1. Turn the ignition switch to the “LOCK” or
“ACC” position.
2. Repeatedly
depress the brake pedal until sig-
nificant resistance is felt (normally after
about 40 times).
3. Check the brake fluid level in the reservoir. The brake fluid level must be between the
“MAX” and “MIN” marks on the reservoir.
The fluid level falls slightly with wear of the brake
pads, but this does not indicate any abnormality.
If the brake fluid level falls markedly in a short
length of time, it indicates leaks from the brake sys-
tem.
If this occurs, we recommend you to have the vehi-
cle checked.
Fluid type
Use brake fluid conforming to DOT3 or DOT4
from a sealed container. The brake fluid is hygro-
scopic. Too much moisture in the brake fluid will
adversely affect the brake system, reducing the
brake performance. CAUTION
l
Take care
in
handling brake fluid as it is
harmful to the eyes, may irritate your
skin and also damage painted surfaces.
l Use only the specified brake fluid.
Do not mix or add different brands of
brake fluid to prevent chemical reactions.
Do not let any petroleum-based fluid
touch, mix with, or get into the brake fluid.
This will damage the seals. CAUTION
l
Keep the reservoir tank cap closed to pre-
vent the brake
fluid from deteriorating ex-
cept maintenance.
l Clean the filler cap before removing and
close the cap securely after maintenance. Clutch fluid*
E01001000193
To check the fluid level
The clutch fluid
in the master cylinder should be
checked when performing other underhood service.
In addition, the system should be checked for leak-
age at the same time.
Check to ensure that the clutch fluid level is always
between the “MAX” and “MIN” level markings on
the fluid reservoir.
LHD
RHD Maintenance
8-09 8
OBKE12E1
If the fluid level falls markedly in a short length of
time, it indicates leaks from the clutch system.
If this occurs,
we recommend you to have the vehi-
cle checked.
Fluid type
Brake fluid conforming to DOT 3 or DOT 4 should
be used.
The reservoir cap must be fully tightened to avoid
contamination from foreign matter or moisture.
DO NOT ALLOW PETROLEUM-BASED FLUID
TO CONTACT, MIX WITH, OR OTHERWISE
CONTAMINATE THE BRAKE FLUID. SEAL
DAMAGE WILL RESULT. WARNING
l Take
care
in
handling brake fluid as it is
harmful to the eyes, may irritate your
skin and also damage painted surfaces.
Wipe up any spills immediately. Power steering fluid
E01001100484
To check the fluid level
Check the fluid
level in the reservoir while the en-
gine is idling.
Check to make certain that the power steering fluid
level is always between the “MAX” and “MIN” lev-
el markings on the fluid reservoir and top up the flu-
id, if necessary. Fluid type
Use “Genuine
MITSUBISHI
Power Steering Flu-
id” or “ATF DEXRON III/DEXRON II”. Battery
E01001201772
The condition of
the battery is very important for
quick starting of the engine and proper functioning
of the vehicle’s electrical system. Regular inspec-
tion and care are especially important in cold weath-
er.
NOTE
l On vehicles equipped with 2 batteries, when
the batteries are replaced, the 2 batteries
should be replaced at the same time.
If only a battery is replaced, it will cause short-
ening of the batteries life.
Checking battery electrolyte level The electrolyte level must be between the specified
limit on the
outside of the battery. Replenish with
distilled water as necessary.
The inside of the battery is divided into several com-
partments; remove the cap from each compartment
and fill to the upper mark. Do not top up beyond
the upper mark because spillage during driving
could cause damage. Maintenance
8-10
8
OBKE12E1
Item 3-door models 5-door models
1 Front track 3000 models
—1,560 mm 3200 models, 3800 models
1,560 mm1,570 mm2 Overall width Without side protector moulding
1,845 mm— With side protector moulding
1,875 mm3 Front overhang
765 mm4 Wheel base
2,545 mm2,780 mm5 Rear overhang
1,075 mm1,355 mm6 Overall length
4,385 mm4,900 mm7 Ground clearance (unladen) 3000 models
—235 mm 3200 models
210 mm, 225 mm*1 3800 models
235 mm8
Overall height Without roof rails 3000 models
—1,870 mm 3200 models
1,840 mm, 1,850 mm*1
,
1,860 mm *2 1,860 mm, 1,870 mm
*1
,
1,880 mm *2 3800 models
1,850 mm1,870 mm9 With roof rails 3000 models
—1,900 mm 3200 models
1,870 mm, 1,880 mm*1
,
1,890 mm *2 1,890 mm, 1,900 mm
*1
,
1,910 mm *2 3800 models
1,880 mm1,900 mm10 Rear track 3000 models
—1,560 mm 3200 models, 3800 models
1,560 mm1,570 mmMinimum turning radius Body
5.7 m6.1 m Wheel
5.3 m5.7 m
*1 : Vehicles for Russia, Ukraine and Kazakhstan
*2 : Vehicles with only the front seats Specifications
9-05 9
OBKE12E1
