i
85
CHANGING A BULB
Front lamps
1. Direction indicators
(PY21W amber).
2. Sidelamps (W5W).
3. Dipped beam headlamps
(H7-55W).
4. Main beam headlamps (H1-55W).
5. Foglamps (PSX-24W).
Operating procedure for replacing a
faulty bulb with a new bulb. These op-
erations must be carried out
with the
ignition off .
To gain access to the bulbs on the right-
hand side * :
- Remove the screenwash reservoir fi l l e r t u b e .
- Unclip the engine harness 1 .
- Remove the nut from the engine management unit support 2 using a
size 10 spanner.
- Remove the engine management unit and support assembly. After changing the faulty bulb:
- Slide the two lugs of the engine
management unit support into the
locations A .
- Put the engine management unit back in place.
- Tighten the engine management unit support nut (size 10 spanner).
- Reclip the engine harness.
These bulbs are available from
PEUGEOT dealers.
In certain climatic conditions (low
temperature, humidity), conden-
sation inside the glass of the
headlamps and other lamps is
normal .
However, contact a PEUGEOT
dealer if water is present in the
headlamps.
* Petrol engines only.
i
86
Turn the bulb holder a quarter turn
and remove it.
Pull the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r .
Direction indicators
Disconnect the headlamp main
connector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Pull the bulb out and change it. Dipped beam headlamps
Disconnect the headlamp main con-
nector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Press the connector downwards to
release the bulb.
Pull the bulb out and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Sidelamps
!
87
Front foglamp
Slide a hand under the bumper.
Turn the connector a quarter turn
and remove the assembly.
Remove the bulb and change it.
Main beam headlamps
Disconnect the headlamp main
connector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Move aside the springs to release
the bulb and pull the bulb out.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order. Direction indicator side repeater
Push the repeater forwards and
release it.
Remove the repeater and change it.
Repeaters can be obtained from a
PEUGEOT dealer.
High pressure washing
When using a jet washer on stub-
born dirt, do not persist on the
headlamps, the other lamps and
their surround to avoid damaging
their coating and seals.
88
Third brake lamp 5 bulbs W5W
Unclip the boot side trim.
Remove the wing nut.
Release the lamp unit from the outside.
Press the lug A and disconnect the
connector.
Remove the sealing foam.
Move aside the tabs B and remove the
bulb holder.
Turn the faulty bulb a quarter turn and
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order and ensure that the bulb
holder, the lamp unit and the foam cover
are repositioned correctly. Using a 10 mm spanner, unscrew the
2 nuts
A .
Release the lamp unit.
Squeeze the two tabs B to release the
bulb holder.
Change the faulty bulb.
1. Direction indicators
(P21W amber).
2. Reversing lamps P21W.
3. Brake lamps/sidelamps (P21/5W).
4. Foglamp (P21W).
Rear lam
ps
89
Rear foglamp (P21W)
The foglamp is located on the rear
bumper, on the left-hand side.
Unscrew the lamp and release the
assembly.
Turn the pin connector a quarter turn
and remove it.
Change the bulb. Number plate lamps W5W
Insert a thin screwdriver into one of the
outer holes of the transparent cover.
Push it outwards to unclip it.
Remove the transparent cover.
Change the faulty bulb.
!
i
97
ACCESSORIES
A wide range of accessories and genu-
ine parts is available from the PEUGEOT
dealer network.
These accessories and parts have been
tested and approved for reliability and
safety.
They are all adapted to your vehicle and
b e n e fi t f r o m P E U G E O T ' s r e c o m m e n d a -
tion and warranty.
"Protection":
mats * , seat covers, boot tray, passenger
seat protector, cup holder, CD storage,
under shelf storage (saloon), booster
seat and child seats, sun blinds, …
For leisure pursuits: roof bars, roof
boxes, ski carrier, bicycle carrier ** ,
show chains, …
T r a i l e r t o w b a r , w h i c h m u s t b e fi t t e d b y a
PEUGEOT dealer.
"Multimedia":
audio/telephone, Bluetooth hands-free
system, satellite navigation system, au-
dio equipment, speakers, …
T h e fi t t i n g o f e l e c t r i c a l e q u i p m e n t
or accessories which are not rec-
ommended by PEUGEOT may
result in a failure of your vehicle's
electronic system.
P l e a s e n o t e t h i s s p e c i fi c w a r n -
ing. You are advised to contact a
representative of the PEUGEOT
marque to be shown the range
of recommended equipment and
accessories.
Depending on the country in which
the vehicle is sold, it is compulsory
to have a high visibility vest, warn-
ing triangle and spare bulbs avail-
able in the vehicle.
"Styling":
alloy wheels, sunroof *** , front foglamps,
m u d fl a p s , t a i l g a t e s p o i l e r ( s a l o o n ) ,
door sills, body kit, leather steering
wheel, …
"Boutique":
screenwash, interior and exterior main-
tenance and cleaning products. Conversion kits
You can obtain an "Enterprise" kit to
convert a trade vehicle to a private car
and vice-versa.
* To avoid any risk of jamming of the
pedals:
- ensure that the mat is positioned and secured correctly,
- n e v e r fi t o n e m a t o n t o p o f a n o t h e r .
* * D o n o t fi t t h e b i c y c l e c a r r i e r o n t h e spoiler or on the rear screen.
* * * W h e n fi t t i n g a s u n r o o f , i t i s e s s e n t i a l that only genuine PEUGEOT prod-
ucts are used.
"Security and safety":
anti-theft alarm, window etching, wheel
s e c u r i t y b o l t s , fi r s t a i d k i t , w a r n i n g
triangle, high visibility vest, …
