Page 117 of 396

115
Access
Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot. ) Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )
Move the latch to the left.
)After unlocking the boot or the vehicle
using the remote control or the key, press
the openin
g control, then raise the tailgate.
Opening Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate
to fully close it.
-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal andthe display of an aler t message for a fewseconds.
Locking after closing
If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:
Page 139 of 396
137
Visibility
B. Rear wiper selection ring: turn the ringto place the desired symbol against the
marking.
If a significant accumulation of snow or ice is present, or when using a tailgate bicycle carrier, deactivate the automatic rear wiper via the vehicle configurationmenu.
Park.
Intermittent wipe.
Wash-wi
pe.
Turn the ring to its stop/the rear screen wash, then the rear wiper operates for a set duration.
Reverse gear
When reverse gear is engaged, the rear wiper will come into operation if the windscreen wipers are operating.
Programming
Rear wiper
The function is activated or deactivated via the vehicle configuration menu.
This function is activated by default.
Page 263 of 396

261Practical information
1.Brake lamps (P21/5W).2.Sidelamps (LEDs).3.Direction indicators (PY21W amber)4.Reversing lamp (P21W).5. Rear foglamps (P21W).
Rear lamps
Amber bulbs, such as those for thedirection indicators, must be replaced by bulbs of the same rating and colour. The lamps on the tailgate, other than the guide lamps, are dummy units. They are there for aestheticpurposes only.
Changing stop lamp, reversing lamp and direction indicator bulbs
These three bulbs are changed from inside the boot:
)
open the boot, )
remove the access grille from thecorresponding side trim panel, )
slacken the two nuts using a 10 mm tube spanner then remove the nuts by hand, )
unclip the lamp unit connector, )
extract the lamp unit carefully pulling in its
middle towards the outside,
) remove the foam seal, )
unclip the two small secondary connectors, )
spread the two tabs and remove the bulb holder, )
turn the bulb a quarter of a turn andchange it.
To reassemble, carry out these operations in
reverse order.
Take care to en
gage the lamp unit in its guides,
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
Page 264 of 396
Changing the LED lamps/sidelamps Number plate lamps (W5W)
Third brake lamp (LEDs)
For the replacement of this type of LED lamp,contact a CITROËN dealer or a qualified
workshop. For the replacement of this type of LED lamp,contact a CITROËN dealer or a qualified
workshop. To
facilitate the removal of the lamp, carry out
this operation with the tailgate half open. ) Insert a thin screwdriver into the lenscutout. )
Push it outwards. )
Remove the lens. )
Change the faulty bulb.
To refit, press on the lens to clip it in place.