Page 266 of 386

What to do in an emergency
6 6
Jump starting procedure 1. Make sure the booster battery is 12-
volt and that its negative terminal is
grounded.
2. If the booster battery is in another
vehicle, do not allow the vehicles come
in contact.
3. Turn off all unnecessary electrical
loads.
4. Connect the jumper cables in the exact
sequence shown in the illustration.
First connect one end of a jumper
cable to the positive terminal of the
discharged battery (1), then connect
the other end to the positive terminal
on the booster battery (2).
5. Proceed to connect one end of the
other jumper cable to the negative ter-
minal of the booster battery (3), then
the other end to a solid, stationary,
metallic point (for example, the engine
lifting bracket) away from the battery
(4). Do not connect it to or near any
part that moves when the engine is
cranked.
Do not allow the jumper cables to con-
tact anything except the correct bat-
tery terminals or the correct ground.
Do not lean over the battery when
making connections.6. Start the engine of the vehicle with the
booster battery and let it run at 2,000
rpm, then start the engine of the vehi-
cle with the discharged battery.
If the cause of your battery discharging is
not apparent, you should have your vehi-
cle checked by an authorized HYUNDAI
dealer.
CAUTION- Battery cables
Do not connect the jumper cable
from the negative terminal of the
booster battery to the negative ter-
minal of the discharged battery.
This can cause the discharged bat-
tery to overheat and crack, releas-
ing battery acid.CAUTION-AGM battery
(if equipped)
• Absorbent Glass Matt (AGM) bat-
teries are maintenance-free and
should only be serviced by an
authorized HYUNDAI dealer. For
charging your AGM battery, use
only fully automatic battery
chargers that are specially devel-
oped for AGM batteries.
• When replacing the AGM battery,
use only the HYUNDAI genuine
battery for the ISG system.
• Do not open or remove the cap on
top of the battery. This may cause
leaks of internal electrolyte that
could result in severe injury.
• If the AGM battery is reconnected
or replaced, ISG function will not
operate immediately.
If you want to use the ISG func-
tion, the battery sensor needs to
be calibrated for approximately 4
hours with the ignition off.
procarmanuals.com
Page 281 of 386

621
What to do in an emergency
Notes on the safe use of the
TireMobilityKit
• Park your car at the side of the
road so that you can work with the
TireMobilityKit away from moving
traffic. Place your warning triangle
in a prominent place to make pass-
ing vehicles aware of your location.
• To be sure your vehicle won't
move, even when you're on fairly
level ground, always set your park-
ing brake.
• Only use the TireMobilityKit for
sealing/inflation passenger car
tires. Do not use on motorcycles,
bicycles or any other type of tires.
• Do not remove any foreign objects-
such as nails or screws -that have
penetrated the tire.
• Before using the TireMobilityKit,
read the precautionary advice
printed on the sealant bottle!
• Provided the car is outdoors, leave
the engine running. Otherwise
operating the compressor may
eventually drain the car battery.• Never leave the TireMobilityKit
unattended while it is being used.
• Do not leave the compressor run-
ning for more than 10 min. at a time
or it may overheat.
• Do not use the TireMobilityKit if the
ambient temperature is below -30°C
(-22°F).
• Do not use the sealing compound
after its expiration date which can
be found on the label of the bottle.
• Keep away from children.Technical Data
System voltage: DC 12 V
Working voltage: DC 10 - 15 V
Amperage rating: max. 15 A
Suitable for use at temperatures:
-30 ~ +70°C (-22 ~ +158°F)
Max. working pressure:
6 bar (87 psi)
Size
Compressor: 170 x 150 x 60 mm
(6.7 x 5.9 x 2.4 in.)
Sealant bottle: 85 x 77 ø mm
(3.3 x 3.0 ø in.)
Compressor weight:
0.8 kg (1.8 lbs)
Sealant volume:
200 ml (12.2 cu. in.)
❈Sealing compound and spare
parts can be obtained and
replaced at an authorized vehicle
or tire dealer. Empty sealing com-
pound bottles may be disposed of
at home. Liquid residue from the
sealing compound should be dis-
posed of by your vehicle or tire
dealer or in accordance with local
waste disposal regulations.
procarmanuals.com
Page 293 of 386
7
Engine compartment / 7-2
Maintenance services / 7-3
Owner maintenance / 7-5
Scheduled maintenance service / 7-7
Explanation of scheduled maintenance items / 7-28
Engine oil / 7-32
Engine coolant / 7-33
Brake/clutch fluid / 7-36
Washer fluid / 7-37
Parking brake / 7-37
Air cleaner / 7-38
Climate control air filter / 7-39
Wiper blades / 7-41
Battery / 7-43
Tires and wheels / 7-46
Fuses / 7-56
Light bulbs / 7-66
Appearance care / 7-78
Emission control system / 7-84
Maintenance
procarmanuals.com
Page 294 of 386
Maintenance
2 7
ENGINE COMPARTMENT
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake/clutch* fluid reservoir
4. Positive battery terminal
5. Negative battery terminal
6. Fuse box
7. Air cleaner
8. Radiator cap
9. Engine oil dipstick
10. Windshield washer fluid reservoir
* : if equipped
OFS011003/OFS012004L* The actual engine room including engine cover in the vehicle may differ from the illustration.
■Gasoline 1.6 GDI
■ Gasoline 1.6 MPI
procarmanuals.com
Page 298 of 386

Maintenance
6 7
At least monthly:
• Check the coolant level in the engine
coolant reservoir.
• Check the operation of all exterior
lights, including the stoplights, turn sig-
nals and hazard warning flashers.
• Check the inflation pressures of all
tires including the spare.
At least twice a year
(i.e., every Spring and Fall):
• Check the radiator, heater and air con-
ditioning hoses for leaks or damage.
• Check the windshield washer spray
and wiper operation. Clean wiper
blades with clean cloth dampened with
washer fluid.
• Check the headlight alignment.
• Check the muffler, exhaust pipes,
shields and clamps.
• Check the lap/shoulder belts for wear
and function.
• Check for worn tires and loose wheel
lug nuts.
At least once a year:
• Clean the body and door drain holes.
• Lubricate the door hinges and checks,
and hood hinges.
• Lubricate the door and hood locks and
latches.
• Lubricate the door rubber weather-
strips.
• Check the air conditioning system.
• Inspect and lubricate automatic
transaxle linkage and controls.
• Clean the battery and terminals.
• Check the brake/clutch fluid level.
procarmanuals.com
Page 301 of 386

79
Maintenance
NORMAL MAINTENANCE SCHEDULE -FOR EUROPE (CONT.)
15,000 km (10,000 miles)/12months
❑ Add fuel additives *5
(Add every 15,000km (10,000miles) or 12 months)
❑ Replace engine oil and engine oil filter (MPI engine) *2 *3 *4
(Replace every 15,000km (10,000miles) or 12months
30,000 km (20,000 miles)/12months
❑ Inspect air cleaner filter
❑ Inspect air conditioner compressor (if equipped)
❑ Inspect air conditioner refrigerant (if equipped)
❑ Inspect battery condition
❑ Inspect brake lines, hoses and connections
❑ Inspect brake pedal, clutch pedal (if equipped)
❑ Inspect brake/clutch fluid
❑ Inspect disc brakes and pads (if equipped)
❑ Inspect drive shaft and boots
❑ Inspect exhaust system
❑ Inspect front suspension ball joints
❑ Inspect parking brake
❑ Inspect steering gear rack, linkage and boots
❑ Replace climate control air filter (if equipped)
❑ Replace engine oil and engine oil filter (GDI) *
2*3*4
(Replace every 30,000km (20,000 miles) or 12 months)
60,000 km (40,000 miles) /24months
❑ Inspect air conditioner compressor (if equipped)
❑ Inspect air conditioner refrigerant (if equipped)
❑ Inspect battery condition
❑ Inspect brake lines, hoses and connections
❑ Inspect brake pedal, clutch pedal (if equipped)
❑ Inspect brake/clutch fluid
❑ Inspect cooling system
(At first, inspect at 60,000km (40,000 miles) or 48 months :
After that, inspect every 30,000km (20,000 miles) or 24
months)
❑ Inspect disc brakes and pads (if equipped)
❑ Inspect double clutch transmission fluid (if equipped) *
9
❑ Inspect drive shaft and boots
❑ Inspect exhaust system
❑ Inspect front suspension ball joints
❑ Inspect Fuel filter *
7
❑ Inspect fuel lines, hoses and connections
❑ Inspect fuel tank air filter
❑ Inspect manual transaxle fluid (if equipped) *
9
❑ Inspect parking brake
❑ Inspect steering gear rack, linkage and boots
(Continued)
procarmanuals.com
Page 302 of 386

Maintenance
10 7
NORMAL MAINTENANCE SCHEDULE -FOR EUROPE (CONT.)
90,000km (60,000 miles)/36months
❑ Inspect air cleaner filter
❑ Inspect air conditioner compressor (if equipped)
❑ Inspect air conditioner refrigerant (if equipped)
❑ Inspect battery condition
❑ Inspect brake lines, hoses and connections
❑ Inspect brake pedal, clutch pedal (if equipped)
❑ Inspect brake/clutch fluid
❑ Inspect cooling system
(At first, inspect at 60,000km (40,000 miles) or 48 months :
After that, inspect every 30,000km (20,000 miles) or 24
months)
❑ Inspect disc brakes and pads (if equipped)
❑ Inspect drive belts *
1
❑ Inspect drive shaft and boots
❑ Inspect exhaust system
❑ Inspect front suspension ball joints
❑ Inspect parking brake
❑ Inspect steering gear rack, linkage and boots
❑ Inspect valve clearance *
6
❑ Replace climate control air filter (if equipped)
❑ Replace engine oil and engine oil filter (GDI engine) *2 *3 *4
(Continued)
❑ Inspect vapor hose and fuel filler cap
❑ Replace air cleaner filter
❑ Replace climate control air filter (if equipped)
❑ Replace spark plugs (MPI engine)
❑ Replace engine oil and engine oil filter *
2*3*4
(Replace every 30,000km (20,000 miles) or 12 months)
procarmanuals.com
Page 303 of 386

711
Maintenance
NORMAL MAINTENANCE SCHEDULE -FOR EUROPE (CONT.)
120,000km (80,000 miles)/48months
❑ Inspect air conditioner compressor (if equipped)
❑ Inspect air conditioner refrigerant (if equipped)
❑ Inspect battery condition
❑ Inspect brake lines, hoses and connections
❑ Inspect brake pedal, clutch pedal (if equipped)
❑ Inspect brake/clutch fluid
❑ Inspect cooling system
(At first, inspect at 60,000km (40,000 miles) or 48 months :
After that, inspect every 30,000km (20,000 miles) or 24
months)
❑ Inspect disc brakes and pads (if equipped)
❑ Inspect double clutch transmission fluid (if equipped) *
9
❑ Inspect drive belts *1
❑ Inspect drive shaft and boots
❑ Inspect exhaust system
❑ Inspect front suspension ball joints
❑ Inspect Fuel filter *
7
❑ Inspect fuel lines, hoses and connections
❑ Inspect fuel tank air filter
❑ Inspect manual transaxle fluid (if equipped) *
9
❑ Inspect parking brake
(Continued)
(Continued)
❑ Inspect steering gear rack, linkage and boots
❑ Inspect vapor hose and fuel filler cap
❑ Replace air cleaner filter
❑ Replace climate control air filter (if equipped)
❑ Replace engine oil and engine oil filter (GDI engine) *
2 *3 *4
❑ Replace spark plugs (MPI engine)
procarmanuals.com