2011 FIAT STRADA belts

20
FRONT SEAT BELT HEIGHT
ADJUSTMENT
Always adjust the height of the seat
belt to the body of the passenger.
This precaution may considerably
reduce the risk of injury in the event
of a collision.
Correct adjustment is obtained
when the belt passes approximately
half way between the shoulder and
the neck.
According to the version, there may
be as many as 5 height adjustment
positions fig. 22:
To raise: lift the ring B to the
desired position.
The height of the seat
belts must be adjusted
with the vehicle stationary.
WARNING
SEAT BELTS
HOW TO USE THE
SEAT BELTS fig. 21
To fasten the seat belts, hold the
tongue A and insert it into the
buckle B, until it clicks into place.
Pull the belt lightly. If the seat belt
jams, let it rewind for a short
stretch, then pull it out again
without jerking.
fig. 21
F0X0022m
To unfasten the seat belt, press
button C. Guide the seat belt while
it is rewinding, to prevent it from
twisting. Through the reel, the belt
automatically adapts to the body of
the passenger wearing it, allowing
freedom of movement.
The reel may lock when the vehicle
is parked on a steep slope: this is
normal.
Furthermore, the reel mechanism
locks the belt if it is pulled sharply or
in the event of sudden braking,
collisions and high-speed bends.
For maximum
protection, keep the
backrest upright, lean back
into it and make sure that the
seat belt fits closely across the
chest and pelvis.
WARNING

21
To lower: press button A and move
ring B downwards to the desired
position at the same time.
When you have finished, check that
it has locked by pushing ring B
downwards without pressing
button A.
fig. 22
F0X0023m
fig. 23
F0X0024m
After adjustment,
always check that the
cursor to which the ring is fixed
is locked in one of the set
positions.
WARNING
REAR SEAT BELTS
Depending on the version, the rear
seat may be fitted with inertia seat
belts with three anchor points and a
reel.
The belts must be worn in
accordance with the diagram in
fig. 23.
fig. 24
F0X0026m
When they are not in use, always
return the rear seats belts to their
dedicated housings A-fig. 24.

22
GENERAL INSTRUCTIONS
FOR USING THE SEAT BELTS
The driver is responsible for
respecting (and ensuring that all the
other passengers also respect) the
local laws in force regarding the use
of seat belts. Always fasten the seat
belts before starting off.
fig. 25
F0X0029m
For maximum safety,
keep the back of your
seat upright, lean back into it
and make sure the seat belt fits
closely across your chest and
pelvis. Always fasten the seat
belts on both the front and the
rear seats! Travelling without
using seat belts increases the
risk of severe injury and even
death in the event of an
accident.
WARNING
The belt must not be
twisted. The upper part
must pass over the shoulder
and cross the chest diagonally.
The lower part must adhere to
the pelvis, rather than the
abdomen of the passenger, to
avoid the risk of slipping
forward fig. 25. Do not use
devices (clips, pegs, etc.) to
hold the belts away from the
body.
WARNING

23
fig. 26
F0X0030m
Do not travel with
children on a
passenger’s lap using one seat
belt to protect them both
fig. 26.
WARNING
Removing or otherwise
tampering with safety
belt and pretensioner
components is strictly
prohibited. Any operations on
these components must be
performed by qualified and
authorised technicians. Always
contact a Fiat Dealership.
WARNING
If the belt has been
subjected to a high level
of stress, for example after an
accident, it must be completely
replaced together with the
attachments, attachment fixing
screws and the pretensioner. In
fact, even if the belt has no
visible defects, it could have
lost its resilience.
WARNING
Each seat belt must be
used by only one
person: do not travel with
children on a passenger’s lap
using the seat belts to protect
them both. In general, do not
place any objects between the
person and belt.
WARNING

24
Seat belts must also be worn by
expectant mothers: the risk of injury
in the event of an accident is greatly
reduced for them and the unborn
child if they are wearing a seat belt.
Of course, expectant mothers must
position the lower part of the belt
very low down so that it passes
under the abdomen fig. 27.
fig. 27
F0X0155m
HOW TO MAINTAIN THE
SEAT BELTS IN EFFICIENT
CONDITIONS
1) Always use the belt with the strap
well stretched and not twisted;
make sure that it is free to run
without obstructions.
2) Replace the belt which was worn
after an accident of a certain
severity even if it does not appear
to be damaged.
3) To clean the belt, wash by hand
with water and mild soap, rinse
and leave to dry in the shade. Do
not use strong detergents, bleach,
paints or any other substance
which could damage the belt
fibres.
4) Prevent the reels from getting
wet: their correct operation is
only guaranteed if water does not
get inside.
5) Replace seat belts when they
show signs of significant wear or
cuts.
SEVERE
DANGER:
If the vehicle has a passenger
side airbag, do not fit a child
seat on the front seat.
WARNING

25
The pretensioner does not require
any maintenance or lubrication.
Anything that modifies its original
conditions invalidates its efficiency.
If, due to unusual natural events
(floods, sea storms, etc.), the device
has been affected by water and mud,
it must be replaced.
To obtain the highest degree of
protection from the action of the
pretensioner, wear the seat belt
tight across the chest and pelvis.PRETENSIONERS
To make the protective action of the
seat belts even more effective, the
Fiat Strada is fitted with
pretensioners. These devices “feel”,
through a sensor, the occurrence of
a severe impact, retracting the belts
by a few centimetres. This
guarantees that the belt adheres
perfectly to the body of the
occupants, before the restraining
action begins. The reel locks to
indicate that the pretensioner has
intervened; the seat belt cannot be
drawn back up even when guided.
A small amount of smoke may be
emitted. This smoke is not harmful
and does not indicate a fire.The pretensioners
require neither internal
lubrication nor maintenance
interventions. The
pretensioners must not be
tampered with under any
circumstances. This could
compromise the operation of
the safety devices. Should
intervention be necessary,
contact a Fiat Dealership.
WARNING

26
Operations which lead
to impacts, vibrations or
localised heating (above
100°C for a maximum of 6
hours) in the area around the
pretensioners may damage or
activate them. These devices are
not affected by vibrations
caused by uneven road surfaces
or low obstacles such as kerbs,
etc. Contact a Fiat Dealership
should intervention be
necessary.LOAD LIMITERS
(for versions/markets,
where provided)
To increase passenger safety in an
accident, the front and rear (for
versions/markets where provided)
seat belt reels contain a load limiter
which controls the force acting on
the chest and shoulders during the
restraining action of the belts in the
event of a head-on collision.
The pretensioner may
be used only once.
After it has been activated,
have it replaced at a Fiat
Dealership. Consult the plate
in the glove box to check the
status of the pretensioners.
Go to a Fiat Dealership to have
the device replaced when the
expiration date approaches.
WARNING

Contact a Fiat
Dealership as soon as
possible if the
U
warning light does not switch on
when the ignition key is turned
to MAR or if it switches on
when driving (together with a
message on the display on some
versions). The operation of the
Uwarning light may be
checked by the traffic control
authorities using specific
devices. Always comply with the
traffic regulations in force in the
country where you are driving.
INJECTION SYSTEM
FAILURE (amber)
In normal conditions, when the
ignition key is turned to MAR, the
warning light switches on, but should
switch off when the engine starts.
If the warning light stays on or
comes on when travelling, it means
there is a fault in the injection
system which could cause loss of
performance, poor handling and high
fuel consumption levels.
On some versions, the display shows
a dedicated message.
Under these conditions, the vehicle
can continue travelling at moderate
speed without demanding excessive
effort from the engine. In any case,
you should contact a Fiat Dealership
as soon as possible. DOORS NOT
CLOSED
CORRECTLY (red)
On certain versions, the warning
light switches on when one or more
doors are not closed correctly. On
some versions, the display shows a
dedicated message. On some
versions, an acoustic signal is emitted
when the vehicle is in motion.SEAT BELTS NOT
FASTENED (red)
(for versions/markets,
where provided)
The warning light on the panel
switches on constantly when the
vehicle is stationary and the driver
side seat belt is not fastened correctly.
It will flash, and be accompanied by a
buzzer, if the front seat belts are not
fastened correctly when the vehicle is
in motion.
<
´
U
60