4-5
4
WARNING
Improper adjustment of the speed limiter and
throttle could cause throttle cable damage or
improper throttle operation. You could lose
control, have an accident or be injured. Do not
turn the adjusting screw out more than 5 mm
(0.2 in).Engine speed limiter plate
TIPStore the speed limiter plate with the owner’s manual
so that it is readily available whenever you want to
reduce the top engine speed.
With this plate installed, the engine speed is limited
to 4800 r/min. With this plate removed, top engine
speed (8000 r/min) is available.
Remove the plate as follows.
1. Remove the seat. (See page 4-11.)
3. Pull the plate out of its case. 4. Tighten the screw.
2. Loosen the screws.
5. Install the seat.
1. Speed limiter plate
2. Screws
21
8-1
PERIODIC MAINTENANCE AND MINOR REPAIR
Safety is an obligation of the owner. Periodic in-
spection, adjustment and lubrication will keep your
ATV in the safest and best operating condition
possible. The most important points of inspection,
adjustment, and lubrication are explained on the
following pages.
The intervals given in the periodic maintenance
and lubrication chart should be considered as a
general guide under normal riding conditions.
However, DEPENDING ON THE WEATHER,
TERRAIN, GEOGRAPHICAL LOCATION, AND
INDIVIDUAL USE, THE MAINTENANCE INTER-
VALS MAY NEED TO BE SHORTENED.
Owner’s manual and tool kit Be sure to put this owner’s manual in the plastic
bag and to always carry it as well as the owner’s
tool kit and the low-pressure tire gauge in their re-
spective compartments under the seat.
8
WARNING
Never service an engine while it is running.
Moving parts can catch clothing or parts of the
body, causing injury. Electrical components
can cause shocks or start fires. Turn off the en-
gine when performing maintenance unlessotherwise specified. Have a Yamaha dealer
perform the service if you are not familiar with
maintenance work.
