2011.5 Citroen DS4 RHD display

195
Driving
With the engine running and the vehiclestationary, in order to immobilise the vehicleit is essential to manuallyapply the parking
brake by pulling
control lever A.


Immobilising the vehicle,
engine running


The emergency braking must only beused in exceptional circumstances.


Before leaving the vehicle, ensurethat parking brake warning lamp inthe instrument panel is on fixed, not flashing. The application of the parkin
g brake is confirmed by:
- illumination of the brakin
g
warning lamp and the Pwarning lamp in the control lever A ,
- displa
y of the message"Handbrake on".
When the driver’s door is opened, a messa
ge is
displa
yed accompanied by an audible signal, if
the parking brake has not been applied, except
in the case of an automatic gearbox with thegear lever in position P.P
Particular situations
In cer tain situations (e.g. star ting the engine),
the parking brake can automatically alter its force. This is normal operation.
To advance
your vehicle a few centimetres without star ting the engine, but with the ignition
on, press on the brake pedal and release the
parking brake by pulling
then releasing
the control lever A. The full release of the parkingbrake is confirmed by the warning lampsin the control lever A
and in the instrumentpanel going off and display of the message"Handbrake off".
If the parking brake develops a fault while appliedor if the battery runs flat, an
emergency release is always possible.



Emergency braking



In the event of failure of the electronicstability control system, signalled
by the illumination of this warning
lamp, braking stability is then not guaranteed.
In this event, stability must be assured by thedriver by repeating alternate "pull-release" actions on the control lever A.

In the event of a failure of the main servicebrake or in an exceptional situation (e.g. driver
taken ill, under instruction, etc) a continuous
pull on the control lever Awill stop the vehicle.
The electronic stability control provides stability
durin
g emergency braking.
If the emergency braking malfunctions,
the message "Parking brake faulty" will be
displayed.

Operating faults
If the electric parking brake malfunction warning lamp comes on together with one or more of the warning lamps presented in these tables, place the
vehicle in a safe condition (on level ground, gear engaged) and contact a CITROËN dealer or a qualified workshop without delay.
SituationsConsequences
Display of the message "Parking brake fault" and of thefollowing warning lamps:

- The automatic functions are deactivated.

- Hill start assist is not available.

- The electric parking brake can only be used manually.
Displa
y of the message "Parking brake fault" and of thefollowing warning lamps:

- Manual release of the electric parking brake is only available by pressing the
accelerator pedal and releasing the control.

- Hill
start assist is not available.

- The automatic functions and the manual application are still available.
Display o
f the message "Parking brake fault" and of thefollowing warning lamps:

- The automatic functions are deactivated.

- Hill start assist is not available.

199Driving
SituationsConsequences
To a p p l
y the electric parking brake:)
immobilise the vehicle and switch off the ignition. )
pull the control for at least 5 seconds or until application is complete.)
switch on the ignition and check the switching on of the electric parking brake
warning lamps.
The application is slower than during normal operation.
To release the electric parkin
g brake:)
switch on the ignition.)
pull the control and hold it for approximately 3 seconds then release it.
If the braking warning lamp is flashing or if the warning lamps do not come on with
the ignition on, these procedures will not work. Place the vehicle on level ground
and have it checked by a CITROËN dealer or a qualified workshop. and possibl
y


flashin
g

Display of the message "Parking brake fault" and of thefollowing warning lamps:

- Only the automatic application on switching off the engine and automatic
release on acceleration functions are available.

- The manual application/release of the electric parking brake and theemergency braking are not available.
an
d possibly
flashin
g



Battery fault:

- If the battery warning lamp comes on you must stop immediately as soon as
the traffic allows. Stop and immobilise your vehicle (if necessary, place the
two chocks under the wheels).

- Apply the electric parking brake before switching off the engine.

Gear lever positions
N. Neutral R.Reverse1, 2, 3, 4, 5, 6.
Gears in sequential mode. AUTO.
This comes on when the automated mode is selected. It switches off on changing to sequential mode.
Displays in the instrument panel

Moving off
N
flashes in the instrument panel, accompanied by an audible signal and a message in the multifunction screen, if the gear lever is not in position Non starting.
)
Select position N . )
Press the brake pedal down fully.)
Start the engine.
Nappears in the instrument panel
screen.
)Select automated mode (position A) or Asequential mode (position M) or reverse(position R). R)Release the parking brake unless it is programmed to automatic mode.)Progressively take your foot off the brake pedal. )Accelerate away.
AUT
Oand 1 , 1
or Rappear in the
instrument panel screen.

You must press the brake pedal when starting the engine.
The Foot on brake
warning lamp comes on the instrument panel, accompanied by anaudible signal and a message in thescreen, if the brake pedal is not pressedon starting the engine.

Driving














Automatic gearbox


Gear selection gate
Six speed automatic gearbox which offers a
choice between the comfor t of fully automatic
operation, enhanced by spor t and snow programmes, or manual gear changing.
Four driving modes are offered:-automatic
operation for electronic
management of the gears by the gearbox,-sport
programme for a more dynamic style
of driving,
-
snowprogramme to improve driving when
traction is poor,

- manualoperation for sequential changing
of the gears by the driver.
1.
Gear lever. 2.Button "S"(sport).
3.Button "7"(snow).
Gear lever
P.Park.
- Immobilisation of the vehicle, parking brakeon or off.
- Starting the engine.R.
Reverse.
- Reversing manoeuvres, vehicle stationary,
engine at idle.
N.Neutral.
- Immobilisation of the vehicle, parking brakeon.
- Starting the engine.D.
Automatic operation. M +/-. Manual operation with sequential changing of the six gears. )
Press for wards to change up through thegears. or )
Press rear wards to change down through
the gears.



Displays in the instrument panel

When you move the lever in the gate to select
a position, the corresponding indicator is
displayed in the instrument panel. P. ParkR.Reverse
N.
NeutralD.Drive (Automatic driving) S.Sport
programme 7.Snowprogramme
1 to 6. Gear engaged during manual operation -.
Invalid value during manual operation

Driving

Manual operation
)
Select position Mfor sequential
changing
of the six gears. ) Push the lever towards the +sign to change up a gear.
)
Pull the lever towards the -
sign to change
down a gear.
It is onl
y possible to change from one gear to
another if the vehicle speed and engine speed
permit; otherwise, the gearbox will operate
temporarily in automatic mode.
Ddisappears and the gearsengaged appear in succession in the
instrument panel.
I
f the engine speed is too low or too high, the
gear selected flashes for a few seconds, then
the actual gear engaged is displayed.
It is possible to chan
ge from position D(automatic) to position M
(manual) at any time.
When the vehicle is stationary or moving
very slowly, the gearbox selects gear M1automatically.
The spor t and snow programmes do not operate in manual mode.

Sport and snow programmes


Sport programme "S"
)Press button "S"
, after star ting the engine.
The gearbox automatically favours a dynamicstyle of driving.
S
appears in the instrument panel.


Snow programme "7
"
)Press button "7", after star ting the engine.
The gearbox adapts to driving on slipperyroads.
This programme improves star ting and drive
when traction is poor.
7appears in the instrument panel.

Return to automatic
operation
)
At any time, press the button selected
again to quit the programme engaged andreturn to auto-adaptive mode.
These two special pro
grammes supplement the
automatic operation in very specific conditions of use.

Invalid value during manualoperation
This symbol is displayed if a gear
is not engaged correctly (selector
between two positions).

Stopping the vehicle
Before switching off the engine, you canengage position Por N
to place the gearbox in neutral.
In both cases, apply the parking brake toimmobilise the vehicle, unless it is programmedto automatic mode.

If the lever is not in position P, when thePdriver's door is opened or approximately45 seconds after the ignition is switched off, there is an audible signal and amessage appears.)Return the lever to position P
; the audible signal stops and themessage disappears.


Operating fault

When the ignition is on, the lighting of this
warning lamp, accompanied by an audible
signal and a message in the multifunction
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to back-up
mode and is locked in 3rd
gear. You may feel
a substantial knock when changing from Pto R
and from N
to R
. This will not cause any
damage to the gearbox.
Do not exceed 60 mph (10 0 km/h), local speed restrictions permitting.
Have it checked by a CITROËN dealer or aqualified workshop.
This warning lamp may also come on if a door
is opened.
You risk damaging the gearbox:


- if you press the accelerator and brake pedals at the same time,

- if you force the lever from position Pto another position when the batteryis flat.

To reduce fuel consumption when stationary for long periods with the engine running (traffic jam...), positionthe gear lever at Nand apply theparking brake, unless it is programmed in automatic mode.

213Driving

Going into engine START mode
The "ECO"warning lamp goes off and the engine star ts automatically:
-with a manual gearbox
, when you fullydepress the clutch pedal,-with the 6-speed electronic gearbox
system:●
gear lever in position Aor M
, when yourelease the brake pedal,
●
or gear lever in position Nand the brake pedal released, when you move the gear lever to position A
or M,●
or when you engage reverse gear.


Special cases: START invoked automatically

If the system has been deactivatedin STOP mode, the engine restar ts immediately.

With a manual gearbox in STOP mode,if a gear is engaged without fullydepressing the clutch pedal,a warning lamp comes on or an aler t message is displayed asking you to depress the clutch pedal to restar t
the engine.
At any time, press the "ECO OFF"
switch todeactivate the system.
This is confirmed by the switch warning lamp coming on accompanied by the display of amessage.


Deactivation
In this case the "ECO"warning lamp flashes for few seconds, then goesof f.
This operation is per fectly normal.
For safety reasons or to ensure smooth
operation, START mode is invoked
automatically when:
- you open the driver’s door,
- you unfasten the driver’s seat belt,
- the speed of the vehicle exceeds 15 mph (25 km/h) with a manual gearbox or 7 mph (11 k m/h) with the 6 -speed electronic
gearbox system,
- the electric parkin
g brake is being applied,
- some special conditions (battery charge,engine temperature, braking assistance,
ambient temperature...
) where the engine is
needed to assure control of a system.