lffll.___E_ m_ e_ r-' g=- e_n_ c=-y _ s_it _ u _ a_t_ i_ o _ n_ s ______________________________________________ _
in. WARNING
• To reduce the risk of serious injury and vehicle damage.
-Always lift the vehicle only at the special workshop hoist and
floor jack lift points illustrated
=> page 333, fig. 238 and
=> page 333, fig. 239.
- Failure to lift the vehicle at these points could cause the
vehicle to tilt or fall from a lift if there is a change in vehicle
weight distribution and balance. This might happen, for
example, when heavy components such as the engine block or
transmission are removed.
• When removing heavy components like these, anchor vehicle
to hoist or add corresponding weights to maintain the center of
gravity. Otherwise, the vehicle might tilt or slip off the hoist,
causing serious personal injury.
0 Note
• Be aware of the following points before lifting the vehicle :
-The vehicle should never be lifted or jacked up from under
neath the engine oil pan, the transmission housing, the front or
rear axle or the body side members. This could lead to serious
damage.
- To avoid damage to the underbody or chassis frame, a rubber
pad must be inserted between the floor jack and the lift points.
- Before driving over a workshop hoist, check that the vehicle
weight does not exceed the permissible lifting capacity of the hoist.
- Before driving over a workshop hoist, ensure that there is sufficient clearance between the hoist and low parts of the
vehicle. •
__________________________________________________ D_ a_t _a __ _
Data
Applies to vehicles: wit h 2.0 lit er 4 -c yl. engin e
211 hp, 2.0 liter 4-cyl. engine
Engine data
M aximum outpu t SA E net
Maximum torque SAE net
No. of cy linders
Displa cement
St roke
Bore
Compression ratio
Fu el
Dimensions (approx. )
Length (with licence plate bracket)
W idth (w ith outs ide mir rors folded)
He igh t (u nloaded)
Turning circle diameter (curb to curb)
Capacities (approx .)
Fu el tank
- Tota l capacity
- Rese rve (of to tal cap aci ty)
W indshield and headlight* washer fluid container
Engine oil
with filter c hange
Safety first
hp@rpm
lb-ft@ rpm
C ID (cm
3
)
in (mm)
in (mm)
211 @43 00-6 000
258@ 1500-4200
4
121 (1984)
3.65 (92.8)
3 .25 (82.5)
9 .6 : 1
Premium unleaded (91 AKI) R ecomm end ed for maximum engin e perfo rmanc e. Fur
ther details =>
page 269, "Gasoline"
i n (mm)
i n (mm)
i n (mm)
ft (m)
182.0 (4625)
73.0 (1854) 54.0 (137 2)
37.4 (11.4)
gal (liters)
gal ( liters)
quarts (liters)
quarts ( liters) 16.9 (64 .0)
2.1
(8)
4.8 (4 .5)
4.9 (4.6)
•
Do-it,yourself service Technical data
