2010 HONDA INSIGHT automatic transmission

µ
µ When the vehicle reaches the
maximum speed in any shif t position,
you may f eel the engine cut in and
out. This is caused by a limiter (112
mph, 180 km/h) in the engine’s
computer controls. The engine will
run normally when you reduce the
speed to below the maximum.
To shift into the S
position, press the release button on
the front of the shift lever, and move
the lever to S. The S position is
similar to D, except the range of
ratios are different for better
acceleration and increased engine
braking.
With the shift lever in D or S, you
canalsousethepaddleshiftersto
shif t the transmission up or down.
With the paddle shifters, you can
operate the transmission much like a
manual transmission without a
clutch pedal. For more inf ormation
on driving with the paddle shif ters,
see page .
To shif t to Low, press
the release button on the front of the
shif t lever. Use Low to get more
power when climbing, and f or
maximum engine braking when
going down steep hills.
ForfasteraccelerationwheninD,S
or L, the transmission will
automatically ‘‘kick down’’ to a lower
range of ratios by pushing the
accelerator pedal to the floor.
316
Except LX models
LX models
Automatic Transmission (CVT)
Second (S)
Low (L) Speed L imiter
314
—
—y

y
)"y
y
2010 Insight

If you need to use the shif t lock
release, it means your vehicle is
developing a problem. Have it
checked by your dealer.
Push down on the key while you
pressthereleasebuttononthe
shif t lever and move the shif t lever
out of Park to neutral. Insert the key in the shift lock
release slot.
This allows you to move the shif t
lever out of Park if the normal
method of pushing on the brake
pedal and pressing the release
button does not work.
Remove the key from the shift
lock release slot, then reinstall the
cover. Make sure the notch on the
cover is on the lef t side. Insert the
key back into the ignition switch,
press the brake pedal, and restart
the engine.
Putaclothonthenotchof the
shif t lock release slot cover. Using
a small f lat-tipped screwdriver or a
metal f ingernail f ile, caref ully pry
on the notch of the cover to
remove it. Remove the key from the ignition
switch. Set the parking brake.
1.
2.
3.
4.
5.6.
Shif t L ock Release
Automatic Transmission (CVT)
Driving
315
SHIFT LOCK
RELEASE SLOT
RELEASE BUTTON
COVER
—
—y
y
)"yy
2010 Insight

´
µ
´ µ
To shif t up or down, use the
(right) or (lef t) paddle shif ter on
either side of the steering wheel.
Pull the (right) paddle shifter to
upshift. Pull (left) to downshift. When you pull either paddle shif ter,
the shif t indicator shows you the
selected speed number.
Downshif ting gives you more power
when climbing, and provides engine
braking when going down a steep hill. WhenyouaredrivingintheD
position, pulling either paddle shif ter
switches f rom the ordinary
automatic transmission (CVT) to the
D-paddle shif t mode. You can shif t
the transmission up or down through
seven-stages manually with the
paddle shif ters.
When the transmission returns to
ordinary automatic transmission
(CVT), the displayed shif t indicator
disappears.
Except LX models
Driving with the Paddle Shif ters
Using the Paddle Shif ters in the
D position (D-Paddle Shif t Mode)
316
SHIFT INDICATOR
—
—y
y
)"y
y
2010 Insight

´
µ
CONT INUED
The transmission control system
monitors the accelerator pedal use
and your driving conditions. When
you press the accelerator pedal as in
the normal driving, the system
judges that you are driving at a
constant cruising speed without
using the paddle shif ters. Under
these conditions, D-paddle shif t
mode is canceled, and the
transmission automatically returns to
ordinary automatic transmission
(CVT). When the transmission returns to
ordinary automatic transmission
(CVT), the displayed shif t indicator
disappears.
To cancel the D-paddle shif t mode
manually, pull and hold the side
paddle shif ter until the shif t indicator
goes out.
Downshifting with the (left)
paddle shif ter allows you to increase
the engine braking when going down
steep or long hills, and provides
more power when climbing uphills.
You can upshif t the transmission
manually to reduce the rpm.
The transmission remains in the
selected speed if you do not
accelerate.
Driving with the Paddle Shif ters
Driving
317
—
—y
y
)"yy
2010 Insight

Each time you pull either paddle
shif ter, the transmission shif ts one
speed up or down. If you want to
shif t up or down more than two
speeds, pull the paddle shif ter twice,
pause, and then pull it again.The automatic transmission (CVT)
will not allow you to change shif t if :
The transmission downshif ts to f irst
speed and returns to ordinary
automatic transmission (CVT) when
the vehicle comes to a complete stop
and the vehicle speed is about 6 mph
(10 km/h).
If there is a problem in the
transmission while you are driving
with the paddle shifters, the D
indicator f lashes, the D-paddle shif t
mode is canceled, and the
transmission returns to ordinary
automatic transmission (CVT).
You downshif t bef ore the engine
speed reaches the highest
threshold of the lower speed.
If you try to do this, the shift
indicator will f lash the number of
the lower speed several times,
then return to a higher speed.
You upshif t bef ore the engine
speed reaches the lowest
threshold of the higher speed.
You press both paddle shif ters at
thesametime.
You pull one of the two paddle
shifters with another paddle
shif ter being pressed.
Driving with the Paddle Shif ters
318
—
—y


y
)"yy
2010 Insight

´µ µ
With the shif t lever in the S position,
you can select the 7-Speed Manual
shif t mode to shif t speeds; much like
a manual transmission using the
paddle shif ters, but without a clutch
pedal.
To enter the 7-speed manual shif t
mode, press the release button on
thesideof theshiftlever,movethe
lever to the S position, then pull
either paddle shif ter. To cancel the
7-speed manual shif t mode and
return to the ordinary automatic
transmission (CVT), move the shif t
lever f rom the S position. When
moving the shift lever, be careful not
to operate incorrectly. While you are
driving in the 7-speed manual shif t
mode, the transmission will not
automatically return to the ordinary
automatic transmission (CVT). When you move the shif t lever f rom
the ‘‘D’’ to ‘‘S’’ position and pull
either paddle shif ter, the shif t
indicator displays ‘‘M’’ along with the
selected speed number.
To upshif t, pull the (right) paddle
shif ter. To downshif t, pull the
(lef t) paddle shif ter.If you keep depressing the
accelerator pedal without pressing
the paddle shif ter, the speed will be
automatically shifted up just before
the tachometer’s red zone.
The transmission also shif ts
automatically as the vehicle comes to
a complete stop. It downshif ts to f irst
speed when the vehicle speed
reaches 6 mph (10 km/h) or less.
Downshifting with the (left)
paddle shif ter allows you to increase
the engine braking when going down
steep or long hills, and provides
more power when climbing uphills.
You can upshif t the transmission
manually to reduce the rpm.
CONT INUED
Except LX models
Driving with the Paddle Shif ters
Using the Paddle Shif ters in the S
position (7-Speed Manual Shif t
Mode)
Driving
319
SHIFT INDICATOR
‘‘M’’ INDICATOR
—
—y
y
)"yy
2010 Insight

µ
à
à
à
à
à
à
The automatic transmission (CVT)
will not allow you to change shif t if :
You downshif t bef ore the engine
speed reaches the highest
threshold of the lower speed.
If you try to do this, the shift
indicator will f lash the number of
the lower speed several times,
then return to a higher speed.
You upshif t bef ore the engine
speed reaches the lowest
threshold of the higher speed.
You press both paddle shif ters at
thesametime.
You pull one of the two paddle
shifters with another paddle
shif ter being pressed. Drive in the highest speed number
that lets the engine run and
accelerate smoothly. This will give
you ef f ective emissions control. The
f ollowing shif t points are
recommended:
To shift to Low,
press and hold both paddle shif ters
simultaneously until you see L in the
shift indicator. Use Low to get more
power when climbing, and f or
maximum engine braking when
going down steep hills.
Shif t up 12
23
34
45
56
67 Normal acceleration
15 mph (24 km/h)
25 mph (40 km/h)
40 mph (64 km/h)
45 mph (72 km/h)
50 mph (81 km/h)
55 mph (89 km/h)
Driving with the Paddle Shif ters
Recommended Shif t Points L (L ow) mode
320
—
—y
y
)"yy
2010 Insight

The engine automatically stops
when:
The vehicle comes to a stop with the
shif t lever in the D position and the
brake pedal pressed.The engine will not stop
automatically under the f ollowing
conditions:
Vehicle speed does not go above 7
mph (11 km/h) af ter starting the
engine
The engine coolant temperature is
low
The transmission f luid
temperature is low
The vehicle is stopped with the
shif t position in R, S, or L
When the vehicle is stopped on an
incline
The climate control is in use and
either or is pressed The engine may not stop
automatically under the following
conditions:
When the ECON button is on, the
engine is more likely to stop. See
page f or the ECON button.
The vehicle is stopped by braking
suddenly Theclimatecontrolsystemisin
use to dehumidif y the moist air
inside the vehicle The ECON button is off, and there
is a signif icant dif f erence between
the ambient temperature and the
temperature setting of the climate
control system The IMA battery temperature is
excessively high or low The IMA battery charge is low
The engine may also stop when
vehicle speed drops below 7 mph (11
km/h) with the brake pedal pressed. To help maximize f uel economy,
your vehicle has an Auto Idle Stop
f unction. Depending on
environmental conditions and vehicle
operation, the engine will shut of f
when you come to a stop.
124
Auto Idle Stop
Driving
321
—
—y

y
)"yy
2010 Insight