2011.5 Peugeot 207 CC lock
[x] Cancel search: lockPage 7 of 224
ii
5
FAMILIARISATION
OPENING
Remote control key
A.
Unfolding/Folding the key.
B.
Unlocking the vehicle.
C.
Unlocking and partially opening the
boot.
65
Also...
D.
Normal locking
or
Deadlocking the vehicle.
Fuel tank
1.
Opening the fuel fi ller fl ap.
2.
Opening and hooking the fuel fi ller
cap.
Capacity of the tank: approximately
50 litres (petrol) or 48 litres (Diesel).
77
Boot
From outside
From inside
1.
Unlocking the vehicle or unlocking
the boot.
2.
Opening the tailgate.
1.
Key in the ignition switch.
2.
Unlocking using the manual cen-
tralised control or the door opening
control.
76
On Diesel vehicles, the fuel fi ller
neck incorporates a misfuel preven-
tion device which prevents fi lling
with petrol.
79
Page 8 of 224
! !
i
6
FAMILIARISATION
OPENING
Retractable roof
When washing your vehicle:
- lock the vehicle,
- avoid spraying the upper part
of the windows,
- keep the end of the high-pres-
sure nozzle at least 1 metre
from the windows and door
seals.
After washing the vehicle or fol-
lowing rain, wait until the roof has
dried before opening it. The roof is operated under the
sole responsibility of the driver.
During operation of the roof, to
avoid the risk of injury, ensure
that no one is in the vicinity of the
moving parts.
You are strongly advised not to
operate the roof in strong winds. It is preferable to operate the roof
with the engine running.
The roof can be operated at
speeds below 6 mph (10 km/h).
It is only possible to carry out the
operation twice with the engine off,
to prevent discharging of the bat-
tery.
Preliminary conditions
)
Switch on the ignition.
)
Ensure that:
- the vehicle is not in energy econo-
my mode (refer to the correspond-
ing section),
- the battery voltage is suffi cient
(switching on of the indicator lamp
on the roof control),
- the roof fuse is in good condition (re-
fer to the corresponding section),
- the electric windows are initialised
(refer to the corresponding section),
- the ambient temperature is above
-15 °C.
Precautions to be taken before
operating the roof
)
Park the vehicle on level ground.
)
Check that no object could hinder
the operation of the roof:
- nothing should be placed on the
moving rear shelf 1
or on the net 2
,
- if luggage is being carried in the
boot, it must not raise the net,
)
Ensure that the net 2
is secure.
)
Close the boot correctly.
Maintenance
Carry out a complete roof opera-
tion at least once a month to keep
it in good working order.
Page 9 of 224
i
!
!
7
FAMILIARISATION
OPENING
Operating the retractable roof
Opening the roof
)
Pull this control until the roof
is fully open.
Closing the roof
)
Press this control until the
roof is fully closed.
If you continue to pull or press this
button after the end of the operation,
the four windows close.
Do not release the roof control during
a roof operation.
However, in the event of danger, re-
lease the control, the roof stops; then,
when the danger is no longer present,
complete the required operation.
If the operation has not been com-
pleted, you will be warned by an au-
dible signal and a message on the
multifunction screen. These will be
repeated when the vehicle reaches a
number of speed thresholds.
Changing to "cabriolet"
confi guration:
- the four windows lower,
- the boot opens,
- the roof folds into the boot,
- the boot closes.
The electric window controls and
the control for the four windows
are deactivated during roof opera-
tions.
The roof electronic control unit
may stop the current operation
as a precaution (example: door
movement and roof operation in
quick succession). In this case,
release the control then activate
it again to complete the required
operation.
Operating fault
If a malfunction of the roof occurs,
apply the parking brake, switch
off the ignition, restart the engine,
then start the required operation
again.
If the problem persists, contact a
PEUGEOT dealer.
Changing to "coupé" confi guration:
- the four windows lower,
- the boot opens,
- The roof opens out and locks auto-
matically,
- the boot closes. The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.
The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.
Page 11 of 224
9
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1.
Audio equipment steering mounted
control.
2.
Steering lock and ignition.
3.
Wipers/screenwash/trip computer
control stalk.
4.
Instrument panel.
5.
Driver’s airbag.
Horn.
6.
Dynamic stability control
(ESP/ASR) button.
Central locking button.
Alarm button.
7.
Gear lever.
8.
Parking brake.
9.
Retractable roof control.
Control for the four windows.
10.
Door mirror controls.
Electric window controls.
11 .
Headlamp height adjustment.
12.
Door window demist/defrost vent.
13.
Side adjustable air vent.
14.
Windscreen demist/defrost vent.
Page 13 of 224
i
!
11
FAMILIARISATION
SITTING COMFORTABLY
Also...
5.
Access to the rear seats.
Front seat adjustment
Steering wheel adjustment
1.
Forwards-backwards adjustment.
2.
Height adjustment.
3.
Seat back angle adjustment.
4.
Head restraint height adjustment.
52
1.
Unlocking the steering wheel adjust-
ment.
2.
Height and reach adjustment.
3.
Locking the steering wheel adjust-
ment.
As a safety precaution, it is im-
perative that these operations are
carried out when stationary.
54
Page 17 of 224
15
FAMILIARISATION
MONITORING
Instrument panel
Switch panel
A.
With the ignition on, the fuel gauge
needle should rise.
B.
With the engine running, the associ-
ated low level warning lamp should
switch off.
C.
With the ignition on, the oil level in-
dicator should display "OIL OK"
for
a few seconds.
If the levels are not correct, top up the
level which is low.
20
Lighting of the indicator lamp indicates
the status of the corresponding function.
A.
Deactivation of the ESP/ASR system.
97
B.
Central locking.
74
C.
Deactivation of the interior volumetric
protection alarm.
69
1.
With the ignition on, the orange and
red warning lamps come on.
2.
With the engine running, these
warning lamps should switch off.
If a warning lamp remains on, refer to
the page concerned.
21
Warning lamps
Page 27 of 224
1INSTRUMENTS and CONTROLS
25
Warning lamp
is on
Cause
Action/Observations
Anti-lock
Braking
System
(ABS)
fi xed. The anti-lock braking
system has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact
a PEUGEOT dealer or a qualifi ed workshop
without delay.
Dynamic
stability
control
(ESP/ASR)
fl ashing. The ESP/ASR regulation is
active. The system optimises traction and improves the
directional stability of the vehicle.
fi xed. Unless it has been
deactivated (button pressed
and its indicator lamp on) the
ESP/ASR system has a fault. Have it checked by a PEUGEOT or a qualifi ed
workshop.
Engine
autodiagnosis
system
fl ashing. The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer or a
qualifi ed workshop.
fi xed. The emission control
system has a fault. The warning lamp should go off when the engine
is started.
If it does not go off, contact a PEUGEOT dealer
or qualifi ed workshop without delay.
Low fuel
level
fi xed.
When it fi rst comes on there
remains approximately
5 litres of
fuel
in the tank. You must refuel as soon as possible to avoid
running out of fuel.
This warning lamp will come on every time the
ignition is switched on, until a suffi cient addition
of fuel is made.
Fuel tank capacity: approximately 50 litres
(petrol) or 48 litres (Diesel).
Never continue to drive until you run out of fuel
as this could damage the emission control and
injection systems.
Page 31 of 224
1
i
i
INSTRUMENTS and CONTROLS
29
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into
account.
Service indicator zero reset
After each service, the service indicator
must be reset to zero.
The procedure for resetting to zero is as
follows:
)
switch off the ignition,
)
press and hold the trip distance re-
corder zero reset button,
)
switch on the ignition; the distance re-
corder display begins a countdown,
)
when the display indicates "=0"
, re-
lease the button; the spanner disap-
pears.
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Service overdue
For 5 seconds after the ignition is
switched on, the spanner fl ashes
to
indicate that the service must be carried
out as soon as possible.
Example:
the service is overdue by
300 km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the distance recorder resumes its
normal operation. The spanner re-
mains
on
.