The navigation system receives
signals f rom the global positioning
system (GPS), and the displayed
time is updated automatically by the
GPS. Ref er to the navigation system
manual f or how to adjust the time.
For example:
Press and hold the FM/AM
(CLOCK) button until the displayed
time begins to blink, then release the
button. Change the hours by
pressing the 1 (H) button until the
numbers advance to the desired time.
Change the minutes by pressing the
2 (M) button until the numbers
advance to the desired time.
PresstheFM/AM(CLOCK)button
again to enter the set time.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, press the FM/
AM (CLOCK) button until you hear
a beep, then press the 3 (R) button
tosettheclockbacktotheprevious
hour. If the displayed time is af ter
the half hour, the clock sets forward
to the beginning of the next hour.
1:06 will reset to 1:00
1:53 will reset to 2:00
On vehicles without navigation system
On vehicles with navigation system
Setting the Clock
254
FM/AM (CLOCK)
BUTTONCLOCK
2 (M) BUTTON
1 (H) BUTTON 3 (R) BUTTON
—
—y
y
)" y y
2010 Insight
If the replacement fuse of the
same rating blows in a short time,
there is probably a serious
electrical problem with your
vehicle. Leave the blown fuse in
that circuit, and have your vehicle
checked by a qualif ied technician.
When the audio system is disabled,
the clock setting in the audio system
will be canceled. You will need to
reset the clock according to the
instructions in the audio system
sectioninthisowner’smanual. The navigation system will also
disableitself.Thenexttimeyouturn
on the ignition switch, the system
will require you to enter a PIN
bef ore it can be used. Ref er to the
navigation system manual. If the radio f use is removed, the
audio system will disable itself . The
nexttimeyouturnontheradio,you
may see ‘‘ENTER CODE’’ in the
f requency display. Use the preset
buttons to enter the digit code (see
page ).
6. 253
On vehicles with navigation system
Fuses
T aking Care of t he Unexpect ed
409
Replacing a f use with one that has a
higher rating greatly increases the
chances of damaging the electrical
system. If you do not have a
replacement f use with the proper rating
f or the circuit, install one with a lower
rating.
—
—y
y
)" y
y
2010 Insight
