Page 76 of 332
74
Access
Locking the vehicle with
perimeter monitoring only
Deactivate the interior volumetric and tiltmonitoring to avoid unwanted triggering of thealarm in cer tain cases, such as:
- an animal left in the vehicle,
- a window left par tly open,
- washing your vehicle.
Deactivation of the interior volumetric and tilt monitoring
Raise and hold the wiper control stalk in the
" MIST " position for about three seconds to
activate them again, the audible signal sounds
twice.
) Switch off the ignition and remove thekey from the ignition switch (OFF mode if your vehicle has the "Keyless Entry andStarting" system). )
Raise and hold the wiper control stalk in
the "MIST"
position for about 3 seconds. )
The audible signal sounds once
and the
interior volumetric and tilt monitoring are
deactivated.
Page 77 of 332
75
2
Access
Tr iggering of the alarm
This is indicated by sounding of the siren andflashing of the direction indicators for thirtyseconds.
A message then appears in the instrument
panel screen while the siren is operating.
When the ignition is next switched on (ONmode if your vehicle has the "Keyless Entry and Starting" system), an audible signal sounds four
times to inform you that the alarm was triggeredduring your absence.
Complete deactivation of
the alarm
)
Switch off the ignition (OFF mode if your vehicle has the "Keyless Entry andStarting" system). )
Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
Entry and Star ting" system. ) Open the driver's door. )
Place the lighting control stalk in the "OFF"position. )
Pull the wiper control stalk towards you and
hold.
After about ten seconds there is an audible signal. ) When the audible signal stops, continue to
hold the wiper stalk pulled towards you and
press the remote control locking button.
You can completely deactivate the alarm
system. To do this, proceed as follows:
) The state of the system is then signalled to you by the number of beeps:
One beep: the alarm system is completely deactivated.
Two beeps: the alarm system is activated.
Each new press of the remote control
lockin
g button changes the state of thesystem.
It is possible to adjust the sensitivity
of the alarm sensor and to deactivatethe function via the colour screen"Equipment" menu.
Page 88 of 332
86
Comfort
From the outside: ) by locking or unlocking the vehicle,using the remote control or the locking / unlocking buttons (for vehicles fitted with
the "Keyless Entry and Starting" system).
If you have folded the mirrors using thecontrol C
, you must use this control tounfold them, other wise the mirrors will not be lock in place correctly.
Some mirror functions (in particular the automatic folding and unfolding of the door mirrors) can be configured via thecolour screen "Equipment" menu.
The mirrors can also be foldedmanually. From inside:
- with the i
gnition switch in the "ON" or "ACC" position, by pressing the control C,
- with the ignition switch in the "LOCK"
position, by pressing control C, within30 seconds.
Page 101 of 332
99
3
Comfort
Mat
When removing the mat on the driver's side, move back the seat as far as possible and
remove the fixings.
When refitting, position the mat correctly on thepins and clip the fixings. Check that the mat issecured firmly.
To prevent any risk of jamming under thepedals:
- only use mats suited to the fixings already present in the vehicle; it is imperative that
these fixings are used.
- never fit one mat on top of another.
Sun visor
Glove box
It has dedicated locations for storing a water bottle, the vehicle's handbook pack... )
To open the glove box, raise the handle.
It is illuminated when the lid is opened.
It houses the front passenger airbag deactivation switch A.
If the vehicle is fitted with air conditioning, it has a ventilation nozzle B
, distributing the sameconditioned air as the vents in the passenger compartment.
If your vehicle is fitted with the "Keyless Entryand Starting" system, it contains the back-upstarting unit C.
The sun visors fold for wards, and to the sidewhen they are unhooked.
They are fitted with a cour tesy mirror and a
ticket holder.
Page 109 of 332
107
4
Driving
Starting - stopping the engine with the Keyless Entry and
Starting system
With the electronic key inside the vehicle; each press on the " START/STOP " button, with no
action on the pedals, changes the vehicle's mode: )First press (ACC mode), the button's
warning lamp comes on in orange.
The accessories (radio, 12V socket...) can be used. )Second press (ON mode), the button's
warning lamp comes on in green.
Switching on the ignition. )Third press (OFF mode), the warning lamp
in the button goes off.
If you use the accessories for aprolonged period with the ignition switch in position 2 (ACC), you risk dischargingthe battery. Star ting your vehicle will then no longer be possible. Take care.See the "Automatic power cut-off to accessories" section.
Changing the mode of
the vehicle
If the warning lamp flashes orange,contact a CITROËN dealer or a
qualified workshop as soon as possible.
)Press and release the " START/STOP" button.
)
With the electronic key inside the vehicle,
depress the clutch pedal fully on vehicles
with a manual gearbox or press the brake pedal on vehicles with a CVT gearbox.
Starting using the
electronic key
For vehicles fitted with a manual gearbox , put
the gear lever in neutral.
For vehicles fitted with a CVT gearbox , put thegear lever in P.P
Page 119 of 332
117
4
Driving
Emergency release
If the battery is discharged or if the gear lever
locking mechanism is damaged, it is possible
for the gear lever to be locked in position P,Peven when you press the brake pedal firmly. However, i
f you have to move the vehicle, release the gear lever using the followingprocedure: ) Apply the parking brake. )
Switch off the engine if necessary. )
Remove the cap A, using a flat screwdriver covered with a cloth. )
Press the brake pedal firmly. )
Put the ignition switch into position ACC(ACC mode, if you vehicle has the Keyless
Entry and Star ting system). ) Inser t the screwdriver into the aper ture. )
While pushing the screwdriver downwards,
move the gear lever to position N.
You must contact a CITROËN dealer or a qualified workshop to have thesystem checked .
Page 137 of 332
135
5
Visibility
Switching off
The manual guide-me-home lighting switchesoff immediately if you.
- flash the headlamps again,
- place the lighting control stalk in another
position,
- switch the ignition on (or select "ON" mode
for vehicle with the "Keyless Entry and Starting" system).
Manual guide-me-home
lighting
Switching on
)
Place the lighting control stalk in the "OFF"
position, or "AUTO" for vehicles that have it. ) Place the ignition switch on "LOCK" and remove the key (or select "OFF" mode for
vehicles that have the "Keyless Entry andStarting" system). ) Within one minute after switching off the
ignition, "flash" the headlamps using the lighting control stalk.
The headlamps come on for around30 seconds. ) A further "headlamp flash" within 60 seconds of switching the ignition to OFF (or selection of "OFF" mode for vehicles
with the "Keyless Entry and Star ting" system) reactivates the function for a
further 30 seconds. Te m p o r a r i l
y keeping the dipped beam headlamps
on after the vehicle's ignition has been switched
o
ff makes the exit of the vehicle's occupants easier
when the light is poor.
The duration of the guide-me-home
lighting can be set in the colour screen"Equipment" menu.
Page 138 of 332
136
Visibility
Exterior welcome lighting Remote switching on of the lighting makes your approach to the vehicle easier in poor light.
It comes on when the vehicle is unlocked remotely.
Switching on
) Place the lighting control in
position "OFF" or "AUTO". ) Press the open padlock on the
remote control or the electronickey.
The sidelamps come on for about 30 seconds. For vehicles fitted
with automatic illumination of
headlamps, the welcome lightingonly comes on under conditions of low ambient light.
Switching off
The welcome lighting goes off immediately if:
- you press the open padlock on the remote control,
- you place the lighting control in another position,
- you switch on the ignition (or select "ON"
mode for vehicles fitted with the "Keyless
Entry and Star ting" system).
It is possible to choose the type of lamps switched on or to deactivate
the function via the colour screen"Equipment" menu.
