving the vehicle, the light goes
off or flashes.
MS13001
In the following cases, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional,
as soon as possible:
DThe front of the vehicle (shaded in the
illustration) was involved in an accident
that was not severe enough to cause
the seat belt pretensioners to operate.
DEither seat belt pretensioner assembly
or surrounding area is scratched,
cracked, or otherwise damaged.
AYGO WE 99E37E11 02.18