2011.5 Citroen DS4 RHD warning

109Access

This system allows automatic simultaneous locking of the doors and boot as soon as the speed of the vehicle exceeds 6 mph (10 km/h).

Anti-intrusion security


Operation
Activation/Deactivation
You can activate or deactivate this function permanently.
)
With the ignition on, press this buttonuntil an audible signal star ts and a corresponding message is displayed. If one of the doors or the boot is open,
the automatic central lockin
g does not takeplace.
This is signalled by the sound of the locks rebounding, accompanied byillumination of this warning lamp in the
instrument panel, an audible signal
and the displa
y of an aler t message.
Carrying long and voluminousobjects If you want to drive with the boot open, you should press the central locking button to lock the the doors. Other wise,
every time the speed of the vehicle exceeds 6 mph (10 km/h), the lockswill rebound and the alerts mentioned above will appear.


In the event of a serious impact with deployment of an airbag, the vehicle's doors unlock automatically to allow theexit of occupants and access for the security services.
Pressin
g the central locking button unlocks
the vehicle.
Above 6 mph (10 km/h), this locking is
temporary. The state o
f the system stays in memory when
switchin
g off the ignition.

113Access











Doors


Opening


From outside
)After unlocking the vehicle completely
using the remote control or the key, pull thedoor handle.


From inside
)
Pull the interior control lever of a front door;
this unlocks the vehicle completely.




Closing

When a door is not closed correctly:
- when the en
gine is running,this warning lamp comes
on, accompanied by an aler t
message for a few seconds,
-when the vehicle is moving (speed higher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an alertmessage for a few seconds.

When the selective unlocking isactivated, the first press of the remotecontrol unlocking button permitsunlocking of the driver's door only.
With the selective unlocking activated:- opening the driver’s door unlocks the driver’s door only (if the vehiclehas not already been completely unlocked). - opening the passenger’s door unlocks the rest of the vehicle. The interior door controls donot operate when the vehicle is deadlocked.

115
Access

















Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot. ) Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )
Move the latch to the left.
)After unlocking the boot or the vehicle
using the remote control or the key, press
the openin
g control, then raise the tailgate.

Opening Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate
to fully close it.
-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal andthe display of an aler t message for a fewseconds.



Locking after closing

If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:

Fuel tank Capacity of the tank: approximately 60 litres.
Low fuel level

When the low fuel level in the
tank is reached, this warning lamp comes on in the instrument panel,
accompanied by an audible warning and the display of an aler t message. When it first comes on, around 6 litres of fuel remain
in the tank.
Until sufficient fuel has been added, every time
the ignition is switched on, this warning lampappears, accompanied by an audible signal and an aler t message. When driving, this audiblesignal and the display of this aler t message are repeated with increasing frequency, as the level
drops towards 0 .
You must refuel as soon as possible to avoid
running out.
If you run out of fuel (Diesel), refer also to
"Checks".


Refuelling
)Press control A
until the automatic openingof the fuel flap is heard.
This control remains active for a few
minutes after switching off the ignition.
If necessary, switch the ignition on again
to reactivate it.)Take care to select the pump that delivers
the correct fuel for your vehicle.
With Stop & Star t, never refuel with the system in STOP mode; you must switch off the ignition with the key. Additions of fuel must be of at least
5 litres to be registered by the fuel gauge.
Opening the filler cap may result in an inrush of
air. This vacuum is entirely normal and results from the sealing of the fuel system.

127Visibility

Switching off the lighting when switching off the ignition

When the ignition is switched off, allof the lamps switch off immediately, except for the dipped beam headlamps if automatic guide-me-home lighting is activated.
Temporarily keeping the dipped beamheadlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor.
Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A further "headlamp flash" switches thefunction off.

Switching off
The manual guide-me-home lighting switches
o
ff automatically after a set time.
Manual guide-me-home
lighting

Switching on the lightingwhen switching on the ignition
To reactivate the lighting control stalk, turnthe ring Ato position A"0"
- lighting off, then to the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that they have forgotten to switchoff the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down dependin
g on the traffic side(for example: when parking on the left;
lighting control stalk upwards; the right hand sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the central position.

When a low level of ambient light is detected by a sunshine sensor, the number plate
lamps, sidelamps and dipped beam headlamps are switched on automatically, without any action on the par t of the driver. They can also come on if rain is detected, at the same time as automatic operation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lamps are switched off automatically.
Automatic illumination of
headlam
ps
Activation
)
Turn the ring to the "AUTO"
position. The
activation of the function is accompanied
by the display of a message in the screen.


Deactivation
)
Turn the ring to another position.
Deactivation of the function isaccompanied by the display of a message
in the screen.
Automatic "guide-me-
home" li
ghting

Operating fault
In the event of a malfunction of
the sunshine sensor, the lighting comes on, this warning lamp is
displayed in the instrument panel and/or a
message appears in the screen, accompanied by an audible signal.
Contact a CITROËN dealer or a qualified
workshop.
In fog or snow, the sunshine sensor may detect sufficient light. In thiscase, the lighting will not come on automatically.
Do not cover the sunshine sensor,coupled with the rain sensor and located in the centre of the windscreen
behind the rear view mirror; theassociated functions would no longer be controlled.
When the automatic illumination of headlamps
function is activated, under low ambient
li
ght the dipped beams headlamps come on
automatically when the ignition is switched off.

Programming
Activation or deactivation, as well
as the duration of the guide-me-home lighting, is set in the vehicle configuration menu.

Automatic adjustment of xenon headlamps
Do not touch the xenon bulbs. Contact a CITROËN dealer or a
qualified workshop. This s
ystem adjusts the height of the xenon
headlamp beams automatically and when
stationary, according to the load in the vehicle, so
as to avoid causing a nuisance to other road user.
I
f a malfunction occurs, this
warning lamp is displayed in the
instrument panel, accompanied byan audible signal and a message in the screen.
The system then places your headlamps in the lowest position.







Manual adjustment
of halogen
headlamps
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle.0.1 or 2 people in the front seats. -.3 people.1. 5 people.-.Intermediate setting. 2.
5 people + maximum authorised load. -.Intermediate setting. 3.
Driver + maximum authorised load.
The initial setting is position "0".

131Visibility








Directional lighting


When the dipped or main beam headlamps
are on, this function, allows the light beams to better follow the road.
The use of this function, coupled with the
xenon headlamps and the cornerin
g lighting,
considerably improves the quality of your lighting round bends.
Thi
s function is inactive:


- when stationary or at low speeds,

- when reverse is engaged.

The s
ystem is activated by default. with directional lighting
without directional lighting


Programming
The system is activated or deactivated in the vehicle configuration menu.
The state o
f the system stays in memory onswitching off the ignition.
Contact a CITRO
ËN dealer or a qualified
workshop.

Operating fault
If a fault occurs, this warning lamp
flashes in the instrument panel,
accompanied by a message in the screen.