2011 Seat Alhambra Owner's Manual

127
Seats and storage compartments
Folding down rear seats to create load space Fig. 89 Second row of seats: folding the rear seat
A ,
re ar se
at as load space B .
Fig. 90 Third row of seats: fold down the rear seat to
loa
d A then return to position
B .
Each rear seat can fold down individually to extend the luggage compart-
ment. Safety First Operating instructions Practical tips Technical Data

128
Seats and storage compartments
Folding the seats in the second row of seats for loading
●If necessary, open the belt loop and wind up the seat belt by hand.
● If it is necessary, remove the head rests on the integrated child seats
then rein s
talled the integrated child seats ⇒ page 46.
● If necessary, raise the armrests.
● Remove objects from the footrest area in front of and behind the rear
seat ⇒  .
● Move the rear seat all the way back.
● Push the head restraint down as far as it will go ⇒ page 10.
● In the mid

dle seat, close the drinks carrier in the rear of the centre con-
sole, if
necessary.
● Pull lever ⇒ fig. 89 1 back and fold the backrest forwards. The com-
pl et

e rear seat folds forward ⇒  .
● Fold the backrest forwards until it locks into the load surface position
B .
● If necessary, pull on the lever ⇒ fig. 90 2 to move the seat to the re-
quired po s

ition.
● When the seat is folded down, no adults or children should travel in it
⇒  .
Fo l

ding the seats in the third row of seats for loading
● If necessary, open the belt loop and wind up the seat belt by hand.
● Open the tailgate.
● Push the head restraint down as far as it will go ⇒ page 10.
● R

emove objects from the footrest area in front of and behind the rear
seat ⇒  .
● Remove objects from the space below the rear seat.
● Remove the attachment elements and supports for the net from the rail
sys t

em.
● Pull lever 1 back and fold the backrest forwards. The rear seat folds for-
war d

⇒  and the cushion also moves forward. ●
Fold the seat tray forward on top of the folded seat.
● When the se at

is folded down, no adults or children should travel in it
⇒  .
Puttin g the se

ats in the second row back in place
● Pull lever ⇒ fig. 89 1 upwards and place the seatback in vertical posi-
tion. The entir e se

at folds backwards.
● Pull on the rear seats and the backrest to ensure that they are correctly
locked in p
lace and that the safety belt protection is guaranteed for rear
seat passengers.
Putting the seats in the third row back in place
● Open the tailgate.
● Pull on the handle ⇒ fig. 90 2 to put the seat tray back in position.
● Pull on the handle 3 . The entire seat folds backwards.
● Press on the seat tray in the backrest until it is held in position by its
magnets.
● Open the s lidin

g door.
● Put the backrest into position and press firmly until it clicks into place.
● Pull on the rear seats and the backrest to ensure that they are correctly
locked in p
lace and that the safety belt protection is guaranteed for rear
seat passengers. WARNING
Folding and lifting the rear seats carelessly without paying attention
cou l

d cause serious injury.
● Never fold or lift the seats while driving.
● Do no trap or damage seat belts when raising the backrest.
● Keep your hands, fingers, feet and other body parts out of the hinges
and the seat loc
king mechanism when folding and unfolding. 

129
Seats and storage compartments WARNING (Continued)
● Mats or other objects can be caught in the hinges of the backrests or
r e
ar seat. This could prevent the seat or backrest from locking securely in
the vertical position.
● All backrests must engage correctly for the seat belts on the rear
seats
to work properly. When the backrest of an occupied seat is not cor-
rectly locked in place, the passenger can be thrust forward with the back-
rest in case of sudden braking, sudden manoeuvres or an accident.
● No seat must be occupied if the backrest or seat is folded or not cor-
rectly en
gaged. CAUTION
● Before folding the backrest of the rear seat, adjust the front seats so
th at

the head restraint or backrest do not hit them when it is folded.
● Objects placed in the footrest area in front of and behind the rear seats
can be dam
aged when seats are folded down or put back into position. Re-
move any objects in the way before folding seats down or repositioning
them. ●
Objects placed in the moulding on the back of the third row of seats can
be dam
aged when folding down the seats or putting them back into posi-
tion. Remove any objects in the way before folding seats down or reposi-
tioning them.
● The attachment elements and supports for the net partition placed on
the rail
system can be damaged when folding down seats from the third row
or putting them back into position and these can also damage the seats
themselves. Before folding down or repositioning the seats, remove the at-
tachment elements and supports for the net from the rail system. Safety First Operating instructions Practical tips Technical Data

130
Seats and storage compartments
Rear shelf* Fig. 91 In the luggage
comp
ar
tment: rear shelf. Fig. 92 Remove the shelf supports
A then put them
aw a

y safely B .
The rear shelf can be fitted behind the second or third row of seats ⇒  .
Opening the shelf
●
Pull the shelf handle ⇒ fig. 91 A backwards.
● Release the shelf upwards by the side supports and guide it forward. 

131
Seats and storage compartments
Closing the shelf
● Pull the unfolded shelf evenly on the guide backwards.
● Secure the shelf using the left and right side supports.
Ins t
alling the shelf behind the second row of seats
● Place the shelf in its position in the side lining, left-hand side first.
● Release the shelf in the direction of the arrow B .
● Insert the shelf into the right-hand support, pressing down.
Ins t

alling the shelf behind the third row of seats
● Remove the shelf from the support in the side lining ⇒ fig. 92 A . To do
this, pr e

ss the shelf upwards (arrow) and remove it.
● Open the compartment in the left-hand side rear lining ⇒ page 141 and
hook
the shelf to the rear of the luggage compartment cover B .
● Close the rear left-hand side lining compartment.
● Place the shelf in its position in the side lining, left-hand side first.
● Lift the shelf off in direction of the arrow ⇒ fig. 91 B .
● Insert the shelf into the right-hand support, pressing down.
Remo v

ing the shelf
● Release the shelf in the direction of the arrow B and lift it in the direc-
tion of the arr o

w C .
● Remove the shelf from the right-hand side support. ●
Also, when removing from behind the third row of seats: Co
ver the side-
lining supports with their covers.
● Only with 5 places: Suppor
t the released shelf by placing it on the front
section of the luggage compartment floor ⇒ page 141. WARNING
If the shelf is placed on one of the rear seats, this could cause serious
injury in c

ase of sudden braking or an accident.
● Whenever it the third row seats are occupied, the shelf should be put
behind this r
ow. WARNING
Unsecured or incorrectly secured objects or animals on the rear shelf
cou l

d cause serious injuries in case of a sudden manoeuvre or braking or
even an accident.
● Do not leave hard, heavy or sharp objects (loose or in bags) on the
rear shelf
.
● Never transport animals on the rear shelf. 
Safety First Operating instructions Practical tips Technical Data

132
Seats and storage compartments
Net partition* Fig. 93 Unfold the net partition
1 then fold it again
2 and
3 .
Fig. 94 In the luggage
comp
ar
tment: Install the
net partition behind the
second row of seats.
The net partition can prevent objects in the luggage compartment entering
the pas
senger compartment / the driver area.
First remove the net from its bag and unfold it. Fold out the net partition
Fol

d out the support transversal rods ⇒ fig. 93 1 for the net partition fully
in the direction of the arr

ow until you hear a “click”.
Installing the net partition behind the second row of seats
● Hook in the net partition on the left-hand side roof support ⇒ fig. 94 A .
To do thi s, guide the r

od from up to down.
● Hook in the net partition on the rear right-hand side roof support by
pres
sing on the rod.
● Secure the net partition hooks into the straps in the front of the luggage
compar
tment B then tighten them.


133
Seats and storage compartments
Installing the net partition behind the front seats
● Hook in the net partition on the left-hand side roof support C . To do
this, guide the r od fr
om up to down.
● Hook in the net partition on the rear right-hand side roof support by
pres
sing on the rod.
● Secure the hooks of the net partition to the attachment rings in the left
and right hand s
ide foot rests on the second row of seats then tighten the
straps.
Removing the net partition
● Loosen the net partition straps.
● Release the net partition hooks from the rings B .
● Release the net partition from the right and left roof supports A or
C by pressing on the rod.
●
Unhook the net partition from the left-hand side roof support.
Fo l

ding in the net partition
● Press on the release button ⇒ fig. 93 2 and bend the rod
A in the di-
rection of the arr

ow with the release o button pressed.
● Press on the release button 3 and bend the rod
B in the direction of
the arro w w

ith the release button pressed.
● Store the net partition securely in the vehicle. WARNING
Loose objects in the passenger compartment can be violently thrown in
ca se of

a sudden manoeuvre or braking and especially in accidents caus-
ing serious injury.
● Ensure that the rods are correctly locked in place.
● Even when net partition is correctly fitted, objects must be secured.
● When driving with the net partition, no passengers should be behind
it. Fastening rings*
Fig. 95 In the luggage
comp
ar

tment: fastening
rings
To the front and rear of the luggage compartment, there are fastening rings
for securin
g objects ⇒ fig. 95 (arrows). On some models, the fastening rings
are all the way to the back on the lock carrier plate.
There are other fastening rings located to the left and right hand side of the
second row footrests.
Some models of fastening rings must be lifted to use them. WARNING
Unsuitable or damaged ropes or straps may be released in case of sud-
den brak in

g or an accident. As a result, objects may be fired through the
passenger compartment causing serious injury or death.
● Always use suitable ropes and straps in good condition.
● Secure the ropes and straps to the fastening rings. Safety First Operating instructions Practical tips Technical Data

134
Seats and storage compartments WARNING (Continued)
● Loose objects in the luggage compartment can suddenly slide and
c h
ange the way the vehicle handles.
● Secure all objects, little and large.
● Never secure a load that is too heavy for the fastening rings.
● Never secure a child seat to the fastening rings. Note
● The maximum load of the fastening rings is approximately 3.5 Kn (3.57
K p).
● Y

ou can find suitable transport straps and load securing systems at a
speci
alist workshop. SEAT recommends visiting a Technical Service. 
Rails and attachment system* Fig. 96 In the luggage
comp
ar

tment: System in-
cluding rails, adjustable
attachment elements 1 and adjustable tighten-
ing s
tr

aps 2 .
The rails and attachment system consists of four rails, movable attachment
elements, s tr

aps to be secured to the rails and a net with supports to cover baggage ⇒ page 135.

The rail and attachment system is designed to se-
cure light objects. If the seats in the third row are to be occupied by passen-
gers then attachment elements should never be placed in the section of the
rails close to the seats ⇒  .
Ins t

alling the attachment elements
● Fit the attachment element with the ruts facing upwards ⇒ fig. 96 1 to
the upper p ar

t of the guide and press downwards.
● Move the attachment element to the desired position.
● Always ensure that the attachment inserts into the guide system ⇒  .
Remo v

ing the attachment elements
● Remove the attachment element from the guide and pull downwards.
Securing a lo
ad
● Pull the strap through the attachment element and secure the load
⇒  .
WARNING
In case of an accident or sudden braking, the attachment elements in the
par t

s of the rails close to the seats of the third row could injure seat oc-
cupants.
● Whenever the seats on the third row are to be occupied, remove the
attachment
elements from the rails or move them all the way back. WARNING
Movable attachment elements that are not secured correctly can be re-
le a

sed from the guide in case of sudden braking or accident. As a result,
objects may be fired through the passenger compartment causing seri-
ous injury or death.
● Always ensure that the movable attachment elements are correctly in-
serted int
o the guides. 