2011 BUICK LUCERNE Owner's Manual

Black plate (3,1)Buick Lucerne Owner Manual - 2011
A.Outlet Adjustment on page 4‑25
B. DIC Operation and Displays on page 4‑42
C. Turn Signal/Multifunction Lever on page 4‑4
Windshield Wipers on page 4‑6
D. Instrument Panel Cluster on page 4‑28
E. Hazard Warning Flashers on page 4‑3
F. Audio System(s) on page 4‑67
G. Exterior Lamps on page 4‑10
H. Trunk Release. See Trunk on page 3‑12
I. Instrument Panel Brightness on page 4‑12
J. Hood Release on page 6‑13
K. Lane Departure Warning (LDW) on page 3‑40
L. Cruise Control on page 4‑7
Heated Steering Wheel on page 4‑4 M. Data Link Connector (DLC) (Out of View). See
Malfunction Indicator Lamp on page 4‑37
N. Parking Brake on page 3‑26
O. Audio Steering Wheel Controls on page 4‑94
P. Climate Control System on page 4‑16
Dual Automatic Climate Control System
on
page 4‑20
Q. Traction Control System (TCS) on page 5‑6
StabiliTrak®System on page 5‑5
R. Front Storage Area on page 3‑49
S. Shift Lever. See Automatic Transmission Operation
on page 3‑24
T.Accessory Power Outlet(s) on page 4‑15
U. Glove Box on page 3‑49
1-3

Black plate (4,1)Buick Lucerne Owner Manual - 2011
Initial Drive Information
This section provides a brief overview about some of
the important features that may or may not be on your
specific vehicle.
For more detailed information, refer to each of the
features which can be found later in this owner manual.
Remote Keyless Entry (RKE) System
The RKE transmitter is used to remotely lock and
unlock the doors from up to 60 m (195 feet) away from
the vehicle.
PressKto unlock the
driver door. Press again
within five seconds to
unlock all remaining
doors. Press
Qto lock all doors.
Lock and unlock feedback can be personalized.
Press and hold
Vfor approximately one second to
open the trunk.
Press
Land release to locate the vehicle.
Press
Land hold for more than two seconds to sound
the panic alarm.
Press
Lagain to cancel the panic alarm.
See Keys
on page 3‑3andRemote Keyless Entry
(RKE) System Operation on page 3‑4.
Remote Vehicle Start
With this feature the engine can be started from outside
of the vehicle.
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press
Q.
3. Immediately after completing Step 2, press and hold
/until the turn signal lamps flash.
1-4

Black plate (5,1)Buick Lucerne Owner Manual - 2011
When the vehicle starts, the parking lamps will turn on
and remain on as long as the engine is running. The
doors will be locked and the climate control system may
come on.
The engine will continue to run for 10 minutes. Repeat
the steps for a 10-minute time extension. Remote start
can be extended only once.
Canceling a Remote Start
To cancel a remote start:
.Aim the RKE transmitter at the vehicle and press
and hold
/until the parking lamps turn off.
.Turn on the hazard warning flashers.
.Turn the ignition on and then back off.
See Remote Vehicle Start on page 3‑7.
Door Locks
From the outside, unlock the door using either the key
or the RKE transmitter.
From the inside, use the power door lock switches or
manual lock knobs located at the top of the door panel
near the window.
Power Door Locks
On vehicles with power door locks, the switches are
located on the front doors.
"(Unlock): Press to unlock the doors.
Q(Lock):Remove the key from the ignition and press
to lock the doors.
For more information, see:
.Door Locks on page 3‑9.
.Power Door Locks on page 3‑9.
.Remote Keyless Entry (RKE) System Operationon page 3‑4.
Trunk Release
In addition to the trunk release button on the RKE
transmitter, there is a remote release
Vbutton
located to the left of the steering wheel, next to the
instrument panel brightness control. Press to open the
trunk.
See Trunk on page 3‑12.
1-5

Black plate (6,1)Buick Lucerne Owner Manual - 2011
Windows
On vehicles with power windows, the switches are on
the driver door armrest. Each passenger door has a
switch that controls only that window.
Press the switch to lower the window. Pull the switch up
to raise it.
For more information, seePower Windows
on
page 3‑15.
Seat Adjustment
Power Seats
To adjust a power seat:
.Move the seat forward or rearward by sliding the
control forward or rearward.
.Raise or lower the front or rear part of the seat
cushion by moving the front or rear of the control
up or down.
.Raise or lower the entire seat by moving the entire
control up or down.
See Power Seats on page 2‑3.
1-6

Black plate (7,1)Buick Lucerne Owner Manual - 2011
Reclining Seatbacks
To raise or recline the seatback, tilt the top of the
control forward or rearward.
SeeReclining Seatbacks on page 2‑9.
Lumbar Adjustment
Use the round control on the outboard side of the seat
to adjust the lumbar support.
SeePower Lumbar
on page 2‑4for more information.
1-7

Black plate (8,1)Buick Lucerne Owner Manual - 2011
Memory Features
On vehicles with the memory feature, the controls on
the driver door are used to program and recall memory
settings for the driver seat, outside mirrors, and the
power steering column, if the vehicle has this feature.
1:Saves and recalls for driver 1.
2: Saves and recalls for driver 2.
S:Recalls the easy exit driver seat and power steering
column positions.
Storing Memory Positions
To save into memory:
1. Adjust the driver seat, seatback recliner, lumbar, both outside mirrors, and the power steering
column, if equipped.
2. Press and hold “1”until two beeps sound.
3. Repeat for a second driver position using “2.”To recall the memory positions, press and release
“1”
or “2.” The vehicle must be in P (Park). A single beep
will sound. The seat, outside mirrors, and power
steering column, if equipped, will move to the positions
previously stored for the identified driver.
See Memory Seat and Mirrors
on page 2‑7for more
information.
Easy Exit Positions
The easy exit feature can move the driver seat rearward
and the power steering column, if equipped, up and
forward to allow extra room to exit the vehicle.
S: Press to recall the easy exit positions. The vehicle
must be in P (Park).
See Memory Seat and Mirrors
on page 2‑7and“Easy
Exit Recall” and“Easy Exit Setup” underDIC Vehicle
Customization
on page 4‑58for more information.
1-8

Black plate (9,1)Buick Lucerne Owner Manual - 2011
Heated Seats
If available, the buttons are on the front doors. To
operate, the ignition must be on.
J:Press to heat the seat and seatback.
I: Press to heat the seatback.
For more information, see Heated Seats on page 2‑4.
Heated and Ventilated Seats
If available, the buttons are on the front doors. To
operate, the ignition must be on.
J:Press to heat the seat and seatback.
I: Press to heat the seatback only.
H:Press to cool the seat and seatback.
For more information see Heated and Ventilated Seats
on page 2‑6.
1-9

Black plate (10,1)Buick Lucerne Owner Manual - 2011
Head Restraint Adjustment
The vehicle's front seats have adjustable head
restraints in the outboard seating positions.
Do not drive until the head restraints for all occupants
are installed and adjusted properly.
To achieve a comfortable seating position, change the
seatback recline angle as little as necessary while
keeping the seat and the head restraint height in the
proper position.
For more information seeHead Restraints
on
page 2‑2and Power Seats on page 2‑3.
Safety Belts
Refer to the following sections for important information
on how to use safety belts properly.
.Safety Belts: They Are for Everyone on page 2‑12.
.How to Wear Safety Belts Properly on page 2‑17.
.Lap-Shoulder Belt on page 2‑26.
.Lap Belt on page 2‑32.
.Lower Anchors and Tethers for Children (LATCH)on page 2‑42.
1-10