165
Continued
Features
The HomeLink
® Universal Transceiver can be programmed to operate up to three
remote controlled devices around your home, such as garage doors, lighting, or
home security systems.
Important Safety Precautions
Refer to the safety information that comes with your garage door opener to test
that the safety features are functioning properly. If you do not have the safety
information, contact the manufacturer.
Before programming HomeLink, make sure that people and objects are out of the
way of the garage or gate to prevent potential injury or damage.
When programming a garage door opener, park just outside the garage door's
path.
If you have not trained any of the buttons in
HomeLink before, you should erase any
previously learned codes. To do this:
Press and hold the two outside buttons for t
about 20 seconds, until the red indicator
blinks. Release the buttons, and proceed
to step 1.
If you are training the second or third t
button, go directly to step 1.
HomeLink
® Universal Transceiver
HomeLink® is a registered trademark of Johnson
Controls., Inc.
Before programming HomeLink to operate a garage
door opener, confirm that the opener has an
external entrapment protection system, such as an
"electronic eye," or other safety and reverse stop
features. If it does not, HomeLink may not be able
to operate it.
Training HomeLinkHomeLink
® Universal Transceiver
Red Indicator
166Features
HomeLink
® Universal Transceiver
Training HomeLink
Training HomeLink
Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:
Training a Button1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the
HomeLink button you want to program.2. Press and hold the desired HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink after 10 secs?3. Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?
a. Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.
Does the LED blink within 20 secs?
4. Press and hold the HomeLink button again.
a. The remote has a rolling code. Press the
"learn" button on the remote-controlled
device (e.g. garage door opener). b. Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.
5. Press and hold the
HomeLink button again.
The remote-controlled
device should operate.
Training CompleteTraining
Complete
YESYES
NO
NO
NO
YES
Erasing Codes
To erase all the codes, press and hold the two
outside buttons until the HomeLink indicator begins
to blink (about 10 to 20 secs). You should erase all
codes before selling the vehicle.
If you have any problems, see the device's
instructions, visit
www.homelink.com
, or call
HomeLink at (800) 355-3515.
1. Press and hold the desired HomeLink button
until the HomeLink indicator begins to blink.2. Continue to hold the HomeLink button and
follow steps 1 - 3 under "Training a Button."
HomeLink LED
is on.
HomeLink indicator blinks for 2 secs,
then remains on.
Indicator remains on
for about 25 secs. Standard transmitter
Indicator blinks rapidly for
two secs, then remains on
for about 23 secs. Rolling code transmitter
