2011 Acura TSX hood release

4Quick Reference Guide
Visual Index
Driving Position Memory System Buttons
*
P.111
Door Mirror Controls
P.114
Driver's Front Airbag
P.36
Rearview Mirror
P.114
Passenger's Front Airbag
P.36
Passenger Side Fuse Box
P.296
Parking Brake
P.210
Glove Box
P.126
Accessory Power Socket
P.129
Shift Lever
Automatic Transmission
P.194

Manual Transmission
P.199
Trunk Release
P.95
Hood Release Handle
P.231
Driver Side Fuse Box
P.295
Power Window Switches
P.100
Power Door Lock Master Switch
(Unlocking Fuel Fill Door)
P.93
Driver’s Pocket

6Quick Reference Guide
Visual Index
Headlights
P.105, 247
Front Turn Signal/Parking/
Side Marker Lights
P.105, 252
Door Mirrors
P.114
Side Turn Signal Lights
P.105, 253
Maintenance Under the Hood
P.229
Windshield Wipers
P.108, 257
Door Lock/Unlock Control
P.91
Fog Lights
P.107, 251
Tires
P.259, 277
Opening/Closing the Trunk
P.95
Trunk Release Switch
P.96
Emergency Trunk Release Lever
P.97
Brake/Taillights
P.253
Rear Turn Signal Lights
P.253
Rear Side Marker Lights
P.253
Back-Up Lights
P.254
How to Refuel
P.216
Rearview Camera
*
See Navigation System Manual
High-Mount Brake Light
P.256

15Quick Reference Guide
Wiper Blades
P.257
Replace blades if they leave
streaks across the windshield.
Lights
P.247
Inspect all lights regularly.
Tires
P.259
Inspect tires and wheels regularly. Check tire pressures regularly. Install snow tires for winter driving.
Maintenance

P.221
Under the Hood
P.229
Check engine oil, engine coolant, and windshield washer fluid.
Add when necessary. Check brake fluid and clutch fluid. Check the battery regularly.
Pull the hood release handle under the corner of the
dashboard. Locate the hood latch lever, pull the lever up, and lift up the
hood. When finished, close the hood and make sure it is firmly
locked in place.

Security System
Security System Alarm
99Controls
Setting the security system alarm
The security system alarm automatically sets when the following conditions have
been met:
The ignition switch is in LOCK t
0
, and the key has been removed from the
ignition switch.
The hood is closed. t
All doors are locked. t
When the security system alarm sets
The security system indicator in the instrument panel blinks. When the blinking
interval changes after about 15 seconds, the security system is set. To cancel the security system alarm
The security system is canceled when the vehicle is unlocked using the key or
remote transmitter. The security system indicator goes off at the same time.
Security System Alarm
Do not set the security system alarm when someone
is in the vehicle or a window is open. The system
can accidentally activate when:
Unlocking the door with the lock tab or the tmaster door lock switch.
Opening the trunk with the release button on the tdriver's door or the emergency trunk opener.

If the battery goes dead after you have set the
security system alarm, the security alarm may go off
once the battery is recharged or replaced.
If this occurs, deactivate the security system alarm
by unlocking a door using the key or remote
transmitter.
Do not attempt to alter this system or add another
device to it.
The panic button on the remote
transmitter
If you press the panic button for
approximately one second, the following will
occur:
The horn sounds. t
Some exterior lights flash for about 30 t
seconds.
Panic Mode Canceling panic mode
Press any button on the remote transmitter, or turn the ignition switch to ON
II
.
Panic
Button

Adjusting the Seats
Adjusting the Seat Positions
118Controls
Adjusting the Head Restraints Adjusting the front and rear outer head restraint positionsYour vehicle is equipped with head restraints.
Head restraints are most effective for
protection against whiplash and other rear-
impact crash injuries when the center of the
back of the occupant's head rests against
the center of the restraint. The tops of the
occupant's ears should be level with the
center height of the restraint.Position head in the center
of the head restraint.
Adjusting the Head Restraints
The driver's and front passenger's seats have active
head restraints.
Active Head Restraints


P.12 2
WARNING
Improperly positioning head restraints
reduces their effectiveness and increases
the likelihood of serious injury in a crash.
Make sure head restraints are in place and
positioned properly before driving.
To raise the head restraint: Pull it upward.
To lower the head restraint: Push it down
while pressing the release button.

Maintenance Under the Hood
Opening the Hood
231
Continued
Maintenance
Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
lower left corner of the dashboard.

The hood will pop up slightly.
3. Push up the hood latch lever in the center
of the hood to release the lock mechanism,
and open the hood.
4-cylinder models 4. Remove the support rod from the clamp
using the grip. Mount the support rod in
the hood.
When closing, remove the support rod, and
stow it in the clamp, then gently lower the
hood. Remove your hand at a height of
approximately 12 inches (30 cm) and let the
hood close.
Opening the Hood NOTICE Do not open the hood when the wiper arms are
raised.
The hood will strike the wipers, and may damage
either the hood or the wipers.
When closing the hood, check that the hood is
securely latched.
If the hood latch lever moves stiffly, or if you can
open the hood without lifting the lever, the latch
mechanism should be cleaned and lubricated.
Grip
ClipSupport Rod
Hood Release Handle
Pull
Lever