2011 FORD C MAX air condition

Downloaded from www.Manualslib.com manuals search engine Should the unexpected occur and a major
part needs replacing, we recommend that
you accept nothing less than Ford Original
Parts.
The use of Ford Original Parts ensures that
your vehicle is repaired to its pre-accident
condition and maintains its maximum
residual value.
Ford Original Parts match Ford's stringent
safety requirements and high standards
of fit, finish and reliability. Quite simply,
they represent the best overall repair value,
including parts and labour costs.
Now it is easier to tell if you have really
been given Ford Original Parts. The Ford
logo is clearly visible on the following parts
if they are Ford Original Parts. If your
vehicle has to be repaired, look for the
clearly visible Ford branding and make sure
that only Ford Original Parts have been
used.
Look for the Ford logo on the
following parts
Sheet metal
•
Bonnet
• Wings
• Doors
• Luggage compartment lid or tailgate Bumper and radiator grille
•
Radiator grille
• Front and rear bumper 8
IntroductionE130165 E130166

Downloaded from www.Manualslib.com manuals search engine Note:
On vehicles with automatic
transmission, the system is active only in S,
D and N.
The system is only active when you exceed
10 km/h (6 mph). The system is
temporarily deactivated when you select
reverse gear.
System detection and alerts
The system will trigger the alert for vehicles
that enter the blind spot zone from the rear
or merge from the side. Vehicles that you
pass, or vehicles that enter the blind spot
zone from the front, will only trigger the
alert after the vehicle has remained in the
blind spot zone for a short period of time.
Note: Vehicles that pass through the blind
zone quickly (typically less than 2 seconds)
will not trigger the alert.
The system consists of two radar sensors
each located behind the rear wheels
hidden behind the bumpers. CAUTIONS
Do not place items such as bumper
stickers in this area.
Repairs to these areas using body filler
will affect the performance of the
system. Detection limitations
There may be certain instances where
vehicles entering and exiting the blind spot
zones may not be detected.
Instances which may cause non-detection:
•
Debris build up on the rear bumper
panels in the area of the sensors.
• Certain manoeuvring of vehicles
entering and exiting the blind zone.
• Vehicles passing through the blind zone
at high speed.
• Severe weather conditions.
• Several vehicles passing through the
blind zone following each other closely.
False alerts
Note: False alerts are temporary and will
self correct.
There may be certain instances when the
system will alert with no vehicle present in
the blind zone.
Circumstances where false alerts may
occur:
• Road guardrails.
• Motorway concrete walls.
• Construction areas.
• Sharp turns around a building.
• Bushes and trees.
• Cyclists and motorcyclists.
• Coming to a stop with a vehicle directly
behind but very close.
Turning the system on and off
Note: The on or off position will remain until
manually changed.
You can turn the system on and off using
the information display. See Information
Displays (page 83).
75
Windows and MirrorsE124741

Downloaded from www.Manualslib.com manuals search engine PRINCIPLE OF OPERATION
Outside air
Keep the air intakes forward of the
windscreen free from obstruction (snow,
leaves etc.) to allow the climate control
system to function effectively.
Recirculated air
CAUTION
Prolonged use of recirculated air may
cause the windows to mist up. If the
windows mist up, follow the settings
for defrosting and demisting the
windscreen. The air currently in the passenger
compartment will be recirculated. Outside
air will not enter the vehicle.
Heating
Heating performance depends on the
temperature of the engine coolant.
Air conditioning
Note:
The air conditioning operates only
when the temperature is above 4°C (39°F).
Note: If you use the air conditioning, the
fuel consumption of your vehicle will be
higher.
Air is directed through the evaporator
where it is cooled. Humidity is extracted
from the air to help keep the windows free
of mist. The resulting condensation is
directed to the outside of the vehicle and
it is therefore normal if you see a small
pool of water under your vehicle.
General information on controlling
the interior climate
Fully close all the windows. Warming the interior
Direct the air towards your feet. In cold or
humid weather conditions, direct some of
the air towards the windscreen and the
door windows.
Cooling the interior
Direct the air towards your face.
AIR VENTS
Centre air vents
100
Climate ControlE129788 E129789

Downloaded from www.Manualslib.com manuals search engine Blower
OffA
Note: If you switch the blower off, the
windscreen may mist up.
Recirculated air Press the button to toggle between outside
air and recirculated air.
Heating the interior quickly Ventilation
Set the air distribution control, blower and
air vents to suit your requirements.
Air conditioning
Switching the air conditioning on and
off
If you turn the blower off, the air
conditioning will turn off. When you turn
the blower on again, the air conditioning
will come on automatically.
Cooling with outside air
Cooling the interior quickly
102
Climate ControlE75470A E73059 E129884 E129885 E129886 E129887

Downloaded from www.Manualslib.com manuals search engine With the heater control in this position, the
air conditioning and recirculated air will
switch on automatically.
You can switch the air conditioning and
recirculated air on and off.
Defrosting and demisting the
windscreen
When the temperature is above 4°C
(39°F), the air conditioning will switch on
automatically. Make sure that the blower
is on. The indicator in the switch will
illuminate during defrosting and demisting.
If you move the air distribution control to
a position other than windscreen, the A/C
will remain on.
You can switch the air conditioning and
recirculated air on and off while the air
distribution control is set to windscreen
If necessary, switch the heated windows
on. See Heated Windows and Mirrors
(page 105).
Reducing interior air humidity AUTOMATIC CLIMATE
CONTROL
The system controls the temperature,
amount and distribution of the air flow
automatically and adjusts them according
to the driving and weather conditions.
Pressing the AUTO button once switches
on the auto mode.
The system in your vehicle is dual-zone
automatic climate control. When the
system is in mono mode, all the
temperature zones are linked to the driver's
zone. When you switch mono mode off,
the dual-zone system allows you to set
different temperatures for the driver's and
front passenger's side.
Note:
Avoid adjusting the settings when
the vehicle interior is extremely hot or cold.
The automatic climate control adjusts to
the current circumstances automatically.
For the system to function properly, the side
and centre vents should be fully open.
Note: The sunload sensor is located on top
of the instrument panel. Do not cover the
sensor with any objects.
Note: At low outside temperatures, when
the system is in auto mode, the air stream
will be directed to the windscreen and the
side windows as long as the engine is cold.
103
Climate ControlE129888 E129889 E140019

Downloaded from www.Manualslib.com manuals search engine Setting the temperature
You can set the temperature between
15.5°C (60°F) and 29.5°C (85°F) in steps
of 0.5°C (1°F). In position LO, 15°C (59°F),
the system will switch to permanent
cooling. In position HI, 30°C (86°F), the
system will switch to permanent heating.
Note:
If either position LO or HI is selected,
the system will not regulate a stable
temperature.
Mono mode
In mono mode, the temperature settings
for both the driver ’s and passenger ’s side
are linked. If you adjust the temperature
using the rotary control on the driver ’s side,
the settings will be adjusted to the same
setting on the passenger ’s side. In mono
mode, MONO appears in the display.
To switch mono mode off
Select a temperature for the passenger ’s
side with the rotary control on the
passenger ’s side. Mono mode will switch
off and MONO disappears from the
display. The temperature for the driver ’s
side will remain unchanged. You can now
adjust the driver and passenger side
temperatures independently of each
another. The temperature settings for each
side are shown in the display. You can set
a temperature difference of up to 4°C
(8°F).
Note: If you set a temperature difference
of greater than 4°C (8°F), the temperature
on the other side will be adjusted so that
the difference remains 4°C (8°F). Note:
If you set one of the sides to HI or LO,
both sides will be set to HI or LO.
To switch mono mode back on To switch mono mode back on,
press the MONO button.
MONO reappears in the display
and the passenger ’s side temperature will
be adjusted to the driver ’s side
temperature.
Blower Use the buttons to adjust the
blower speed.
The blower setting is indicated
in the display.
To return to auto mode, press the AUTO
button.
Air distribution
To adjust air distribution, press the desired
button. Any combination of settings can
be selected simultaneously. Footwell
A
Face level
B
Windscreen
C
When you select windscreen defrosting
and demisting, A,B and C switch off
automatically and the air conditioning
switches on. Outside air will flow into the
vehicle. You cannot select recirculated air.
104
Climate ControlE91391 E70306 E70308ABC

Downloaded from www.Manualslib.com manuals search engine Windscreen defrosting and
demisting
Press the windscreen defrosting
and demisting button. Outside
air will flow into the vehicle. Air
conditioning is automatically selected. As
long as the air distribution is set to this
position, you cannot select recirculated air.
The blower speed and the temperature
control operate automatically and cannot
be adjusted manually. The blower is set to
high speed and the temperature to HI.
When you select windscreen defrosting
and demisting, the heated screens switch
on automatically and switch off after a
short time.
To return to auto mode, press the AUTO
button.
Switching the air conditioning on
and off Press the A/C button to switch
the air conditioning on and off.
A/C OFF appears in the display
when the air conditioning is switched off.
A/C ON appears in the display when the
air conditioning is switched on.
Recirculated air Press the recirculated air button
to toggle between outside air
and recirculated air.
Note: When the system is in auto mode and
the interior and exterior temperatures are
quite hot, the system selects recirculated
air automatically to maximise cooling of the
interior. Once the selected temperature is
reached, the system will reselect outside air
automatically. Switching off the automatic
climate control Press the OFF button.
When switched off, the heating,
ventilation and air conditioning
system is switched off and recirculated air
is selected.
HEATED WINDOWS AND
MIRRORS
Heated windows
Use the heated windows to defrost or
demist the windscreen or rear window.
Note: The heated windows operate only
when the engine is running.
Heated windscreen Heated rear window
Vehicles without auxiliary heater
If the ambient temperature is below 5°C
(41°F) and the engine coolant is below
65°C (149°F), the heated windscreen and
heated rear window will switch on
automatically. They will switch off
automatically.
Heated exterior mirrors
Electric exterior mirrors are fitted with a
heating element that will defrost or demist
the mirror glass. They will switch on
automatically when you switch the heated
rear window on.
105
Climate ControlE91392 E91394 E72506 E72507

Downloaded from www.Manualslib.com manuals search engine Incorrect position
A
Correct position
B
3. Do not lift the nozzle during refilling. This
can affect the flow of fuel and shut off of
the fuel nozzle before the fuel tank is full. 4. Operate the nozzle within the area
shown.
WARNINGS
We recommend that you remove the
fuel nozzle slowly to allow any
residual fuel to drain into the fuel
tank. Alternatively you can wait 10 seconds
before removing the fuel nozzle. Do not remove the nozzle from its
fully inserted position during the
entire refuelling process. 5. Slightly raise the fuel nozzle to remove
it.
Refuelling with a fuel can
Use the funnel which is located in the glove
box.
REFUELLING
CAUTION
Do not attempt to start the engine if
you have filled the fuel tank with the
incorrect fuel. This could damage the
engine. Have the system checked by a
properly trained technician immediately. FUEL CONSUMPTION
The CO2 and fuel consumption figures are
derived from laboratory tests according to
EEC Directive 80/1268/EEC and
subsequent amendments and are carried
out by all vehicle manufacturers.
They are intended as a comparison
between makes and models of vehicles.
They are not intended to represent the real
world fuel consumption you may get from
your vehicle. Real world fuel consumption
is governed by many factors including;
driving style, high speed driving, stop/start
driving, air conditioning usage, the
accessories fitted and towing etc.
138
Fuel and RefuellingE139203AB E139924 E119081