121
Driving and operation
Wheels, tyres Suitable tyres or limitations 3191.
Tyres fitted in the factory are adapted to
the chassis and provide optimum driving
comfort and safety.
Changing tyre/wheel type
If tyres of a different size than those fitted
at the factory are used, it may be
necessary to reprogram the electronic
speedometer and make other vehicle
modifications.
After converting to a different tyre size,
have the adhesive label with tyre pressures
replaced. Fitting new tyres
Fit tyres in pairs or in sets, which is even
better. Ensure that tyres on one axle are
zthe same size,
zthe same design,
zthe same make,
zand have the same tread pattern.
Fit directional tyres such that they roll in the
direction of travel. The rolling direction is
indicated by a symbol (e.g. an arrow) on
the sidewall.
Tyres fitted opposing the rolling direction
(such as when changing a tyre) should be
refitted as soon as possible. This is the only
way to benefit fully from the design
properties of the tyre.
Pay attention to legal requirements when
disposing of tyres.
Picture no: 12117s.tif
Tyre pressure
Check tyre pressure at least every 14 days
and prior to any long journey; the tyres
should be checked when cold. Don’t forget
to check the spare 3.
Remove the valve cap key from the tank
flap and use it to unscrew the valve cap.
Tyre pressure 3191, 3192 and on the
adhesive label on the inside of the tank
flap.
The tyre pressure data is for cold tyres. It
applies to both summer and winter tyres.
9 Warning
Use of unsuitable tyres or wheels may
lead to accidents and render the vehicle
unroadworthy.
122 Driving and operationAlways inflate the spare wheel 3 to the
pressure specified for full load.
Do not reduce tyre pressure when the tyres
are warm. Otherwise the pressure may
drop below the permissible minimum when
the tyres cool down.
After having checked the tyre pressure,
tighten the valve caps using the valve cap
key.
Incorrect inflation pressures will impair
safety, vehicle handling, comfort and fuel
economy and will increase tyre wear.
Picture no: 9358t.tif Picture no: 15941s.tif
Tyre condition, wheel condition
Drive over edges slowly and at right angles
if possible. Driving over sharp edges can
cause tyre and wheel damage. Do not trap
tyres on the kerb when parking.
Regularly check the wheels for damage.
Seek the assistance of a workshop in the
event of damage or unusual wear.
9 Warning
If the pressure is too low, this can result
in considerable tyre warm-up and
internal damage, leading to tread
separation and even to tyre blow-out at
high speeds.
124 Driving and operationTyre designations
Meanings:
e.g. 175/70 R 14 79 T
Speed code letters: Winter tyres 3
Instructions on fitting new tyres 3121.
Limitations 3191.
Winter tyres improve driving safety at
temperatures below 7 C.
The design of summer tyres means they
have limited qualities for winter driving.
In accordance with country-specific
regulations, affix the speed sticker 3 in the
driver’s field of view.
Use of a spare wheel fitted with a summer
tyre may affect the vehicle’s driveability,
especially on slippery road surfaces.
Obtain a replacement for the faulty tyre as
soon as possible, and have the wheel
balanced and fitted to the vehicle.
Wheel trims 3
The use of wheel trims and tyres that Opel
has approved for the vehicle and therefore
fulfill all requirements for the relevant
combination of wheels and tyres.
If the wheel trims and tyres used are not
Opel-approved, the tyres must not have a
beaded edge. Wheel trims must not impair brake cooling.
Remove the wheel trims if fitting tyre
chains3.
175= Tyre width in mm
70= Cross-section ratio (tyre height to
tyre width in %)
R= Belt type Radial
14= Rim diameter in inches
79= Load index e. g.: 79 corresponds
to 437 kg
T= Speed code letter
Q= up to 160 km/h
S= up to 180 km/h
T= up to 190 km/h
H= up to 210 km/h
V= up to 240 km/h
W= up to 270 km/h
9 Warning
Use of unsuitable tyres or wheel trims
could lead to sudden loss of air and
thereby accidents.
125
Driving and operation
Picture no: 6459u.tif
Tyre chains 3
Limitations 3191.
Tyre chains are only permitted on the
driven wheels (front axle). They must be
fitted to the tyres symmetrically in order to
achieve a concentric fit.
Always use fine mesh chains that add no
more than 10 mm to the tyre tread and the
inboard sides (including chain lock). Remove the wheel trims when using tyre
chains 3137.
T y r e c h a i n s m a y o n l y b e u s e d a t s p e e d s u p
to 50 km/h. When travelling on roads that
are free of snow, they may only be used for
brief periods.
Tyre chains must not be used on the
temporary spare wheel. If you need to use
tyre chains after suffering a flat front tyre,
fit the temporary spare on the rear axle
and transfer one of the rear wheels to the
front axle.
Roof racks
3
For safety reasons and to avoid roof
damage we recommend using the Opel
roof rack system that is approved for your
vehicle.
Follow the usage instructions for the roof
rack.
Remove the roof rack when not in use.
Remove the covers from the roof rack
mounting apertures.
Driving hints 3106.
9 Warning
Damage may lead to tyre blowout.
128 Self-help, vehicle careSelf-help, vehicle care
Diesel fuel system, bleeding If the tank is allowed to run dry, the diesel
fuel system must be bled. Turn over the
ignition three times for 15 seconds at a
time. Then start the engine for a maximum
of 40 seconds
1). Repeat this process after
no less than 5 seconds. If the engine fails to
start, seek the assistance of a workshop.
Picture no: 16121s.tif
Bonnet Pull the release lever located on the driver’s
side below the instrument panel. Return the
release lever to its original position. Diesel fuel system, bleeding ............... 128
Bonnet .................................................. 128
Starting the engine with jump leads3 129
Towing .................................................. 131
Warning triangle ¨ 3 and first-aid kit
(cushion) + 3.................................... 133
Spare wheel 3...................................... 134
Jack £ 3 and vehicle tools3............ 136
Changing wheels ................................. 137
Tyre repair kit 3................................... 142
Electrical system .................................. 145
Fuses and the most important circuits
they protect ....................................... 147
Bulb replacement ................................ 151
Vehicle care.......................................... 160
1)For technical reasons, only 30 seconds is
possible for engine Z 17 DTH. Sales
designation
3184.
134 Self-help, vehicle care
Picture no: 12462s.tif
Combo van
The warning triangle and the first aid
cushion or box are kept in the
compartment behind the driver’s seat.
When the vehicle is being loaded, please
ensure that nothing protrudes over the
bottom edge of the opening. Disengage
flap 3 by pressing retaining lug and
remove.
Picture no: 12454s.tif
Spare wheel
3
The spare wheel is stored beneath the
floor.
1. Fully release the hexagon bolt in the
luggage compartment floor using the
wheel bolt wrench. Vehicle tools 3136.
2. Lift the spare wheel holder.
Picture no: 12455s.tif
3. Unhook the catch and lower the spare
wheel holder.
4. Detach the safety cable.
5. Lower the holder fully and take out the
spare wheel.
Vehicles with a temporary spare wheel3
have a spacer ring between the
temporary spare and the vehicle
underbody.
6. Changing wheels 3137.
135
Self-help, vehicle care
Picture no: 16493s.tif
7. Place the replaced wheel in the spare
wheel holder with the outside of the
wheel facing upwards.
If a full specification wheel is stowed, do
not fit the spacer ring between the
wheel and the vehicle underbody.
8. Lift the spare wheel holder, insert the
safety cable.
9. Lift the spare wheel holder and engage
in the catch. The open side of the catch
must point towards the rear.
10. Turn the hexagon bolt in the luggage
compartment floor with the wheel bolt
wrench to raise the spare wheel holder
all the way up. General information
Depending on the version, the spare wheel
may be designed for use as a temporary
spare 3. The temporary spare is
designated by a sticker on the rim. Follow
the instructions on this page and on 3125,
3191.
On vehicles with alloy wheels 3 the spare
wheel may have a steel rim.
Use of a spare wheel together with winter
tyres could alter driving conditions. Have
the defective tyre replaced as soon as
possible.
Use of a spare wheel that is smaller than
the other wheels could alter driving
conditions. In many countries, it is only
permitted as a temporary spare wheel.
Have the defective tyre replaced as soon
as possible. Advice to aid in an emergencywheel 3
zUsing a temporary spare wheel may
change the driving behaviour of the
vehicle, particularly if using winter
tyres3. Replace defective tyre as
quickly as possible, balance wheel
and fit to vehicle.
zFit only one temporary spare wheel.
zDo not drive faster than 80 km/h.
zTake curves slowly.
zDo not use the temporary spare wheel
for a lengthy period.
zReplace temporary spare wheel with full
specification wheel without delay.
zDo not use tyre chains. If tyre chains
must be used when one of the front tyres
has a flat, mount the temporary spare
wheel on the rear axle and transfer one
of the rear wheels to the front axle.
Check the tyre pressure and correct if
necessary 3121, 3191.
zFollow "Notes on temporary spare
wheel" 3125, 3191.
137
Self-help, vehicle care
Picture no: 12461s.tif
Combo van
The jack and the vehicle tools are secured
behind the driver’s seat.
The jack is secured in place by a wing
screw. The vehicle tools are secured to the
jack with rubber bands.
Changing wheels There may be a tyre repair kit instead of a
spare wheel 3142.
Make the following preparations and
observe the following information:
zPark the vehicle on a level, firm and non-
skid surface. The front wheels must be in
the straight-ahead position.
zSwitch on the hazard warning flashers,
apply the hand brake, engage first gear
or reverse.
zSet up the warning triangle correctly.
Warning triangle 3133.
zRemove the spare wheel from beneath
the vehicle floor 3134.
zNever change more than one wheel at
once. zUse the jack only to change wheels.
zIf the ground on which the vehicle is
standing is soft, a solid board (max. 1 cm
thick) should be placed under the jack.
zBlock the wheel diagonally opposite the
wheel to be changed by placing wedge
blocks or equivalent in front and behind
the wheel.
zNo people or animals may be in the
vehicle when it is jacked up.
zNever crawl under a jacked-up vehicle.
zDo not start the vehicle when it is raised
on the jack.
zBefore screwing in the wheel bolts, clean
them and lightly coat the taper of each
wheel bolt with commercially available
grease.