2010 YAMAHA RHINO 700 headlights

3-1
EVU00080
1 -DESCRIPTION
1. Headlights
2. Radiator cap
3. Coolant reservoir
4. Brake fluid reservoir
5. Driver seat
6. Driver seat belt
7. Rear passenger handhold
8. Rear seat
9. Rear passenger seat belt
10. Cargo bed
11. Tail/brake light
12. Spark arrester
13. Rear shock absorber assembly
14. Rear door1324 56 7890A
HG FED C B
15. Spark plug
16. V-belt case
17. Front door
18. Front shock absorber assembly
19. Front passenger seat belt
20. Front passenger seat
21. Front passenger handhold
22. Battery
23. Fuses
24. Air filter element
25. Engine oil dipstick
26. Fuel tank cap
27. Oil filter cartridge
97IJKLMN
DQP OG
FEE.book Page 1 Monday, January 19, 2009 5:30 PM

4-37 1. Light switch “//”
1. Contacteur d’éclairage “//”
1. Interruptor de luces “//”
HL
1
L
H
L
H
L
H
1. Horn switch “”
1. Contacteur d’avertisseur “”
1. Interruptor de la bocina “”
1
EVU00240
Light switch “//”
Set the switch to “” to turn on the low beam and
the taillights.
Set the switch to “” to turn on the high beam
and the taillights.
Set the switch to “” to turn off all the lights.NOTICEDo not use the headlights with the engine
turned off for an extended period of time. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.Horn switch “”
Press the switch to sound the horn.
L
H
LH
EE.book Page 37 Monday, January 19, 2009 5:30 PM

4-85 1. Trailer hitch bracket 2. Receiver
1. Fixation de l’attelage de remorque
2. Support de fixation d’attelage
1. Soporte para gancho de remolque
2. Receptor
12
1. Auxiliary DC jack cap
1. Capuchon de la prise pour accessoire
1. Tapa de la toma auxiliar de corriente continua
1
EVU00370
Trailer hitch bracket and receiver
This vehicle is equipped with a trailer hitch bracket
and a 5 cm (2 in) receiver for a standard trailer
hitch. Trailer towing equipment can be obtained at
a Yamaha dealer. (See pages 6-27–6-37 for pre-
caution information.)
EVU00380
Auxiliary DC jack
The auxiliary DC jack is located at the right side of
the front panel. The auxiliary DC jack can be used
for suitable work lights, radios, etc. The auxiliary
DC jack should only be used when the engine is
running and the headlights are turned off.
1. Set the light switch to “ ”.
2. Start the engine. (See pages 6-7–6-9.)
3. Open the auxiliary DC jack cap, and then in-
sert the accessory power plug into the jack.
EE.book Page 85 Monday, January 19, 2009 5:45 PM