Page 7 of 16
7
Facia
1.Direction indicators/exterior lighting/
trip computer
2. Instrument pack, warning indicators,
message center and turn by turn navigation
\f. Wiper/washers
4. Audio system
5. Touch\bscreen display
6. Hazard warning switch
7. Home screen button
8. Climate control system
9. Engine start/stop button
10. DSC/Trac switch
11. Automatic speed limiter12.Electric parking brake
1\f. Dynamic mode switch
14. Winter mode switch
15. Jaguar Drive Selector
16. Cruise control
17. Horn
18. Steering column adjuster
19. Audio/telephone controls
20. Rear fog lamps
21. Trunk release
22. Fuel filler flap release
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 71234567
8
16171820
21
22
9
10
11
14
13
15
12
19
Page 8 of 16
8
Driving
Exterior lighting\bTrip computer
1. Front screen wash/wipe.
2. AUTO/intermittent wipe.
\f. Slow speed.
4. Fast speed.
5. With position2selected, rotate the collar to
adjust speed of intermittent wipe or rotate to
AUTO to select auto wipe controlled by the
rain sensor.
Wipers and washers
Move the lever forward for high beam and back
for high beam flash. Move it up or down to
operate the direction indicators. A brief push up
or down will flash the indicators three times.
Rotate the collar to the first position to select
side lamps.
Second position is headlamps.
Next position is Autolamps. Sensor controlled
to switch side lamps and low beam
headlamps on or off as appropriate.
Autolamps combined with exit delay.
Headlamps can remain on to illuminate the
immediate vicinity for a set period after
leaving the vehicle. There are three time
setting positions. Press the button on the end of the lever to
cycle through the trip computer displays in
the message center.
Autolamps
If AUTO mode is selected and the front screen
wipers are operated for more than 20 seconds, the
exterior lamps will be switched ON automatically
for a minimum of two minutes.
Instrument pack warning lamps
Low tire pressure
Air bag fault
Rear fog lamp on
Flashing lamp \b
Dynamic Stability
Control (DSC) activeSeat belt reminder
Forward alert active
Automatic Speed Limiter
(ASL) active
ABS fault
Parking brake on or
system fault \b Canada
only
Parking brake on or
system fault \b USA only
Adaptive Cruise Control
active
Engine malfunction
The following lamps will illuminate during normal driving to indicate that a related system or feature is
operating. If any other warning lamp illuminates, refer to the Owner’s Handbook.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 81
2
3
4
5 BRAKE
Page 10 of 16
When a vehicle ahead enters the same lane as
you, or a slower vehicle is encountered in the
same lane, road speed will be adjusted to
maintain the currently selected gap.The warning lamp will illuminate to
indicate that the vehicle is in follow
mode.
ACCIS NOT a collision warning or avoidance
system. Additionally the system WILL NOTdetect:
• Stationary or slow moving vehicles below 6 mph (\f0 km/h).
• Pedestrians or objects in the roadway.
• Oncoming vehicles in the same lane.
Cruise (speed) control and ACC
1. SET \b use to set the road speed to be
maintained or increase/decrease the speed
in \f mph (2 km/h) steps when cruise control
is operating.
2. RESUME \b use to resume a set speed
retained in memory.
\f. CANCEL \b cancels cruise control but
retains the set speed in memory.
ACC only
4. GAP \b use to increase/decrease the time gap
to the vehicle ahead. The gap can be set to
one of four pre\bdefined settings, the largest
gap depicted by four chevrons.
The gap setting will be displayed in the
message center.
Dependent upon specification, your vehicle will be fitted with either the standard cruise control system or
the Adaptive \fruise \fontrol system (A\f\f). Both systems allow you to maintain a set speed until either
cruise control is cancelled or the brake pedal is used. A\f\f also allows you to maintain a gap between
yourself and the vehicle ahead when the speed of that vehicle is not greater than yours. Both systems are
controlled via switches on the steering wheel.
Cruise (speed) control and Adaptive Cruise Control
\f0
Driving
Cruise control will automatically disengage when
the foot brake is pressed or when the vehicle
speed falls below \f8 mph (28 km/h).
Forward alert
Forward Alert is a feature of the Adaptive \fruise \fontrol system. It provides limited detection and warning
of a vehicle in the road ahead.
1. Press to
activate.
The warning lamp in the instrument
pack will illuminate.There are four sensitivity settings and the
message center will confirm which setting is
selected. The setting can be changed by using
theGAP control (see 4above) while ACC is not
engaged.
The system will display warnings in the
message center even if ACC is not engaged.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:24 Page 101
2
4
3 1
