2010 OPEL COMBO fuse box

26 Keys, doors, windowsFault
If the central locking system cannot be
operated, the problem may be as follows:
zIf the central locking system is
overloaded as a result of repeated
operation at short intervals. The power
supply is cut off for a brief period.
zDefective fuse in the fuse box 3147.
Please contact a workshop to have the
cause of the fault remedied.
Operate the driver’s door with the key.
Picture no: 17881s.tif
Fault in the remote control To unlock
Turn key in driver’s door lock towards front
of vehicle, turn back to vertical position
and remove. The entire vehicle is unlocked.
Switch on ignition to deactivate anti-theft
alarm system 3.
To lock
With the driver’s door closed, turn key in
lock towards rear of vehicle, turn back to
vertical position and remove. The entire
vehicle is locked.
Malfunction in central locking
system To unlock
Turn the key in the driver’s door lock
towards the front of vehicle, turn it back to
the vertical position and remove. The
driver’s door is unlocked. The other doors
can be opened by pulling the lock button
(unless the anti-theft locking system 3 is
active). The luggage compartment and
tank flap remain locked. Switch on the
ignition to deactivate the anti-theft alarm
system 3.
To lock
With the driver’s door open, press the lock
button of one of the other doors. Close the
driver’s door and turn the key in the driver’s
door lock toward the rear of the vehicle,
turn it back to the vertical position and
remove. The unlocked fuel filler flap 3
cannot be locked.
Note
zThe mechanical anti-theft locking
system 3 and the anti-theft alarm
system 3 cannot be activated with the
key.
zTo deactivate the anti-theft alarm
system 3 alarm, switch on the ignition
after opening a door.

145
Self-help, vehicle care
Important
The driving comfort of the repaired tyre is
greatly lessened. Have such tyres replaced.
If the compressor makes abnormal noises
or heats up greatly, switch it off for at least
30 minutes.
The integrated safety valve opens at a
pressure of 7 bar.
Protect the compressor from moisture and
rain.
The sealant can only be stored for approx.
4 years. After this time, the sealing
properties can no longer be guaranteed.
Heed the expiration date on the sealant
bottle.
Replace the used sealant bottle. Dispose of
the bottle as prescribed by applicable
laws.
The compressor and the sealant can be
used from approximately -30 C.
The adaptor which is located on the
underside of the compressor can be used
to inflate other items such as balls, air beds
and inflatable boats. To remove, screw on
the compressor air hose and pull out the
adaptor.
Picture no: 11648s.tif
Electrical system Fuses
Data on the replacement fuse must match
the data on the defective fuse.
The fuse box is located in the engine
compartment next to the coolant
expansion tank.
Disengage cover of fuse box from lug and
lift off.
Picture no: 11650s.tif
Store spare fuses in the place provided
in the fuse box, to the right of which there
is a fuse extractor which facilitates fuse
replacement (spare fuses and the fuse
extractor are marked in yellow in the
figure).

146 Self-help, vehicle care
Picture no: 11651s.tif
Before replacing a fuse, turn off the
respective switch and the ignition.
Slot fuse-gripping tool onto fuse and
withdraw it.
Picture no: 12892j.tif
A defective fuse can be recognized by its
melted wire. A new fuse should only be
installed after the cause of the trouble has
been rectified. Always use fuses with the correct current
value. This is shown on each fuse, and is
also indicated by the fuse colour and the
plug-in location in the fuse box.
Different versions of fuses are used.

147
Self-help, vehicle care
Picture no: 15543s.tif
Fuses and the most important
circuits they protectSome circuits may be protected by several
fuses.
The figures on pages 147, 148 depict
the fuse boxes of vehicles with engine
Z13DTJ
1). Fuse boxes of other engines
are depicted on pages 149, 150.
Picture no:
1)Sales designation
3184.
No. Circuit
1
Central control unit
2
Engine control unit
No. Circuit
3
Instruments, information display,
light switch, horn, hazard warning
lamps, electronic immobiliser
4
Towing equipment, number plate
lampsNo. Circuit
5
Electric window (left)
6
–
7
–
8
Starter
9
Fuel injection system, fuel pump,
stationary heater
10
Horn
11
Central control unit
12
Information display, infotainment
system
13
Anti-theft alarm system
14
Exterior mirrors
15
Windscreen washer system
16
Courtesy lamp
17
Central control unit
18
–

151
Self-help, vehicle care
Bulb replacement Switch off the ignition and switch off the
relevant switch or close the doors.
Only hold a new bulb at the base! Do not
touch the bulb glass with your bare hands.
The replacement bulb must be in
accordance with the data on the base of
the defective bulb. Do not exceed wattage
given on bulb base.
To change the bulbs on the left side, open
the fuse box cover. With the Z 13 DTJ
engine
1), also pull the relay box in front of
the fuse box upwards out of the guides.
Pull off the air hose on the air filter on the
right.
Picture no: 16074s.tif
Halogen headlamp system,
dipped and main beam The headlamp system has separate
systems for dipped beam 1 (outer bulbs)
and main beam 2 (inner bulbs).
Dipped beam
1. Open bonnet and engage support.
Picture no: 16075s.tif
2. Rotate the cap anticlockwise and
remove.
6
1)Sales designation
3184.