2010 INFINITI QX56 sensor

[x] Cancel search: sensor

turn signal bulb air condition low oil pressure mirror controls tire pressure reset power steering

Load previous 8 pages

Page 814 of 4210

INFINITI QX56 2010 Factory Service Manual DEF-26
< ECU DIAGNOSIS >
BCM (BODY CONTROL MODULE)
58 W/R Optical sensorInput ONWhen optical sensor is illumi-
nated
3.1V or more
When optical sensor is not illu-
minated 0.6V or less
59 G Front door

Page 831 of 4210

INFINITI QX56 2010 Factory Service Manual PRECAUTIONSDEF-43
< PRECAUTION >
C
DE
F
G H
I
J
K
M A
B
DEF
N
O P
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:00000000053

PRECAUTIONSDEF-43
< PRECAUTION >
C
DE
F
G H
I
J
K
M A
B
DEF
N
O P
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000005367609
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severi ty of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and w hether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoper ative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including in correct removal and installation of the SRS, can lead to personal
injury caused by unintentional act ivation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipm ent on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identi fied by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Un it or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or el ectric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor( s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service.
Precaution Necessary for Steering Wheel Rotation After Battery Disconnect
INFOID:0000000005367612
NOTE:
• This Procedure is applied only to models with Intelligent Key system and NATS (NISSAN ANTI-THEFT SYS-
TEM).
• Remove and install all control units after disconnecti ng both battery cables with the ignition knob in the
″ LOCK ″ position.
• Always use CONSULT-III to perform self-diagnosis as a part of each function inspection after finishing work.
If DTC is detected, perform trouble diagnosis according to self-diagnostic results.
For models equipped with the Intelligent Key system and NATS , an electrically controlled steering lock mech-
anism is adopted on the key cylinder.
For this reason, if the battery is disconnected or if the battery is discharged, the steering wheel will lock and
steering wheel rotation will become impossible.
If steering wheel rotation is required when battery power is interrupted, follow the procedure below before
starting the repair operation.
OPERATION PROCEDURE
1. Connect both battery cables. NOTE:
Supply power using jumper cables if battery is discharged.
2. Use the Intelligent Key or mechanical key to turn the ignition switch to the ″ACC ″ position. At this time, the
steering lock will be released.
3. Disconnect both battery cables. The steering lock will remain released and the steering wheel can be
rotated.
4. Perform the necessary repair operation.
Revision: April 20092010 QX56

Page 836 of 4210

INFINITI QX56 2010 Factory Service Manual DLK-2
System Diagram .....................................................47
System Description .................................................47
Component Parts Location ..........................

DLK-2
System Diagram .....................................................47
System Description .................................................47
Component Parts Location ...................................48
Component Description .........................................50
HOMELINK UNIVERSAL TRANSCEIVER ........51
Component Description ....................................... ...51
DIAGNOSIS SYSTEM (BCM) ............................52
COMMON ITEM ..................................................... ...52
COMMON ITEM : CONSULT-III Function (BCM -
COMMON ITEM) ................................................. ...
52
DOOR LOCK .......................................................... ...52
DOOR LOCK : CONSULT-III Function (BCM -
DOOR LOCK) .........................................................
53
MULTIREMOTE ENT ............................................. ...53
MULTIREMOTE ENT : CONSULT-III Function
(BCM - MULTIREMOTE ENT) ................................
53
INTELLIGENT KEY ................................................ ...55
INTELLIGENT KEY : CONSULT-III Function
(BCM - INTELLIGENT KEY) ...................................
55
DIAGNOSIS SYSTEM (INTELLIGENT KEY
UNIT) ............................................................... ...
56
CONSULT-III Function (INTELLIGENT KEY) ...... ...56
COMPONENT DIAGNOSIS ........................58
U1000 CAN COMM CIRCUIT ......................... ...58
Description ........................................................... ...58
DTC Logic ...............................................................58
Diagnosis Procedure ..............................................58
U1010 CONTROL UNIT (CAN) .........................59
DTC Logic ............................................................ ...59
Diagnosis Procedure ..............................................59
Special Repair Requirement ...................................59
CENTER CONSOLE AREA ANTENNA
(REAR) ............................................................ ...
60
Description ........................................................... ...60
Component Function Check .................................60
Diagnosis Procedure ..............................................60
LUGGAGE AREA ANTENNA ...........................62
Description ..............................................................62
Component Function Check .................................62
Diagnosis Procedure ..............................................62
CENTER CONSOLE AREA ANTENNA
(FRONT) .............................................................
64
Description ........................................................... ...64
Component Function Check .................................64
Diagnosis Procedure ..............................................64
OVERHEAD CONSOLE AREA ANTENNA ......66
Description ........................................................... ...66
Component Function Check .................................66
Diagnosis Procedure ............................................ ...66
POWER SUPPLY AND GROUND CIRCUIT .....68
INTELLIGENT KEY UNIT ....................................... ...68
INTELLIGENT KEY UNIT : Diagnosis Procedure ...68
BCM (BODY CONTROL MODULE) ..........................68
BCM (BODY CONTROL MODULE) : Diagnosis
Procedure ...............................................................
68
BACK DOOR CONTROL UNIT .............................. ...69
BACK DOOR CONTROL UNIT : Diagnosis Proce-
dure ...................................................................... ...
69
DOOR SWITCH .................................................71
Description ........................................................... ...71
Component Function Check ..................................71
Diagnosis Procedure ...............................................71
DOOR LOCK AND UNLOCK SWITCH .............74
DRIVER SIDE ......................................................... ...74
DRIVER SIDE : Description ....................................74
DRIVER SIDE : Component Function Check ........74
DRIVER SIDE : Diagnosis Procedure .....................74
PASSENGER SIDE ...................................................76
PASSENGER SIDE : Descripti on ...........................76
PASSENGER SIDE :
Component Function Check ............................... ...
76
PASSENGER SIDE : Diagnosis Procedure ............76
KEY CYLINDER SWITCH .................................79
Description ........................................................... ...79
Component Function Check ...................................79
Diagnosis Procedure ...............................................79
FRONT DOOR LOCK ACTUATOR LH (DOOR
UNLOCK SENSOR) ..........................................
81
Description ........................................................... ...81
Component Function Check ..................................81
Diagnosis Procedure ...............................................81
Component Inspection ............................................82
DOOR REQUEST SWITCH ...............................83
Description ..............................................................83
Component Function Check ..................................83
Diagnosis Procedure ...............................................83
Component Inspection ............................................85
DOOR LOCK ACTUATOR ................................86
DRIVER SIDE ......................................................... ...86
DRIVER SIDE : Description ....................................86
DRIVER SIDE : Component Function Check ........86
DRIVER SIDE : Diagnosis Procedure .....................86
PASSENGER SIDE ...................................................87
PASSENGER SIDE : Descripti on ...........................87
PASSENGER SIDE :
Component Function Check ............................... ...
87
PASSENGER SIDE : Diagnosis Procedure ............87
Revision: April 20092010 QX56

Page 854 of 4210

INFINITI QX56 2010 Factory Service Manual DLK-20
< FUNCTION DIAGNOSIS >[WITH INTELLIGENT KEY SYSTEM]
DOOR LOCK FUNCTION
ALKIA0579ZZ
1. Horn E3
(view with hood open) 2. IPDM E/R E122, E124
(view with cover removed) 3. Horn relay H-1
4. Remote

Page 859 of 4210

INFINITI QX56 2010 Factory Service Manual DOOR LOCK FUNCTIONDLK-25
< FUNCTION DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O P
INTELLIGENT KEY : Co mponent DescriptionINFOID:0000000005146882
ALKIA0579ZZ
1. Horn E3
(

Page 870 of 4210

INFINITI QX56 2010 Factory Service Manual DLK-36
< FUNCTION DIAGNOSIS >[WITH INTELLIGENT KEY SYSTEM]
BACK DOOR OPENER FUNCTION
INTELLIGENT KEY : Component Description
INFOID:0000000005146890
ALKIA0579ZZ
1. Horn E3 (view with hood open) 2. IPD

Page 877 of 4210

INFINITI QX56 2010 Factory Service Manual WARNING FUNCTIONDLK-43
< FUNCTION DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O PALKIA0579ZZ
1. Horn E3 (view with hood open) 2. IPDM E/R E122, E124
(view with co ver remov

Page 880 of 4210

INFINITI QX56 2010 Factory Service Manual DLK-46
< FUNCTION DIAGNOSIS >[WITH INTELLIGENT KEY SYSTEM]
KEY REMINDER FUNCTION
ALKIA0579ZZ
1. Horn E3
(view with hood open) 2. IPDM E/R E122, E124
(view with cover removed) 3. Horn relay H-1
4. Remo

Load next 8 pages

Page: < prev 1-10 ... 161-168 169-176 177-184 185-192 193-200 201-208 209-216 217-224 225-232 ... 1008 next >

engine oil fuel cap release tyre pressure dead battery check transmission fluid brake pads