244
Maintenance
Maintenance Minder™
Resetting the Display
■
Reset the engine oil life display if you have performed the maintenance service.
Turn the ignition switch to ON
1.
II.
Display the engine oil life by repeatedly pressing the
2.
button.
Press and hold the SEL/RESET button for 10 seconds or more.
3.
The oil life reset mode is displayed on the multi-information display.
Select “RESET” with the
4.
button, then press the SEL/RESET button.
The service code will disappear and the engine oil life display will return to
100 %.
To cancel the oil life reset mode, select “CANCEL”, then press the SEL/RESET button.
Resetting the Display
NOTICE Failure to reset the engine oil life after a maintenance service results in the system showing incorrect maintenance intervals, which can lead to serious mechanical problems. The dealer will reset the engine oil life display after completing the required maintenance service.If someone other than a dealer performs
maintenance service, reset the engine oil life disp lay
yourself.
Maintenance Item Codes
Engine Oil Life
SEL/RESET Button
(Information) Button
Main MenuTable of Contents
278
Maintenance
12 Volt Battery
Checking the 12 Volt Battery
Check the battery condition monthly. Look at the test indicator window and check the terminals for corrosion.
If your vehicle’s battery is disconnected or goes dead: The audio system is disabled.
•
Entering the Security Code P.140
The clock resets.
•
Setting the Clock P.98
The navigation system is disabled. A PIN code will be required.
•
Refer to the navigation system manual.
Charging the 12 Volt Battery Disconnect both battery cables to prevent damaging your vehicle’s electrical system. Always disconnect the negative (–) cable first, and reconnect it last.
Test Indicator Window 12 Volt Battery
WARNING: Battery posts, terminals, and
related accessories contain lead and lead compounds.Wash your hands after handling. The test indicator's color information is on the battery. When you ind corrosion, clean the battery terminals by applying a baking powder and water solution. Rinse the terminals with water. Cloth/towel dry the battery. Coat the terminals with grease to help prevent future corrosion. If the 12 volt battery is disconnected or goes dead, the IMA battery level gauge reading may show less than the actual level the next time you turn the ignition switch to ON
. It will show the correct
level after you drive for about 30 minutes.
WARNING
The battery gives off explosive hydrogen gas during normal operation. A spark or flame can cause the battery to explode with enough force to kill or seriously hurt you. Wear protective clothing and a face shield, or have a skilled technician do any battery maintenance.
Main MenuTable of Contents
