2011 Citroen BERLINGO FIRST Owner's Manual

23MONITORING and DISPLAY SCREENS
-

Engine oil level indicator

When the ignition is switched on,
the engine oil level is indicated for
approximately 10 seconds, after the
service information.
Flashing of the six squares and dis-
playing of "max" indicate a surplus of
oil which could damage the engine.
If the surplus of oil is confi rmed by
a check using the dipstick, contact a
CITROËN dealer without delay. Your CITROËN dealer carries out
this operation after each service.
The reset procedure is as follows:


- Switch off the ignition.

- Press and hold button 1
.

- Switch on the ignition.
The display begins a 10 second count-
down.


-
Keep button 1
pressed for 10 seconds.

The display shows [=0]
and the spanner
disappears.

Flashing of the six segments and dis-
playing of "min" indicate a lack of oil
which could damage the engine.
If the lack of oil is confi rmed by a
check using the dipstick, it is essential
that the level is topped up. Flashing of the six segments indi-
cates a malfunction of the oil level
indicator.
There is a risk of damage to the
engine.
Consult a CITROËN dealer.

The level read on the dipstick or on
the indicator will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 15 minutes.




Resetting the service indicator

Surplus of oil

Lack of oil
Oil level indicator fault

MONITORING and DISPLAY SCREENS
24 -
Briefl y pressing button 1
alternates
between the total and trip distance
displays.
To reset the trip recorder to zero,
when it is displayed press button 1

until zeros appear.


Total distance recorder

With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
LIGHTING RHEOSTAT CLOCK
Button 1
: hour adjustment
Button 2
: minute adjustment
Press and hold the button for rapid
advance.

25MONITORING and DISPLAY SCREENS
-
DISPLAY A

This displays the following information:


- the time,

- the date,

- the audio system displays,

- a door check (e.g.: ''left front door
open''),

- warning messages (e.g.: ''remote
control battery fl at'') or information
messages (e.g.: ''economy mode
active''), displayed temporarily.

Adjusting the parameters display A
Press and hold button A
for two
seconds to access the settings; the
data fl ashes, indicating it is ready to
be modifi ed.
Then, each press of button A
scrolls
through the various data in the follow-
ing order:


- language of information displayed,

- hours (12 then 24 hour mode),

- minutes,

- year,

- month,

- day.
Pressing button B
alters the value of
the parameter selected. Press and
hold for rapid advance (return to start
after the last possible value).
After 7 seconds with no action, the
standard display returns; the modifi ed
data is now recorded.

COMFORT26 -

27COMFORT-
VENTILATION


1.
Windscreen de-icing or demisting
vents.

2.
Front window de-icing or demist-
ing vents.

3.
Side vents.

4.
Centre vents.

5.
Air outlets to front footwells. The air conditioning system does not
contain chlorine and does not pres-
ent any danger to the ozone layer.
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
The water created by the air condi-
tioning condensation is discharged
via an opening provided for this pur-
pose. Therefore, a puddle of water
may form underneath the vehicle
when stationary.
If the system does not produce
cold air, do not use it and contact a
CITROËN dealer.

De-icing the rear windows and
mirrors
With the engine running, pressing
the control de-ices the rear windows
and mirrors.
It switches off automatically after ap-
proximately twelve minutes.
Pressing the control again switch-
es the de-icing system on again for
twelve minutes.
It is possible to switch off the de-ic-
ing by pressing the control before the
twelve minutes have elapsed.



Advice on operation

Select the air distribution most suited
to your requirements and the climatic
conditions.
Gradually adjust the temperature
setting for your comfort.
Position the air control in the ''Outside
Air'' position.
For perfectly even air distribution,
take care not to obstruct the exterior
air intake grille and the vents. Check
that the passenger compartment fi l-
ter is in good condition.
When the engine is cold, to prevent
too great a distribution of cold air, the
ventilation will increase to its opti-
mum level gradually.
In order to be effective, the air condi-
tioning ( A/C
button), should only be
used with the windows closed.
If the interior temperature remains
very high following a prolonged peri-
od parked in the sun, do not hesitate
to ventilate the passenger compart-
ment for a few minutes.

COMFORT28 -
Intake of exterior air.
HEATING

Turn the control from posi-
tion 1
to position 4
to obtain
an air fl ow suffi cient to en-
sure your comfort.

2. Air fl ow adjustment and air
intake control
Turn the control from posi-
tion 1
to position 4
to obtain
an air fl ow suffi cient to en-
sure your comfort.
As soon as possible, position the
control in the exterior air intake po-
sition to prevent the formation of
mist on the windows.

This is the normal operating posi-
tion.
Passenger compartment isolation.

This position prevents exterior odours
and smoke entering the passenger
compartment.
1. Air fl ow adjustment

29COMFORT-
These settings are recommended for
cold climates.
3. Temperature adjustment
To be adjusted to your requirements.
From blue (exterior temperature) to
red (hot).

4. Air distribution adjustment
This setting is recommended for high
temperatures.
Windscreen and side win-
dows (de-icing/demisting).
To quickly demist or defrost the wind-
screen and side windows:


- position the air intake control in
the ''Exterior Air Intake" position,

- turn the temperature and air fl ow
controls to maximum,

- close the centre vents. Windscreen, side windows
and footwells.
Footwells.
Centre and side vents.

COMFORT30 -
Press the switch to activate
the air conditioning. The indi-
cator lamp comes on.
2. Air fl ow adjustment and air
intake control
Turn the control from position 1

to position 4
to obtain an air
fl ow suffi cient to ensure your
comfort.
AIR CONDITIONING


The air conditioning does not op-
erate while the air fl ow adjustment
control is in the minimum position.


Note:
to optimise the operation of
the air conditioning, leave the vents
open.
1. Air conditioning control
The air conditioning is designed to
operate in all seasons. In summer,
it enables the temperature to be
lowered and in winter, above 0 °C,
it increases the effectiveness of the
demisting.