2011 HONDA ODYSSEY display

[x] Cancel search: display

Page 618 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil

Page 619 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual Always change the oil and f ilter
according to the maintenance
messages shown on the odometer/
trip meter display or on the multi-
inf ormation display. The oil and f ilter
collect contaminants that c

Page 623 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual Check the f luid level in the
windshield washer reservoir at least
monthly during normal use. This
reservoir supplies the windshield and
rear window washers.
Check the f luid level by removing
the cap

Page 625 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual If the level is below the lower
mark, add f luid into the dipstick
tube to bring it to the level
between the upper and lower
marks on the dipstick.
Pour the f luid slowly and caref ully so
you do not

Page 626 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual Check the brake f luid level in the
reservoirs monthly.Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 f luid, f rom a sealed
container, as a

Page 639 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air dry bef ore
you use the vehicl

Page 648 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual To help increase tire lif e and
distribute wear more evenly, rotate
the tires according to the
maintenance messages displayed on
the inf ormation display or multi-
inf ormation display (depending on
m

Page 652 of 722

HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual The sensor on the negative terminal
monitors your vehicle’s battery
condition.
If there is a problem with the sensor,
you will see a ‘‘CHECK BATT
SENSOR’’ message on the
inf ormation display