2009 OPEL MERIVA air filter

10 In BriefControl indicators X Seat belt
3,
3 82.
B Adaptive Forward Lighting
(AFL)
3, fault,
3 82, 3106.>
Fog lamps 3,
3 83, 3103.
A
Engine electronic
s, immobiliser,
Easytronic 3, Fault,
3 83, 327, 3143.
Z
Exhaust gases 3,
3 83, 3143.
v
Airbag systems 3, Belt
tensioners,
3 61, 372.
I
Engine oil pressure,
384.
O
Turn signal lamps,
311, 384.
C Main beam,
3
11, 384.
!
Preheating system
3, Diesel
particle filter 3,
3 86.
j Easytronic
3, starting the
engine 3,
3 130.
T
Easytronic 3, Winter
programme,
3 132.
m
Cruise control 3,
3 148.
r
Fog tail lamp,
385, 3104.
p
Alternator,
3
85.
R
Brake system, clutch system 3,
3 85.
u
Anti-lock Braking System 3,
3 152.
S
Engine oil level 3 ,
3 85.
EPS Electric power steering
3,
3 86.
v
Electronic Stability Program
(ESP®
Plus
) 3 ,
3 146.
Y
Fuel level,
3 86, 3140.
y
Seat occupancy recognition 3,
3 72, 373.

83
Instruments, Controls
Picture no: 18385s.tif
Flashes

System converted to symmetrical dipped
beam.
Control indicator
B
flashes for
approximately 4 seconds after the ignition
is switched on as a reminder that the
system has been converted 3110.
AFL 3106.
>

Fog lamps 3
Control indicator lights up green.
This comes on when the front fog lamps
are switched on 3103.
Picture no:
A

Engine electronics, transmission
electronics, immo biliser, diesel fuel filter 3
Control indicator lights up and/or flashes
yellow.
It illuminates for a few seconds when the
ignition is switched on.
Illuminates when the engine is running
Fault in engine electronics or transmission
electronics. Electr onics switches to
emergency running program, fuel
consumption may increase and driveability
of vehicle may be affected 3143. If the
fault is still there when the engine is started
again, contact a workshop for assistance.
For vehicles with diesel engine, the diesel
fuel filter may need to be drained of water
3 212.
Flashes when the ignition is onFault in the electronic immobiliser system;
the engine cannot be started 327. Z

Exhaust emission
Control indicator lights up and/or flashes
yellow.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Fault in emission control system. The
permissible emission limits may be
exceeded. Contact a workshop for
assistance immediately.
If it flashes when the engine is runningFault that could lead to catalytic converter
damage. Ease up on the throttle until the
flashing stops 3143. Seek the immediate
assistance of a workshop. v
Airbag systems 3, Belt tensioners
Control indicator lights up red.
Illuminates when the engine is runningFault in zone of airbag system or belt
tensioners 361, 372.

114 Climate controlClimate control
Picture no: 14154s.tif
Heating and ventilation system,
air conditioning system
3
Ventilation, heating and cooling 3 are
combined into one unit that is designed to
provide comfort regardless of the season,
weather or outside temperature.
When cooling 3 is activated, the air is
cooled and dried.
The heating unit heats the air as required in
all operating modes depending on the
position of the temperature switch. The air
supply can be adjusted to suit
requirements by means of the fan.
The buttons for cooling n and air
recirculation 4 are only found on
versions with optional air conditioning
system 3.
Air conditioning system 3 3 119.
Picture no: 16499s.tif
Electronic climate control
system
3
Offers the greatest comfort in the vehicle
interior regardless of the conditions
outside.
To ensure a uniform and comfortable
climate in the vehicle, the temperature of
inflowing air, air-flow rate and air
distribution are automatically adapted
based on the climate conditions outside
the vehicle and the current temperature of
the vehicle interior.
Electronic climate control system 3 3 122.
Heating and ventilation system, air
conditioning system 3...................... 114
Electronic climate control system 3... 114
Air vents ............................................... 115
Heating and ventilation system ......... 116
Air conditioning system 3................... 119
Electronic climate control system 3... 122
Auxiliary heater ................................... 127
Air intake .............................................. 127
Air outlet............................................... 127
Pollen filter ........................................... 127
Regular operation ............................... 128

122 Climate controlElectronic climate control
system
3
Provides a the greatest amount of comfort
in the interior regardless of the weather,
outside temperature or season.
To ensure a constant and comfortable
climate in the vehicle, the temperature of
the inflowing air, the air-flow rate and the
air distribution are changed automatically
according to climatic conditions outside
the vehicle.
The climate is regulated automatically
based on personal settings.
Picture no: 16500s.tif
Temperature changes due to external
influences, such as direct sunlight, are
automatically compensated.
When cooling (air conditioning
compressor) is active, air is cooled and
dehumidified.
The pollen filter removes dust, soot, pollen
and spores from the inflowing outside air.
Picture no:
When set to automatic mode, the climate
control system provides the optimal
settings for almost all conditions. If
necessary, climate control system settings
can be modified manually.
The climate control system is only
operational when the engine is running.
If you wish the climate control system 3 to
operate correctly, do not cover the sensor
on the instrument panel.
Cooling (air conditioning compressor)
switches off automatically at low outside
temperatures.

127
Climate control
Auxiliary heater Depending on outside temperature and
engine temperature, the passenger
compartment of vehicles with Quickheat 3
electric auxiliary heating is warmed up
more quickly.
Diesel-engined vehicles have a fuel-
powered auxiliary heater 3.
Picture no: 14147s.tif
Air intake The air intakes in front of the windscreen on
the far right and left sides of the engine
compartment must be kept clear to allow
air intake. Remove any leaves, dirt or snow. Air outletDo not cover the air outlets when storing
items in the luggage compartment storage
compartments.
Pollen filter The pollen filter cleans dust, soot, pollen
and spores from the air entering from
outside. The active carbon layer 3
eliminates most odours and noxious
environmental gases from the air.

136 Driving and operationSave energy – more kilometres
Please observe the running-in hints on the
previous page and the tips for energy
saving on the following pages.
Good, technically correct and economical
driving ensures maximum durability and
performance for your vehicle.
Overrun cut-off
The fuel supply is automatically cut off
during overrun, e.g. when the vehicle is
driven with a gear engaged but no throttle
application. Overrun cut-off is deactivated
if catalytic converter temperature is high.
Vehicles with turbocharged engine
3
Flow-generated noises may be audible if
the accelerator is released quickly on
account of air flow in the turbocharger.
Engine speed
Drive in a low engine speed range for each
gear as much as possible. Warming up
Allow the engine to wa
rm up while driving.
Do not warm it up by letting it ru n at idling
speed. Do not apply full throttle until the
engine has reached operating
temperature.
After a cold start, the manual transmission
automated 3 does not switch to higher
gears until the speed increases when it is in
automatic mode. This allows the catalytic
converter to reach th e temperature quickly
which is required for optimum emission
reduction.
Correct gear selection
Do not race your engine whilst in neutral or
with a low gear selected. Driving too fast in
individual gears as well as stop-and-go
traffic increases engine wear and fuel
consumption.
Change down
When decreasing speed, shift down into
the next lowest gear. Do not slip the clutch
with a high-revving engine. This is
especially important when hill climbing. Cooling fan
The cooling fan is controlled via a
thermoswitch and therefore only runs if
necessary.
The cooling fan automatically switches on
when the diesel particle filter is being
cleaned
3 depending on the engine.
Pedals
Do not place any objects in the foot well
which could slip under the pedals and
inhibit the pedal travel.
To ensure the pedal travel is uninhibited,
there must be no mats in the area of the
pedals.
Battery care
When driving slowly or when the vehicle is
stationary, e.g. in slow urban traffic, stop-
and-go traffic or traffic jams, turn off all
unnecessary electrical loads where
possible (e.g. heated rear window, heated
front seats, etc.).
Declutch when starting in order to relieve
the strain on the starter and the battery.

143
Driving and operation
Picture no: 17891s.tif
Control indicator
Z for exhaust
Illuminates when the ignition is switched on
and during the start attempt. Goes off
shortly after the engine starts running.
Illumination whilst the engine is running
indicates a fault in the emission control
system. The permissible emission limits
may be exceeded. Contact a workshop for
assistance immediately.
Illumination with the engine running
indicates a fault that can cause damage to
the catalytic converter. It is possible to
continue driving without causing damage
by slowing down until the flashing stops
and the control indicator illuminates.
Contact a workshop for assistance
immediately.
Picture no: 17880s.tif
Control indicator
A
for engine electronics
Illuminates for a few seconds after the
ignition is switched on.
If it illuminates when the engine is running,
there is a fault in engine or transmission
electronics. The electr onic system switches
to an emergency runni ng programme. Fuel
consumption may be increased and the
driveability of the vehicle may be impaired.
In some cases the fault can be remedied by
switching the engine off and starting it
again. If the control indicator continues to
illuminate whilst the en gine is running,
contact a workshop for assistance in
remedying the cause of the fault. If it illuminates briefly, but does not recur, it
is of no significance.
Lighting of
A may indicate water in the
diesel fuel filter 3. Have the fuel filter
checked for water residue 3212.
If it flashes after the ignition is switched on,
there is a fault in the immobiliser system.
The engine cannot be started 327.

185
Self-help, vehicle care
Picture no: 14214s.tif
The following fuses are Maxi fuses.
Bulb replacement Switch off the ignition and switch off the
relevant switch or close the doors.
Only hold a new bulb at the base! Do not
touch the bulb glass with your bare hands.
Replace the bulb, checking that the data
on the base matches that of the defective
bulb.
To replace a bulb, pull off the relay box on
the left side. On the right side, pull off the
air hose to the air filter.
Picture no: 16085s.tif
Halogen headlamp systemHeadlamp system has separate bulbs for
dipped beam 1 (bottom bulbs) and main
beam 2 (top bulbs).
No. Circuit
1 Interior fan
2 Power steering
3 ABS
4 Easytronic diesel preheating
system
5 Heated rear window
6 Engine cooling
7 Starter
8 Engine cooling