2010 AUDI S8 technical data

Emergency situations --------------=---:.-----JftFI
Loading the vehicle onto a flat bed truck
Front hook up
"' .... N
Fig. 288 Vehicle on
flat bed truck
- Align the vehicle with the centerline of the car carrier
ramp.
- Attach the winch hook to the front towline eye previously
installed.
Re ar hoo k up
Align the vehicle with the centerline of the car carrier
ramp .
- Attach the winch hook to the rear towline eye previously installed .
[ i ] Tips
Check carefully to make sure the hook-up is secure before moving the
car up the flatbed truck ramp .•
Vehicle OP-eration
Vehicle transport
Whenever you have your vehicle transported, be sure to
note the following:
0 Note
Mount the tie-down chains/cables over the running surface (circum­
ference) of the tires. Never secure the vehicle by the axle , the suspen­
sion struts or the front or rear towline eye . For technical reasons, the
pressure in the suspension struts may change during the transport
and this will adve rsely affect veh icle handling. •
Lifting vehicle
Lifting with workshop hoist and with floor
jack
The vehicle may only be lifted at the lifting points illus­
trated.
--1------------- ~
'-l.=c==;;;;;;;;;;===-cl i
Fig. 289 Fron t li fting
p oint
~
Vehicle care Do-it-yourself service iTechnical data

Emergency situations --------------=----PfN:t'II
-Before driving over a workshop hoist, ensure that there is
sufficient clearance between the hoist and low parts of the
vehicle. •
Safety first Vehicle care Do-it-yourself service Technical data

___ G_ e_n_ e_r _a _ l_ in_ f_o _r_ m_ a_ t_io _ n _______________________________________________ _
General information
Explanation of technical data
Some of the technical data listed in this manual requires
further explanation.
The technical data for your vehicle is listed in the charts starting on
~ page 360. This section provides general information, notes and
restrictions which apply to this data.•
Vehicle identification
The key data is given on the vehicle identification number
(VIN) plate and the vehicle data sticker.
Fig . 291 Vehicle Iden­
tification Number
(V IN) plate: location
on driver's side dash
panel Fig.
292 The vehicle
identification label -
inside the luggage
compartment
The Vehicle Identification Number (VlN)
is locat ed on the driver's sid e so that it is visible from the outside
through the windshield ~ fig . 291. You can also display the Vehicle
Identification Number of your vehicle in the MMI. Select: Function
button [CAR]>
Systems> Vehicle ID number (VIN) .
The vehicle identification label
is located in the luggage compartment in the spare wheel well.
The label ~ fig . 292 shows the following vehicle data:
© Production control No.
@ Vehicle identification No.
® Type code number
@ Type designation/engine output in Kilowatts
© Engine and transmission code letter
© Paint No./lnterior
(j) Optional equipment No.'s
Vehicle data 2 to 7 are also found in your Warranty
& Maintenance
booklet . .,,

______________________________________________ G_e_ n_e _ r_ a_ l_ in_ f_o _r_ m_ a_ t_ i _o_ n __ __
The safety compliance sticker
is your assurance that yo ur new vehicle complies with all applicable
Fede ral Motor Veh icle Safe ty Standards which were i n effect at the
time the vehicle was manufact ured . Yo u can fi nd this sticker on the
left doo r jamb.
It shows the mont h and year of prod uct io n and the
vehicle identification number of your veh icle (perforation) as well as
the Gross Vehicle Weight Rating (GV WR) and the Gross Axle Weight
Rating (GAWR).
The high voltage warning label
is located o n the loc k carrier.
The spark ignition system complies with the
Canadian standard ICES-002. •
Weights
Gross Vehicle Weight Rating
The Gross Vehicle Weight Rating (GVWR), and the Gross Axle Weight
Rating (GAWR) for front and rear are listed on a sticker on the left
door jamb.
T he Gross Vehicle Weight Rating includes the weight of the basic
vehicle pl us f ull f uel tank, oil and coo la nt, plus max im um load, whi ch
includes passenger we ight (150 lbs/68 kg per des ignated seating
position) and luggage weight.
Gross Axle Weight Rating
Th e Gross Axle Weight Ra ting is the maximum lo ad that can be
applied at each axle of the vehicle~&.
Vehicle capacity weight
The vehicle capac ity weight (max . load) is listed either on the driver's
side B -pillar or inside the fuel fille r flap .
Safety first
Roof weight
The maxim um permiss ib le roof weight is 220 lb (100 kg ). T he roof
we ight is made up of the weight of the roof rac k system and t he
we ight of the object being transported~
page 94, "Loading the roof
rack".
& WARNING
• The actual Gross A xle Weight Rating at the front and rear a xles
s hould not exceed the permis sible weights , and their combination
must not exceed the Gros s Vehicl e Weight Rat ing .
• Exceeding permi ssible weight ratings can result in vehicle
damage, accidents and personal injury.
0 Note
• T he vehicle capac ity we ight figures apply when the load is distrib­
uted evenly i n the vehicle (passengers and lug gage). When trans ­
porting a heavy load i n the luggage compartment, ca rry the load as
near to the rear axle as possible so that the ve hicle's handling is not
impa ired.
• Do not exceed the max imum permissible axle loads o r the
maximum gross veh icle weight. Always remember that the vehicle's
handling will be affecte d by the extra load. Therefore, adjust your
speed according ly .
• Always observe loca l reg ulat ions. •
Dimensions
The specifications refe r to the basic mode l. Differences may occur
depe nd ing on the mode l type a nd options ordered, for exam ple, t ire
sizes. _.,,
Do-it,yourself service Technical data

______________________________________________ G_e_ n_e _ r_ a_ l_ in_ f_o _r_ m_ a_ t_ i _o_ n __ _
Controls and equip­
ment Safety first Vehicle operation
Vehicle care Do-it-yourself service Technical data

______________________________________________ C _o_ n _ s_u_ m_ e_r_ I_n _f_ o_ r_m _ a_t_ i_ o _ n __ _
Consumer Information
Warranty coverages
Your Audi i s covered by the following warrantie s:
• New Vehicle Limited Warranty
• Limited Warranty Against Corrosion Perforation
• Emissions Control System Warranty
• Emissions Performance Warranty
• California Emissions Control Warranty (USA vehicles only)
• California Emissions Performance Warranty (USA vehicles only)
Detailed in forma tion reg ard ing yo ur war ran ties can be fo und in your
Warranty & Maintenance booklet .•
Operating your vehicle outside the
U.S.A. or Canada
Government regulations in the United States and Canada req uire that
au tomobile s mee t sp eci fic emi ssio n regula tions and safety s tan­
dards . Therefore, vehicles b uilt for the U .S .A . and Canada d if f er from
vehicles sold in othe r countr ies .
If you plan to take your veh icle outs ide the con tinen tal lim its of the
United States o r Canada , there is the poss ibility that
• unle ade d fu els for veh icles wi th c atal ytic conve rter m ay no t be
available;
• fue l may have a conside rably lowe r octane rat ing. Im proper f ue l
may cause engine damage;
• serv ice may be inadeq uate due to lack of proper service facilities,
too ls o r testing eq uipment;
• replacemen t parts may not be read ily avai lab le .
Safety first
• N aviga tion syst ems for ve hicles built fo r th e U .S.A . and Canada
will not necessar ily work in Europe, and may not work in other coun ­
tr ies o utside North Amer ica.
0 Note
Audi c annot be responsible for me ch anic al d am age t hat cou ld re su lt
from inadequate fuel, service or parts ava ilability. •
Audi Service Repair Manuals and
Literature
Audi Official Fac tory Service Manuals a re published as soon as
po ss ible afte r model in troduc tion. Serv ice m anuals are av ailable
from :
Audi Technical Literature Ordering Center
Call toll -free:
T el. :
1 (8 0 0) 5 44- 8021
(from 8:00 AM to 8:00 PM, EST , Mo nday through Friday)
or access their webs ite
www .audi.ddsltd.com on t he Internet to
or der r ep air m anuals and othe r Au di literat ure.•
Maintenance
General
Yo ur vehicle has been des igned to help keep main tenance req uire­
m en ts to a min imum . Howeve r, a certa in amoun t of regular ma inte­
nance is still necessary to assure your ve hicle's safety, economy an d ..,_
Do-it,yourself service Technical data

______________________________________________ C _o_ n _ s_u_ m_ e_r_ I_n _f_ o_ r_m _ a_t_ i_ o _ n __ _
& WARNING (co ntinued )
• The engine compartment of any motor vehicle is a potentially
hazardous are a. Nev er reach into the area around or touch the
radiator fan. It is temperature controlled and can switch on
suddenly -even when the engine i s off and the ignition key has
been remo ved. The radiator fan switches on automatically when
the coolant reache s a certain temperature and will continue to run
until the coolant temperature drops.
• Always remove the ignition key before anyone gets under the
vehicle.
• Alway s support your vehicle with safety stands if it i s nece ssary
to work underneath the vehicle. The jack supplied with the vehicle
is not adequate for this purpose and could collapse causing
serious personal inju ry.
• If you must work underneath the vehicle with the wheels on
the ground, always make sure the vehicle is on level ground , that
the whe els are always securely block ed and that the engine cannot
be started.
• Always make sure the transmi ssion selector lever (automatic
transmiss ion) is in "P" (Park position ) and the park brake is firmly
app lied .
c£> For the sake of the environment
• C ha ng ing the engine settings will a dversely affe ct emiss ion levels.
Th is is det rimenta l to the environment and increases fuel consump­
t ion.
• Always observe environmental regulations when dispos ing of o ld
eng ine oi l, u se d brake fl uid, d irty engine coo lant, s pen t batter ies or
worn out t ires .
• Undeployed a irbag modules and prete ns ione rs m ight be classified
as Perchlorate Materia l -spec ia l hand ling may apply, see
www.dt sc.ca .gov/h azardousw aste/pe rc hl or ate. When the vehi cle or
parts of the rest raint system including airbag modu les safety belts
wit h pre tens io ner s are sc rappe d, a ll applicable laws an d reg ulat io ns
Safety first
must be observed. Your author ized Aud i dealer is familiar with these
req uirements and we re commen d that yo u have yo ur d eale r perfo rm
t his service for you. •
Additional accessories,
modifications and parts
replacement
Additional accessories and parts
replacement
A lways c onsul t an au thori zed Audi dealer before
purchasing acces so ries .
Your vehicle incorporates the latest safety des ign feat ures ens uring a
high s tand ard of active and pas sive s afe ty.
T hi s safety could be compromised by non-app roved changes to the
vehicle. Fo r th is reaso n, if pa rts have to be re place d, ple ase obse rve
t he following poin ts when ins talling addit ional accessories:
Approved Audi accessories and genuine Audi parts are available from au thor ized Au di deal ers .
These dea lers a lso have the necessary facilities, tools and tra ined
s pecialists to install t he p arts and ac cesso ries p roper ly .
& WARNING
Using the wrong spare parts or u sing non-approved acces sories
can cause damage to the vehicle and serious personal injury.
• Use only accessorie s expressly approved by Audi and genuine
Audi spare parts
• These parts and accessories have been specially designed to be
used on your vehicle . ..,_
Do-it,yourself service Technical data

______________________________________________ C _o_ n _ s_u_ m_ e_r_ I_n _f_ o_ r_m _ a_t_ i_ o _ n __ _
• Cell phone package
• Electronic immobilizer
• Homelink ® universal remote control
• Remote control key
• Tir e pressure monitoring system*
FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interfe rence rece ived , including inter­
ference that may cause undesired operation.
FCC Part 15.21
CAUTION:
Changes or modifications not expressly approved by the party
respons ible for compliance could void the user's authority to operate
the equipment.
RSS-Gen Issue 1
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device .•
Safety first Do-it,yourself service Technical data