2011.5 Citroen DS4 RHD warning

195
Driving
With the engine running and the vehiclestationary, in order to immobilise the vehicleit is essential to manuallyapply the parking
brake by pulling
control lever A.


Immobilising the vehicle,
engine running


The emergency braking must only beused in exceptional circumstances.


Before leaving the vehicle, ensurethat parking brake warning lamp inthe instrument panel is on fixed, not flashing. The application of the parkin
g brake is confirmed by:
- illumination of the brakin
g
warning lamp and the Pwarning lamp in the control lever A ,
- displa
y of the message"Handbrake on".
When the driver’s door is opened, a messa
ge is
displa
yed accompanied by an audible signal, if
the parking brake has not been applied, except
in the case of an automatic gearbox with thegear lever in position P.P
Particular situations
In cer tain situations (e.g. star ting the engine),
the parking brake can automatically alter its force. This is normal operation.
To advance
your vehicle a few centimetres without star ting the engine, but with the ignition
on, press on the brake pedal and release the
parking brake by pulling
then releasing
the control lever A. The full release of the parkingbrake is confirmed by the warning lampsin the control lever A
and in the instrumentpanel going off and display of the message"Handbrake off".
If the parking brake develops a fault while appliedor if the battery runs flat, an
emergency release is always possible.



Emergency braking



In the event of failure of the electronicstability control system, signalled
by the illumination of this warning
lamp, braking stability is then not guaranteed.
In this event, stability must be assured by thedriver by repeating alternate "pull-release" actions on the control lever A.

In the event of a failure of the main servicebrake or in an exceptional situation (e.g. driver
taken ill, under instruction, etc) a continuous
pull on the control lever Awill stop the vehicle.
The electronic stability control provides stability
durin
g emergency braking.
If the emergency braking malfunctions,
the message "Parking brake faulty" will be
displayed.

Operating faults
If the electric parking brake malfunction warning lamp comes on together with one or more of the warning lamps presented in these tables, place the
vehicle in a safe condition (on level ground, gear engaged) and contact a CITROËN dealer or a qualified workshop without delay.
SituationsConsequences
Display of the message "Parking brake fault" and of thefollowing warning lamps:

- The automatic functions are deactivated.

- Hill start assist is not available.

- The electric parking brake can only be used manually.
Displa
y of the message "Parking brake fault" and of thefollowing warning lamps:

- Manual release of the electric parking brake is only available by pressing the
accelerator pedal and releasing the control.

- Hill
start assist is not available.

- The automatic functions and the manual application are still available.
Display o
f the message "Parking brake fault" and of thefollowing warning lamps:

- The automatic functions are deactivated.

- Hill start assist is not available.

199Driving
SituationsConsequences
To a p p l
y the electric parking brake:)
immobilise the vehicle and switch off the ignition. )
pull the control for at least 5 seconds or until application is complete.)
switch on the ignition and check the switching on of the electric parking brake
warning lamps.
The application is slower than during normal operation.
To release the electric parkin
g brake:)
switch on the ignition.)
pull the control and hold it for approximately 3 seconds then release it.
If the braking warning lamp is flashing or if the warning lamps do not come on with
the ignition on, these procedures will not work. Place the vehicle on level ground
and have it checked by a CITROËN dealer or a qualified workshop. and possibl
y


flashin
g

Display of the message "Parking brake fault" and of thefollowing warning lamps:

- Only the automatic application on switching off the engine and automatic
release on acceleration functions are available.

- The manual application/release of the electric parking brake and theemergency braking are not available.
an
d possibly
flashin
g



Battery fault:

- If the battery warning lamp comes on you must stop immediately as soon as
the traffic allows. Stop and immobilise your vehicle (if necessary, place the
two chocks under the wheels).

- Apply the electric parking brake before switching off the engine.

Manual parking brake
)Pull the parking brake lever fully up toimmobilise your vehicle.



Releasing
)
Pull the parking brake lever up gently,
press the release button then lower the
lever fully.
When parking on a slope, direct your wheels against the kerb, apply the
parking brake, engage a gear andswitch off the ignition.

When the vehicle is being driven,
if this warning lamp and the STOP
warning lamp come on, accompanied
by an audible signal and a message in the
multifunction screen, this indicates that the
parkin
g brake is still on or has not been
properly released.

Gear lever positions
N. Neutral R.Reverse1, 2, 3, 4, 5, 6.
Gears in sequential mode. AUTO.
This comes on when the automated mode is selected. It switches off on changing to sequential mode.
Displays in the instrument panel

Moving off
N
flashes in the instrument panel, accompanied by an audible signal and a message in the multifunction screen, if the gear lever is not in position Non starting.
)
Select position N . )
Press the brake pedal down fully.)
Start the engine.
Nappears in the instrument panel
screen.
)Select automated mode (position A) or Asequential mode (position M) or reverse(position R). R)Release the parking brake unless it is programmed to automatic mode.)Progressively take your foot off the brake pedal. )Accelerate away.
AUT
Oand 1 , 1
or Rappear in the
instrument panel screen.

You must press the brake pedal when starting the engine.
The Foot on brake
warning lamp comes on the instrument panel, accompanied by anaudible signal and a message in thescreen, if the brake pedal is not pressedon starting the engine.

Invalid value during manualoperation
This symbol is displayed if a gear
is not engaged correctly (selector
between two positions).

Stopping the vehicle
Before switching off the engine, you canengage position Por N
to place the gearbox in neutral.
In both cases, apply the parking brake toimmobilise the vehicle, unless it is programmedto automatic mode.

If the lever is not in position P, when thePdriver's door is opened or approximately45 seconds after the ignition is switched off, there is an audible signal and amessage appears.)Return the lever to position P
; the audible signal stops and themessage disappears.


Operating fault

When the ignition is on, the lighting of this
warning lamp, accompanied by an audible
signal and a message in the multifunction
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to back-up
mode and is locked in 3rd
gear. You may feel
a substantial knock when changing from Pto R
and from N
to R
. This will not cause any
damage to the gearbox.
Do not exceed 60 mph (10 0 km/h), local speed restrictions permitting.
Have it checked by a CITROËN dealer or aqualified workshop.
This warning lamp may also come on if a door
is opened.
You risk damaging the gearbox:


- if you press the accelerator and brake pedals at the same time,

- if you force the lever from position Pto another position when the batteryis flat.

To reduce fuel consumption when stationary for long periods with the engine running (traffic jam...), positionthe gear lever at Nand apply theparking brake, unless it is programmed in automatic mode.

211Driving
System which keeps your vehicle immobilised
temporaril
y (approximately 2 seconds) whenstarting on a gradient, the time it takes to move your foot from the brake pedal to the
accelerator pedal.
This function is onl
y active when:


- t
he vehicle is completely stationary, with your foot on the brake pedal,

- when cer tain conditions of gradient are met,

- with the driver’s door closed.
The hill start assist function cannot bedeactivated.






Hill start assist
On an ascending slope, with the vehicle
stationary, the vehicle is held for a brief moment when you release the brake pedal:- if you are in first gear or neutral with a
manual gearbox,
- if you are in position A
or Mwith the electronic gearbox system,
- if you are in position D
or Mwith an
automatic gearbox.
Operation

Operatin
g fault

If a fault occurs with the system, these warninglamps come on. Contact a CITROËN dealer or a qualified workshop to have the system
checked.


Do not leave the vehicle while it is being held in the hill star t assist phase.
If you need to leave the vehicle whilethe engine is running, apply the parking brake manually then ensure that theparking brake warning lamp is on (notflashing) in the instrument panel.On a descending slope, with the vehicle
stationar
y and reverse gear engaged, thevehicle is held for a brief moment when you
release the brake pedal.

Stop & Start The Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...).
The engine restar ts automatically - START mode - as soon as you want to move off. The restar t takes place instantly, quickly and silently.
Per
fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
With the electronic gearbox system, for your comfor t during parking maoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such asbraking, power steering, for example.
Never refuel with the engine in STOPmode; you must switch off the ignition with the key. Th
e "ECO"warning lamp comes on
in the instrument panel and the engine goes into standby automatically:
-with a manual gearbox , at speeds below
12 mph (20 km/h), when you put the gear lever into neutral and release the clutchpedal,
- with the 6-speed electronic gearbox
system, at a speed below 5 mph (8 km/h),
when you press the brake pedal or put thegear lever into position N.
If your vehicle is fitted with the system, a time counter calculates
the sum o
f the periods in STOP
mode during a journey. It resets
itself to zero every time the ignition
is switched on with the key.
STOP mode is not invoked when:


- the driver’s door is open,

- the driver’s seat belt is not fastened,

- the vehicle has not exceeded 6 mph
(10 km/h) since the last engine start usingthe key,

- the electric parking brake is applied or
being applied,

-the engine is needed to maintain a comfortable
temperature in the passenger compartment,
- demisting is active,

- some special conditions (battery charge, engine temperature, braking assistance,ambient temperature...) where the engine isneeded to assure control of a system.


Special cases: STOP modeunavailable

In this case, the "ECO"
warning lamp
flashes for a few seconds, then goes off.
This operation is per fectly normal.