2011 JAGUAR XK center console

3
Opening the trunk
Engine start stop
TheSTART STOP button is operational only
when the Jaguar Smart Key is inside the
vehicle.
Ignition only on:
• A single press of the START STOP
button will switch on the ignition.
• A second press will switch off the ignition.
Engine start:
• With the footbrake depressed and the gear selector in Park, press and release the
START STOP button to start the engine.
The JaguarDrive Selector will rise from the
center console in readiness for gear selection.
• With the gear selector in Park, press the
button again to stop the engine and switch off
the ignition.
Cold climate starting
In extreme low temperatures, there may be a
delay of up to \f2 seconds between the START
STOP button being pressed and the engine
cranking. Ensure the footbrake remains
depressed. Do NOT press the START STOP
button again. Cranking time will be increased.
Operating note
The START STOP button must be pressed to stop
the engine. If not, it will continue to run even if the
Jaguar Smart Key is removed from the vehicle.
1. Press the release button indicated.
Front windows
The front windows can be fully opened or closed
with a single operation of the switch.
• To open a window, press the respective
switch briefly. Press the switch again to stop
the window from fully opening.
• To close a window, pull the switch up briefly. Pull the switch again to stop the window from
fully closing.Reminder Global closing
If a front window has been left open when leaving
the vehicle and global closing is enabled, press
and hold the Jaguar Smart Key lock button to close
them. Alternatively, press and hold the button on
the door handle.
2. Alternatively, press the button on the facia.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 31 2

When you have found your ideal driving
position, the vehicle can memorise the settings
for future use.
1.Press the Mbutton. The red LED will
illuminate for a five second period.
2. Press button 1,2, or \fto store your driving
position.
The LED will extinguish and a chime will sound
to confirm that the settings have been
memorised. If the ignition is on, the message
center will display a confirmation message.
5
Operating note
A seat position will only be memorised during the
five second period that the LED is illuminated.
An existing memory setting can be over\bwritten
with a new memory position.
Driving position memory
Recalling a seat position
To recall a memorised seat position simply
press and hold button 1,2, or \funtil the seat
has finished moving.
Convertible top
The vehicle must be stationary with the engine
running.
Note: The luggage separator MUST be in the
correct position before the top will retract.
• To open, press and hold the REAR of switch 1
in the overhead console.
An audible chime indicates start of opening.
Rear windows will open, the top unlatches and
starts to move. Front windows will fully lower.
When the process is complete another audible
chime will be given.
• Release the switch.
• To close, press and hold the FRONT of switch 1.
Convertible top operation
• DO NOT press the engine START STOP
button while the top is operating. Doing so will
cause the system to lose its position memory.
• DO NOT operate the top while the vehicle is in motion. Doing so may damage the top and/or its
operating mechanism.
• DO NOT open the trunk while the top is operating. This will cause the operation to stop.
Once again an audible chime is given and the
windows will lower before the roof moves back
into position. When the process is complete
another audible chime will be given.
• Release the switch.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 5 1

\f3
Connecting ports for portable iPod and USB
storage devices are located inside the center
console cubby box and can be operated from
the touch\bscreen. A dedicated iPod lead is
supplied with the vehicle.
Note:
All iPod generations are supported at this time.
The system will play PM3, WMA, WAV and AAC
files from a memory stick or a USB controlled
MP3 player or mobile phone.
Some MP3 players use proprietary file systems
that are not supported by the vehicle system.
MP3 players must be set to Removable Device
or Mass Storage Device mode (see the
manufacturer’s information). Only music files
added to the device in this mode can be played
via the vehicle system.
The vehicle system will support USB devices
with a storage capacity up to 256GB.Using the Portable Audio Interface
From theHomescreen, select Audiothen
Portable audio. Select USBoriPod.
When a device is connected, touch Foldersto
display all search methods such as Playlist,
artist, Albums etc.
Continue through the folders to find the music
you want to play. Use the arrow icons to scroll
through the list.
Touch and hold this icon to expand
details of music being played.
Pause/Play, Mix, Repeat and Seek
next/Previous are similar to CD use.
Portable Audio Interface iPod and USB
CD player
Press the LOADbutton and follow screen
instructions.
From the Homescreen, select Audiothen CD.
\f. Touch the required CD number icon \f to 6.
2. Touch to pause play. Touch again to restart.
3. Touch the next or previous icons to skip tracks or hold to move through a track.
4. Touch Mixto randomly play CD tracks. Hold
Mix to randomly play tracks from all CD’s.
5. Hold Repeatto repeat current CD. Touch to
repeat current track.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:24 Page 13 Audio
Sat Radio
CD
AM/FM
12:26 pm
iPod AUX
MixRepea tUSB
Set tings
Fol ders
P
TY DPLII
Tr 02
Por table audio
Diamo ndDogs
01:36 Audio
12:26pm
Tr
A rtist
M yipod
Album
Song
P la yli st
01
TP TA PTY DPLII
00:36 Audio
Sat Radio
CDAM/FM
Portable audio
MixR epeat S et tings
3
451
12:26 pm
2